oil filter FIAT 500 1972 1.G Workshop Manual

FIAT 500 1972 1.G Workshop Manual 500 1972 1.G FIAT FIAT https://www.carmanualsonline.info/img/10/4482/w960_4482-0.png FIAT 500 1972 1.G Workshop Manual

Page 2 of 128

FIAT 500 1972 1.G Workshop Manual CHAPTER 1
THE ENGINE
1 :1
1 :2
1 :3
1 :4
1 :5
1 :6
1 :7
1 :8
1:9
1 :10
1 :11Description
Engine removal (sedan—all versions)
Engine removal (station wagon)
Engine disassembly (sedan—all versions)
E

Page 3 of 128

FIAT 500 1972 1.G Workshop Manual FIG 1:1  Left side view of the power plant to suit
500  Sedan
10
FIG 1:2  Right side  rear  three-quarter view of the power plant for 500 Station  Wagon Mounted on the top of the cylinder  head  is th

Page 6 of 128

FIAT 500 1972 1.G Workshop Manual The  interior of the  car can  be heated by the engine
warmed air being ducted into the front compartment and
controlled  by a  lever on the heating system tunnel.
Engine ignition is by a battery, ign

Page 8 of 128

FIAT 500 1972 1.G Workshop Manual 6 Release the ignition distributor support retaining nut
and lift away the distributor together w i t h  its support.
7  Remove all the mounting  bolts of the engine cooling
cowling and  lift away the

Page 9 of 128

FIAT 500 1972 1.G Workshop Manual STUD REMOVAL
PULLER  40010
FIG 1 :12  Removal of stud from crankcase by puller
A.40010
FIG  1  :13   Engine  without blower cowling and cylinder
head  cover.SPACER  A N D  CONNECTION
FOR ROCKER SHAFT

Page 17 of 128

FIAT 500 1972 1.G Workshop Manual FIG 1:33 Checking crankshaft land-to-connecting rod
shoulder clearance
FIG 1:34 Engine  f r o n t  end  without flywheel
Using an expanding reamer or Fiat reamer U.0307 ease
out the internal diameter

Page 18 of 128

FIAT 500 1972 1.G Workshop Manual After the  crankshaft  has been reground  it is important
that all traces of swarf are removed  by constant washing
and then drying with a non-fluffy rag.
The clearance between the main bearings and j

Page 19 of 128

FIAT 500 1972 1.G Workshop Manual FIG 1:37  Lubrication diagram of engine 120.000
Key to  Fig  1:37 1 Oil dipstick 2 Oil filler with vent valve  3 Centrifugal oil filter
4 Crankshaft, with central oil gallery  5  Low oil pressure indi

Page 20 of 128

FIAT 500 1972 1.G Workshop Manual Drain the oil sump to ensure that the oil does not syphon
out. Thoroughly clean the area around the pump body
(see FIG 1 :37).
Remove the end cover plate by releasing the retaining
bolts and washers.

Page 21 of 128

FIAT 500 1972 1.G Workshop Manual FIG 1 :40  Engine detail showing lube oil passages
Key to Fig 1 :40  1  Splines in crankshaft for oil passage
to filter  2  Oil inlet into circuit from filter 3 Hole for
oil passage to main bearing
FI
Page:   1-10 11-20 next >