phone FIAT 500E 2013 2.G Owner's Manual

Cargo Area Features...................... .144
Car Washes ............................ .302
CD (Compact Disc) Player ...................167
Cellular Phone .......................... .196
Chart, Tire Sizing ........................ .231
Checking Your Vehicle For Safety ...............91
Checks, Safety ............................91
Child Restraint ............................72
Cleaning Wheels .............................. .303
Climate Control ......................... .196
Clutch ................................ .299
Clutch Fluid ............................ .299
Compact Disc (CD) Maintenance ..............195
Connector UCI................................ .193
Universal Consumer Interface (UCI) ..........193
Contract, Service ......................... .330
Corrosion Protection ...................... .301Cupholders
............................ .143
Customer Assistance ...................... .328
Data Recorder, Event .......................71
Daytime Running Lights ....................120
Defroster, Windshield .......................92
Door Locks ..............................39
Door Locks, Automatic ......................41
Driving Through Flowing, Rising, or Shallow Standing
Water ............................... .217
Electrical Power Outlets .....................140
Electric Remote Mirrors .....................100
Electronic Brake Control System Brake Assist System .....................224
Electronic Speed Control (Cruise Control) ........128
Electronic Stability Control (ESC) ..............225
Electronic Vehicle Information Center (EVIC) ......161
10
INDEX 339

INSTALLATION OF RADIO TRANSMITTING
EQUIPMENT
Special design considerations are incorporated into this
vehicle’s electronic system to provide immunity to radio
frequency signals. Mobile two-way radios and telephone
equipment must be installed properly by trained person-
nel. The following must be observed during installation.
The positive power connection should be made directly
to the battery and fused as close to the battery as possible.
The negative power connection should be made to body
sheet metal adjacent to the negative battery connection.
This connection should not be fused.
Antennas for two-way radios should be mounted on the
roof or the rear area of the vehicle. Care should be used
in mounting antennas with magnet bases. Magnets may
affect the accuracy or operation of the compass on
vehicles so equipped.The antenna cable should be as short as practical and
routed away from the vehicle wiring when possible. Use
only fully shielded coaxial cable.
Carefully match the antenna and cable to the radio to
ensure a low Standing Wave Ratio (SWR).
Mobile radio equipment with output power greater than
normal may require special precautions.
All installations should be checked for possible interfer-
ence between the communications equipment and the
vehicle’s electronic systems.