phone FIAT 500L 2015 2.G User Guide
[x] Cancel search | Manufacturer: FIAT, Model Year: 2015, Model line: 500L, Model: FIAT 500L 2015 2.GPages: 438, PDF Size: 12.64 MB
Page 424 of 438

Cellular Phone...........................190
Center High Mounted Stop Light..............396
Chains, Tire.............................290
Changing A Flat Tire.......................324
Chart, Tire Sizing.........................268
Check Engine Light (Malfunction Indicator Light) . .172
Checking Your Vehicle For Safety...............83
Checks, Safety............................83
Child Restraint............................61
Child Restraints
Booster Seats...........................65
Child Restraints.........................61
Child Seat Installation.....................79
How To Stow An Unused ALR Seat Belt........75
Infants And Child Restraints................63
Install A LATCH-compatible Child Restraint.....74
Installing Child Restraints Using The Vehicle
Seat Belt..............................76
Lower Anchors And Tethers For Children.......68
Older Children And Child Restraints..........64
Seating Positions........................67
Child Safety Locks.........................25
Cigar Lighter............................148
Clean Air Gasoline........................299
Cleaning
Wheels...............................379
Windshield Wiper Blades..................358
Climate Control..........................191
Manual..............................191
Clutch.................................371
Clutch Fluid.............................371
Compact Disc (CD) Maintenance..............190
Compact Spare Tire........................285
Connector
UCI . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ..187
Universal Consumer Interface (UCI)..........187
Contract, Service..........................412
Coolant (Antifreeze).......................397
422 INDEX
Page 437 of 438

INSTALLATION OF RADIO TRANSMITTING
EQUIPMENT
Special design considerations are incorporated into this
vehicle’s electronic system to provide immunity to radio
frequency signals. Mobile two-way radios and telephone
equipment must be installed properly by trained person-
nel. The following must be observed during installation.
The positive power connection should be made directly
to the battery and fused as close to the battery as possible.
The negative power connection should be made to body
sheet metal adjacent to the negative battery connection.
This connection should not be fused.
Antennas for two-way radios should be mounted on the
roof or the rear area of the vehicle. Care should be used
in mounting antennas with magnet bases. Magnets may
affect the accuracy or operation of the compass on
vehicles so equipped.
The antenna cable should be as short as practical and
routed away from the vehicle wiring when possible. Use
only fully shielded coaxial cable.
Carefully match the antenna and cable to the radio to
ensure a low Standing Wave Ratio (SWR).
Mobile radio equipment with output power greater than
normal may require special precautions.
All installations should be checked for possible interfer-
ence between the communications equipment and the
vehicle’s electronic systems.