child restraint FIAT 500E 2013 2.G Owner's Manual

Can the rear-facing child restraint touch the back
of the front passenger seat?Yes Contact between the front passenger seat and the
child restraint is allowed, if the child restraint
manufacturer also allows contact.
Can the head restraints be removed? Yes, all.
Can the buckle stalk be twisted to tighten the seat
belt against the belt path of the child restraint? Yes In positions with cinching latch plates (CINCH),
the buckle stalk may be twisted up to 3 full turns.
Do not twist the buckle stalk in a seating position
with an ALR retractor.
Installing A Child Restraint with a Switchable
Automatic Locking Retractor (ALR)
1. Place the child seat in the center of the seatingposition. For some second row seats, you may need to
recline the seat and/or raise the head restraint to get a
better fit.
2. Pull enough of the seat belt webbing from the retractor to pass it through the belt path of the child restraint.
Do not twist the belt webbing in the belt path. 3. Slide the latch plate into the buckle until you hear a
“click.”
4. Pull on the webbing to make the lap portion tight against the child seat.
5. To lock the seat belt, pull down on the shoulder part of the belt until you have pulled all the seat belt webbing
out of the retractor. Then, allow the webbing to retract
back into the retractor. As the webbing retracts, you
will hear a clicking sound. This means the seat belt is
now in the Automatic Locking mode.
2
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 87

6. Try to pull the webbing out of the retractor. If it islocked, you should not be able to pull out any web-
bing. If the retractor is not locked, repeat step 5.
7. Finally, pull up on any excess webbing to tighten the lap portion around the child restraint while you push
the child restraint rearward and downward into the
vehicle seat.
8. If the child restraint has a top tether strap and the seating position has a top tether anchorage, connect
the tether strap to the anchorage and tighten the tether
strap. Refer to “Lower Anchors and Tethers for Chil-
dren (LATCH) Restraint System” for directions to
attach a tether anchor.
9. Test that the child restraint is installed tightly by pulling back and forth on the child seat at the belt
path. It should not move more than 1 inch (25.4 mm)
in any direction. Any seat belt system will loosen with time, so check the
belt occasionally, and pull it tight if necessary.
Installing A Child Restraint With A Cinching
Latch Plate (CINCH) — If Equipped
1. Place the child seat in the center of the seating
position. For some second row seats, you may need to
recline the seat and / or raise the head restraint to get
a better fit.
2. Next, pull enough of the seat belt webbing from the retractor to pass it through the belt path of the child
restraint. Do not twist the belt webbing in the belt
path.
3. Slide the latch plate into the buckle until you hear a “click.”
88 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE

4. Finally, pull up on any excess webbing to tighten thelap portion around the child restraint while you push
the child restraint rearward and downward into the
vehicle seat.
5. If the child restraint has a top tether strap and the seating position has a top tether anchorage, connect
the tether strap to the anchorage and tighten the tether
strap. Refer to “Installing Child Restraints Using The
Top Tether Anchorage” for directions to attach a tether
anchor.
6. Test that the child restraint is installed tightly by pulling back and forth on the child seat at the belt
path. It should not move more than 1 inch (25.4 mm)
in any direction.
Any seat belt system will loosen with time, so check the
belt occasionally, and pull it tight if necessary. If the buckle or the cinching latch plate is too close to the
belt path opening of the child restraint, you may have
trouble tightening the seat belt. If this happens, discon-
nect the latch plate from the buckle and twist the short
buckle-end belt up to three full turns to shorten it. Insert
the latch plate into the buckle with the release button
facing out, away from the child restraint. Repeat steps 4
to 6, above, to complete the installation of the child
restraint.
If the belt still cannot be tightened after you shorten the
buckle, disconnect the latch plate from the buckle, turn
the buckle around one half turn, and insert the latch plate
into the buckle again. If you still cannot make the child
restraint installation tight, try a different seating position.
2
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 89

