snow chains DODGE VIPER SRT 2016 VX / 3.G Owners Manual

TIRE CHAINS (TRACTION DEVICES)
Due to limited clearance, tire chains or traction devices
are not recommended.
CAUTION!
Damage to the vehicle may result if tire chains are
used.
TIRE ROTATION RECOMMENDATIONS
Tires on the front and rear axles of vehicles operate at
different loads and perform different steering, driving,
and braking functions. For these reasons, they wear at
unequal rates.
These effects can be reduced by timely rotation of tires.
The benefits of rotation are especially worthwhile with
aggressive tread designs such as those on all season typetires. Rotation will increase tread life, help to maintain
mud, snow, and wet traction levels, and contribute to a
smooth, quiet ride.
Refer to the “Maintenance Schedule” for the proper
maintenance interval. Remember, more frequent rotation
is permissible if desired. Also, correct for anything caus-
ing rapid or unusual wear prior to performing the tire
rotation.
NOTE:
Each wheel on your vehicle contains a tire pres-
sure sensor. The Tire Pressure Monitor System (TPMS)
learns the location of each sensor though system pro-
gramming. Although not required, the manufacturer
recommends reprogramming the TPMS after rotating the
tires so that the system can relearn each sensor ’s location.
See your authorized dealer for system reprogramming.
5
STARTING AND OPERATING 295

no longer exists, the TPM Telltale Light will no longer
flash, and theSERVICE TPM SYSTEM message will no
longer display, and a pressure value will display in place
of the dashes. A system fault can occur due to any of the
following:
1. Signal interference due to electronic devices or driving next to facilities emitting the same radio frequencies as
the TPM sensors.
2. Installing aftermarket window tinting that contains materials that may block radio wave signals.
3. Accumulation of snow or ice around the wheels or wheel housings.
4. Using tire chains on the vehicle.
5. Using wheels/tires not equipped with TPM sensors.
The DID will also display a SERVICE TPM SYSTEM
message for a minimum of five seconds when a system fault related to an incorrect sensor location fault is
detected. In this case, the
SERVICE TPM SYSTEM
message is then followed with a graphic display with
pressure values still shown. This indicates that the pres-
sure values are still being received from the TPM sensors
but they may not be located in the correct vehicle
position. The system still needs to be serviced as long as
the SERVICE TPM SYSTEM message is displayed.
General Information
This device complies with Part 15 of the FCC rules and
RSS-210 of Industry Canada. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received,
including interference that may cause undesired opera-
tion.
5
STARTING AND OPERATING 301

Operating Instructions....................40
Pregnant Women ........................44
Pretensioners ...........................44
Rear Seat ..............................37
Reminder ............................ .152
Untwisting Procedure .....................42
Seats .............................. .100, 103
Adjustment ....................... .100, 103
Reclining ............................ .102
Security Alarm ........................ .18, 156
Selection Of Coolant (Antifreeze) ..............385
Selection Of Oil ......................... .341
SENTRY KEY Key Programming .......................17
Sentry Key (Immobilizer) ....................15
Sentry Key Replacement .....................16
Service Assistance ........................ .399
Service Contract ......................... .401
Service Manuals ......................... .404Shift Indicator Light
...................... .250
Shift Speeds ......................... .247, 250
Shoulder Belts ............................37
Signals, Turn ...................... .89, 111, 171
Snow Chains (Tire Chains) ...................295
Spare Tire ....................... .288, 289, 290
Spark Plugs ............................ .385
Speed Control Resume ............................. .122
Speed Control (Cruise Control) ................120
Starting ............................... .244
Emergency (Jump Starting) ................327
Engine Fails To Start .....................246
Starting And Operating .....................244
Starting Procedures ....................... .244
Steering Column Controls ........................111
Power ........................... .259, 260
Tilt Column ...........................117
420 INDEX