seat memory FIAT 500 ABARTH 2015 2.G Owners Manual

▫Seat Height Adjustment.................103
▫EZ Entry Feature......................104
▫Memory Feature......................104
▫Heated Seats — If Equipped.............105
▫Head Restraints......................106
!TO OPEN AND CLOSE THE HOOD.........107
!LIGHTS.............................109
▫Multifunction Lever....................109
▫Headlights..........................109
▫High Beams.........................110
▫Flash-To-Pass........................110
▫Parking Lights.......................110
▫Daytime Running Lights — If Equipped.....110
▫Turn Signals.........................110
▫Lane Change Assist....................111
▫Follow Me Home/Headlight Delay.........111
▫Interior Lights.......................112
▫Front Fog Lights — If Equipped...........113
!WINDSHIELD WIPERS AND WASHERS......114
▫Front Windshield Wiper Operation.........114
▫Rear Windshield Wiper.................116
!TILT STEERING COLUMN — IF EQUIPPED . . .117
!ELECTRONIC SPEED CONTROL...........118
▫To Activate..........................119
▫To Set A Desired Speed.................119
▫To Deactivate.........................119
84 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

EZ Entry Feature
The driver and front passenger seats have an EZ entry
feature for rear seat passengers. Pull upward on the
release tether, located on the outboard side of the seat-
back, dump the seatback forward, then slide the seat
forward to allow access in and out of the rear seat.
Lift the seatback upright and push the seat rearward to
its locked position once the rear passengers are seated.
Memory Feature
Both front seats have a memory feature, which can
operate in two ways:
Memory Function Option 1 — Full Seat Back And
Track Fore/Aft Position Memory:
After using the EZ entry function, the seatback angle and
the Track fore/aft adjuster can both re-lock into the
position they were most recently adjusted to. This is
accomplished if the seat is moved fully rearward to its
last fore/aft position on the tracks before the seat back is
returned upright.
Memory Function Option 2 — Seat Back Only
Memory:
After using the EZ entry function, the seat back may first
be returned upright prior to going back to the lastEZ Entry Lever
104 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

fore/aft (memory) position on the tracks. This results in
the seat back memory being set only – The track will then
be locked forward of its last set fore/aft memory posi-
tion. To then reset the fore/aft track memory feature (to
reestablish Memory Function Option 1), the seat has to be
returned fully rearward to its last fore/aft memory track
position as described in Memory Function Option 1.
Heated Seats — If Equipped
On some models, the front driver and passenger seats
may be equipped with heaters in both the seat cushions
and seatbacks. The controls for the front heated seats are
located on the center instrument panel area.
Press the switch once to turn on the heated
seats. Press the switch a second time to shut the
heating elements off.
NOTE:Once a heat setting is selected, heat will be felt
within two to five minutes.
WARNING!
•Persons who are unable to feel pain to the skin
because of advanced age, chronic illness, diabetes,
spinal cord injury, medication, alcohol use, exhaus-
tion or other physical condition must exercise care
when using the seat heater. It may cause burns
even at low temperatures, especially if used for
long periods of time.
•Do not place anything on the seat or seatback that
insulates against heat, such as a blanket or cushion.
This may cause the seat heater to overheat. Sitting
in a seat that has been overheated could cause
serious burns due to the increased surface tempera-
ture of the seat.
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 105