Light FIAT 500L LIVING 2014 2.G Owners Manual

RADIOFREQUENCY REMOTE CONTROL: MINISTERIAL APPROVALS
fig. 228
F0Y0277
292GETTING TO KNOW
YOUR CAR
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX

fig. 229
F0Y0278
293GETTING TO KNOW
YOUR CAR
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCETECHNICAL
SPECIFICATIONSINDEX

Morocco



!
"

#$%


&'

!
"

#(#)
Mexico RLVMABC11-0959 RLVMABC12-0020
Serbia
TRF198= 34540-164/12-3
BCML7= 34540-83/12-4
SyriaMarking
Marking
South Africa
TA-2011/505
APPROVED
TA-2011/1915
APPROVED
TunisiaMarking
Marking
294GETTING TO KNOW
YOUR CAR
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
OFFICIAL TYPE APPROVALS FOR SPECIFIC MARKETS
CountryRadiofrequency remote control
type approval initials (TRF198)Body Computer type approval
initials (BCML7)
Jordan TRC/LPD/2011/102 TRC/LPD/2012/75

DASHBOARDThe presence and position of the controls, instruments and indicators may vary according to the different
versions.1. Adjustable air diffusers 2. Upper glove compartment (for versions/markets, where provided the compartment may be
conditioned) 3. Passenger front airbag 4. Adjustable and directable centre air diffusers 5. Fixed upper air vent 6. Radio
controls on the steering wheel (for versions/markets, where provided) 7. Exterior light control lever 8. Instrument panel
9. Windscreen wiper/rear window wiper/trip computer control lever 10. Ignition switch 11. Driver front airbag 12. Cruise
Control/Speed Limiter lever (for versions/markets, where provided) 13.UConnect™ (for versions/markets, where
provided) or radio system setup 14. USB port/AUX socket (for versions/markets, where provided)
15. Heating/ventilation system or manual climate control (for versions/markets, where provided) or automatic dual zone
climate control (for versions/markets, where provided) 16. Control buttons 17. Lower glove compartment 18. Oddment
compartment
fig. 1
F0Y0185
295
RIGHT HAND DRIVE VERSIONS

CONTROL PANEL AND INSTRUMENTSInstrument background colour and type may vary according to the version.
The warning lights
and
are only present on Diesel versions. On diesel versions, the max. rpm (red
range on the revolution counter) corresponds to 5000 rpm.
VERSIONS WITH MULTIFUNCTION DISPLAY
A. Speedometer (speed indicator) B. Multifunction display C. Rev counter D. Fuel level gauge with reserve warning light
E. Engine coolant temperature gauge with overheating warning light
fig. 2
F0Y0183
296
RIGHT HAND DRIVE VERSIONS

VERSIONS WITH RECONFIGURABLE MULTIFUNCTION DISPLAYA. Speedometer (speed indicator) B. Reconfigurable multifunction display C. Rev counter D. Fuel level gauge with reserve
warning light E. Engine coolant temperature gauge with overheating warning light
fig. 3
F0Y0184
297
RIGHT HAND DRIVE VERSIONS

WARNING
Alert other drivers that the car is
stationary in compliance with local
regulations: hazard warning lights, warning
triangle, etc . Any passengers on board should
leave the car, especially if it is heavily laden.
Passengers should stay away from on-coming
traffic while the wheel is being changed. If you
are on a slope or uneven surface, place the
wedge provided under the wheels (see the
instructions on the next pages).
WARNING
The vehicle's driving characteristics will
be modified with the space-saver wheel
fitted. Avoid violent acceleration and braking,
abrupt steering and fast cornering.The overall
duration of the space-saver wheel is of about
3000 km, after which the relevant tyre must be
replaced with another one of the same type.
Never install a standard tyre on a rim that is
designed for use with a space-saver wheel. Have
the wheel repaired and refitted as soon as
possible. Using two or more small space-saver
wheels at the same time is forbidden. Do not
grease the threads of the stud bolts before
fitting them: they might slip out .
WARNING
The jack shall only be used for raising
the car model it has been supplied with.
Never use the jack for other purposes, such as
raising other car models. Never use the jack for
repair operations under the vehicle. Incorrectly
positioning of the jack may cause the car to fall.
Do not use the jack for loads higher than the
one shown on its label.The space-saver wheel
cannot be fitted with snow chains. If a front
(drive) tyre is punctured and chains are needed,
use a standard wheel from the rear axle and
install the space-saver wheel on the rear axle. In
this way, with two normal drive wheels at the
front axle, it is possible to use snow chains.
WARNING
Incorrectly fitting the wheel cap may
cause it to fall off when the vehicle is in
motion. Never tamper with the inflation valve.
Never introduce tools of any kind between rim
and tyre. Check tyre and space-saver wheel
pressures regularly, complying with the values
given in the “Wheels” paragraph.
318

REFITTING THE STANDARD WHEEL
Following the procedure described previously, raise
the car and remove the space-saver wheel.
Versions with steel rims
Proceed as follows:
❒make sure the contact surfaces between standard
wheel and hub are clean and free from impurities
so that the fixing stud bolts will not come loose;
❒fit the standard wheel inserting the 5 stud bolts
into the holes;
❒press-fit the wheel cap, aligning the special splining
(on the cap) with the inflation valve;
❒using the spanner provided, tighten the fixing stud
bolts;
❒lower the car and remove the jack;
❒using the spanner provided, fully tighten the stud
bolts in the sequence shown previously.Versions with alloy rims
Proceed as follows:
❒insert the wheel on the hub and using the spanner
provided tighten the stud bolts;
❒lower the car and remove the jack;
❒using the spanner provided, fully tighten the 5 stud
bolts in the sequence shown;
❒reinstall the hub cap, taking care to position the
three plastic pins in the dedicated seats on the
wheel. Slightly press the cap to prevent any damage
to the plastic pins.
IMPORTANT If it is not fitted correctly, the hub cap
may detach when the car is running.
325

At the end of the operation
Proceed as follows:
❒place the space-saver wheel in the luggage
compartment;
❒place the jack and the other tools in the tool bag;
❒place the bag, complete with the tools, in the
luggage compartment, then secure it with the
suitable belts;
❒correctly reposition the luggage compartment mat.
REPLACING INTERIOR BULBSTHIRD ROW REAR SEAT ROOF LIGHT
(for versions/markets, where provided)
Type of bulb: C5W
Power:5W
To replace the bulb, proceed as follows:
❒operate in the point shown by the arrows and
remove roof light A fig. 42;
❒open the flap C fig. 43 and replace the bulb B
releasing it from the side contacts;
❒Insert the new bulb and make sure that it is
correctly clamped between the contacts.
❒refit the roof light A fig. 42 by inserting it in its
correct position, firstly on one side and then
pressing on the other until it clicks into place.
fig. 42
F0Y0152
326

LUGGAGE COMPARTMENT ROOF LIGHT
Type of bulb: W5W
Power:5W
To replace the bulb, proceed as follows:
❒open the luggage compartment and extract the
roof light A fig. 44 working in the point shown by
the arrow;
❒open cover B and replace the bulb;❒fit the new bulb, then close again cover B on the
lens;
❒refit the roof light A by inserting it in its correct
position firstly, on one side and then pressing on
the other side until it clicks into place.
fig. 43
F0Y0104
fig. 44
F0Y0380
327