wheel FIAT 500 ABARTH 2016 2.G Service Manual

FIAT 500 ABARTH 2016 2.G Service Manual 500 ABARTH 2016 2.G FIAT FIAT https://www.carmanualsonline.info/img/10/4499/w960_4499-0.png FIAT 500 ABARTH 2016 2.G Service Manual

Page 316 of 432

FIAT 500 ABARTH 2016 2.G Service Manual WARNING!
•Do not attempt to seal a tire on the side of the
vehicle closest to traffic. Pull far enough off the
road to avoid the danger of being hit when using
the Tire Service Kit.
• Do not use T

Page 317 of 432

FIAT 500 ABARTH 2016 2.G Service Manual WARNING!(Continued)
•Tire Service Kit Sealant solution contains latex. In
case of an allergic reaction or rash, consult a phy-
sician immediately. Keep Tire Service Kit out of
reach of children. If

Page 323 of 432

FIAT 500 ABARTH 2016 2.G Service Manual 6. Verify that the cap is installed on the fitting at the endof the Sealant Hose (6) and return the hose to its
storage area (located on the bottom of the air pump).
7. Return the Tire Service Kit to

Page 324 of 432

FIAT 500 ABARTH 2016 2.G Service Manual Inspect the wheel mounting surface prior to mounting
the tire and remove any corrosion or loose particles.
Tighten the lug nuts/bolts in a star pattern until each
nut/bolt has been tightened twice.Aft

Page 325 of 432

FIAT 500 ABARTH 2016 2.G Service Manual WARNING!
To avoid the risk of forcing the vehicle off the jack,
do not tighten the lug nuts fully until the vehicle has
been lowered. Failure to follow this warning may
result in personal injury.
JACK

Page 326 of 432

FIAT 500 ABARTH 2016 2.G Service Manual Jack Location
The jack and jack wrench tool are stowed in a bag under
the front driver ’s seat.
Preparations For Jacking
1. Park the vehicle on a firm level surface, avoiding ice orslippery areas.
W

Page 327 of 432

FIAT 500 ABARTH 2016 2.G Service Manual Block both the front and rear of the wheel diagonally
opposite the jacking position. For example, if changing
the right front tire, block the left rear wheel.NOTE:Passengers should not remain in the
v

Page 329 of 432

FIAT 500 ABARTH 2016 2.G Service Manual CAUTION!
Do not attempt to raise the vehicle by jacking on
locations other than those indicated in the Jacking
Instructions for this vehicle.
1. Remove the scissors jack and tool bag from under the dr

Page 330 of 432

FIAT 500 ABARTH 2016 2.G Service Manual 3. Loosen, but do not remove, the wheel bolts by turningthem to the left one turn while the wheel is still on the
ground.
NOTE: •There are front and rear jacking locations on each
side of the body (

Page 331 of 432

FIAT 500 ABARTH 2016 2.G Service Manual 4. Turn the jack screw to the left until the jack can beplaced under the jacking location. Once the jack is
positioned, turn the jack screw to the right until the
jack head is properly engaged with th