Installing Child Restraints Using The Top Tether
Anchorage
1. Look behind the seating position where you plan toinstall the child restraint to find the tether anchorage.
You may need to move the seat forward to provide
better access to the tether anchorage. If there is no top
tether anchorage for that seating position (see the
charts above), move the child restraint to another
position in the vehicle if one is available.
2. Route the tether strap to provide the most direct path for the strap between the anchor and the child seat. If
your vehicle is equipped with adjustable rear head
restraints, raise the head restraint, and where possible,
route the tether strap under the head restraint and
between the two posts. If not possible, lower the head
restraint and pass the tether strap around the outboard
side of the head restraint. 3. Attach the tether strap hook of the child restraint to
the top tether anchorage as shown in the diagram.
4. Remove slack in the tether strap according to the child restraint manufacturer ’s instructions.
Rear Seat Tether Strap Mounting
90 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE

WARNING!
•An incorrectly anchored tether strap could lead to
increased head motion and possible injury to the
child. Use only the anchorage position directly
behind the child seat to secure a child restraint top
tether strap.
• If your vehicle is equipped with a split rear seat,
make sure the tether strap does not slip into the
opening between the seatbacks as you remove
slack in the strap.
SAFETY TIPS
Transporting Passengers
NEVER TRANSPORT PASSENGERS IN THE CARGO
AREA.
WARNING!
• Do not leave children or animals inside parked
vehicles in hot weather. Interior heat build-up may
cause serious injury or death.
• It is extremely dangerous to ride in a cargo area,
inside or outside of a vehicle. In a collision, people
riding in these areas are more likely to be seriously
injured or killed.
• Do not allow people to ride in any area of your
vehicle that is not equipped with seats and seat
belts.
• Be sure everyone in your vehicle is in a seat and
using a seat belt properly.
2
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 91

Cargo Area Features...................... .144
Car Washes ............................ .302
CD (Compact Disc) Player ...................167
Cellular Phone .......................... .196
Chart, Tire Sizing ........................ .231
Checking Your Vehicle For Safety ...............91
Checks, Safety ............................91
Child Restraint ............................72
Cleaning Wheels .............................. .303
Climate Control ......................... .196
Clutch ................................ .299
Clutch Fluid ............................ .299
Compact Disc (CD) Maintenance ..............195
Connector UCI................................ .193
Universal Consumer Interface (UCI) ..........193
Contract, Service ......................... .330
Corrosion Protection ...................... .301Cupholders
............................ .143
Customer Assistance ...................... .328
Data Recorder, Event .......................71
Daytime Running Lights ....................120
Defroster, Windshield .......................92
Door Locks ..............................39
Door Locks, Automatic ......................41
Driving Through Flowing, Rising, or Shallow Standing
Water ............................... .217
Electrical Power Outlets .....................140
Electric Remote Mirrors .....................100
Electronic Brake Control System Brake Assist System .....................224
Electronic Speed Control (Cruise Control) ........128
Electronic Stability Control (ESC) ..............225
Electronic Vehicle Information Center (EVIC) ......161
10
INDEX 339

Steering............................. .219
Sunroof ............................. .137
Windows ..............................42
Pregnant Women and Seat Belts ................56
Pretensioners Seat Belts ..............................54
Radial Ply Tires ......................... .243
Radio Operation ......................... .167
Radio Reception ......................... .167
Radio (Sound Systems) .....................167
Rear Liftgate (Sedan) .......................43
Rear Window Features .....................146
Recorder, Event Data .......................71
Recreational Towing ...................... .258
Release, Hood ............................117
Reminder, Seat Belt .........................55
Remote Sound System (Radio) Controls .........194
Replacement Bulbs ....................... .314Replacement Keys
.........................35
Replacement Parts ........................ .286
Replacement Tires ........................ .247
Reporting Safety Defects ....................331
Restraints, Child ...........................72
Rotation, Tires .......................... .250
Safety Checks Inside Vehicle ..................92
Safety Checks Outside Vehicle .................94
Safety Defects, Reporting ....................331
Safety Information, Tire .....................230
Safety Tips ...............................91
Schedule, Maintenance .....................322
Seat Belt Maintenance ..................... .306
Seat Belt Reminder .........................55
Seat Belts ................................92
And Pregnant Women .....................56
Child Restraint ..........................72
Extender ..............................56
10
INDEX 343