buttons FIAT BRAVO 2014 2.G User Guide

WARNING
Improper use of the electric windows
can be dangerous. Before and during
their operation ensure that any passengers are
not at risk from the moving glass either by
personal objects getting caught in the
mechanism or by being hit by it directly.When
leaving the car, always remove the ignition
key to prevent the electric windows from being
inadvertently activated, as this could present
a danger for the passengers remaining in the
vehicle.
Passenger side front door/rear doors
On the passenger side front door panel, and on
some versions also on the rear doors, buttons
A fig. 72 are provided to control the associated
windows.ELECTRIC WINDOWS SYSTEM
INITIALISATION
The system must be re-initialised after disconnecting
the battery or if the relevant protection fuse is
blown.
Proceed as follows to start the electric window
initialisation:
❒fully close the window to be initialised manually;
❒after the window has reached the upper end
of travel, hold the up button pressed for at least
one second.
MANUAL REAR WINDOW MECHANISM
(for versions/markets, where provided)
To open and to close the window, use the relevant
handle.
fig. 72
F0Q0743
79GETTING TO
KNOW YOUR CARSAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX

HEADLIGHTSLIGHT BEAM DIRECTION
The correct aiming of the headlights is important for
the comfort and safety of not only the driver but
all other road users. This is also covered by a specific
rule of the highway code.
The headlights must be correctly aligned to
guarantee the best visibility conditions for all drivers
while travelling with headlights on.
Contact a Fiat Dealership to have the lights checked
and adjusted, if necessary.
IMPORTANT When the gas discharge (Xenon)
headlamps (for versions/markets, where provided)
are switched on, normally parabolas and light beam
move vertically for about 2 seconds until headlamp
alignment has stabilised.
HEADLIGHT ALIGNMENT CORRECTOR
This device works with the ignition key in the
MAR-ON position and the dipped beam headlights
on.
The car will tilt backwards when it is loaded, raising
the light beam. The beams must therefore be
realigned in this case.
Adjusting headlights alignment
For adjusting, press buttons
and
fig. 88 on
the dashboard.Press button
to increase the light beam of one
position.
Press buttonto decrease the light beam of one
position.
The display shows the position while adjusting.
Correct positions depending on the load
Position 0
one or two occupants in the front seats.
Position 1
five people
Position 2
five people with a load in the luggage
compartment
Position 3
driver + maximum permitted load stowed
in the luggage compartment.
IMPORTANT Check the headlight alignment each
time the weight of the load transported changes.
fig. 88
F0Q0644
88GETTING TO
KNOW YOUR CAR
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX

IMPORTANT If the car is equipped with (Xenon) gas
discharge headlights, the headlight alignment is
controlled electronically, as a consequence
the
and
buttons are not present.
FOG LIGHT ALIGNMENT
Contact a Fiat Dealership to have the lights checked
and adjusted, if necessary.
ADJUSTING THE HEADLIGHTS WHEN
ABROAD
The dipped beam headlights are aligned for operation
in the country where the vehicle was originally
purchased. When in countries where you drive on
the other side of the road, you need to alter the
beam direction by affixing a specially designed
self-adhesive film in order not to dazzle the vehicles
travelling in the opposite direction.
Such film is provided by Lineaccessori Fiat and is
available at Fiat Dealerships.
ABS SYSTEMABS is an integral part of the braking system which
prevents, whatever the road conditions and force
applied to the brake pedal, the wheels from locking
and consequently sliding under braking, thus ensuring
that the vehicle remains under control even during
emergency braking.
The EBD system (Electronic Braking Force
Distribution) completes the system allowing the
brake force to be distributed between the front and
rear wheels.
IMPORTANT To obtain the maximum efficiency of
the braking system, a bedding-in period of about 500
km is needed: during this period it is better to
avoid sharp, repeated and prolonged braking.
WARNING
The ABS gets the most from the
available grip, but it cannot improve it ;
you should therefore take every care when
driving on slippery surfaces and not take
unnecessary risks.
SYSTEM INTERVENTION
The driver can feel that the ABS system has come
into action because the brake pedal pulsates slightly
and the system gets noisier: it means that the car
speed should be altered to suit the type of road
surface.
89GETTING TO
KNOW YOUR CARSAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX

Climate control system
compressor
activation/deactivation............. 50
Clutch ........................................... 230
CO2 emissions ........................... 247
CODE Card ................................. 8
Control buttons (display) ......... 18
Control panel and
instruments ................................ 4
Controls ................. 39-42-47-63-78
Courtesy mirror lights
– bulb replacement.................. 187
Cruise Control ............................ 59D
ashboard ................................... 3
Description .................................. 47
Diesel filter .................................. 212
Diffusers........................................ 37
Dipped headlights ....................... 52
– bulb replacement.................. 177
Direction indicators ................... 53
– bulb replacement.................. 179
Display ........................................... 17
Door mirrors............................... 34
Doors ............................................ 75
DPF (Diesel Particulate
Filter) .......................................... 109Driver front airbag .................... 127
Driver's side knee bag .............. 130
"Dualdrive" electric power
steering system ......................... 97EBD (system) .............................. 90
Electric windows......................... 77
Emergency manoeuvre .............. 74
Engine code - bodywork
versions ...................................... 227
Engine compartment
– opening/closing ...................... 85
– washing ................................... 221
Engine coolant ............................ 211
Engine coolant temperature
indicator...................................... 6
Engine
– marking ................................... 226
– technical data ........................ 228
Engine oil
– Consumption ........................ 209
– Level check ............................ 209
– specifications ......................... 243
EOBD system .............................. 95
ESP (system) ................................ 91
ESP system ................................... 91
Exterior lights .............................. 52
Failure indications ...................... 98
Fan speed adjustment ..... 41-44-48
Fast front window
demisting/defrosting ............ 40-43
Fiat CODE (system) .................. 7
Fiat CODE system ..................... 7
Fitting "Universal" child
restraint system ....................... 118
Fix&Go Automatic Kit ............. 169
Flashing .......................................... 52
Fluids and lubricants
(specifications).......................... 243
Fog lights ................................ 63-180"Follow me home" device ........ 53Front airbags .............................. 126
Front armrest .............................. 66
Front light clusters
(changing a bulb) ...................... 177
Front roof light
– bulb replacement.................. 184
Front roof light with spot
lights............................................. 61
Fuel cut-off switch ...................... 64
Fuel cut-off system ..................... 65
Fuel
– saving fuel ............................... 139
266GETTING TO KNOW
YOUR CAR
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX