open bonnet FIAT DUCATO 2013 Owner handbook (in English)
[x] Cancel search | Manufacturer: FIAT, Model Year: 2013, Model line: DUCATO, Model: FIAT DUCATO 2013Pages: 287, PDF Size: 4.5 MB
Page 14 of 287

There is a maximum number of acoustic/visual cycles.
When this is reached the system returns to normal
operation.
IMPORTANT The engine lock function is guaranteed by
the Fiat CODE, which is automatically activated when
the ignition key is extracted from the starter device.
TURNING THE ALARM ON
With the doors and bonnet closed and the ignition key
either turned to STOP or removed, point the key with
the remote control towards the vehicle and press and
release the lock button.
Excluding some markets, the system produces an
acoustic warning (beep) and enables door locking.
The switching on of the alarm is preceded by an self-
diagnosis stage: if a fault is detected, the system
produces another acoustic signal.
In this case, turn the alarm off by pressing the “release
doors/release load compartment” button, check that the
doors and bonnet are properly closed and turn the
alarm back on by pressing the lock button.ELECTRONIC ALARM
(for versions/markets where provided)
The alarm, in addition to all the remote control
functions described previously, is controlled by the
receiver located under the dashboard near the fuse box.
ALARM TRIPPING
The alarm intervenes in the following cases:
❒when one of the doors or bonnet is opened
illegitimately (perimeter protection);
❒when the ignition system is started up (ignition key
rotated to MAR-ON);
❒when the battery cables are cut.
Depending on the market, the activation of the alarm
causes the activation of the siren and the direction
indicators (for about 26 seconds). Alarm tripping and
the number of cycles depend on the sales market.
10
KNOWING
YOUR CAR
SAFETY
STARTING
AND
DRIVING
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
MAINTENANCE
AND CARE
TECHNICAL
SPECIFICATIONS
INDEX
Page 108 of 287

104
KNOWING
YOUR CAR
SAFETY
STARTING
AND
DRIVING
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
MAINTENANCE
AND CARE
TECHNICAL
SPECIFICATIONS
INDEX
F0N0063mfig. 123
BONNET
OPENING
Proceed as follows:
❒open the driver’s door to gain access to the bonnet
release;
❒pull the lever fig. 123 in the direction of the arrow;
❒pull the lever A-fig. 124 as shown in the figure;
❒lift the bonnet and, at the same time, release the
bonnet stay fig. 125 from its locking device D, then
insert the end C-fig. 126 of the stay into the bonnet
housing E.
IMPORTANT Before opening the bonnet, check that
windscreen wiper arms are not lifted from the
windscreen. IMPORTANT With the ignition key in the STOP
position or extracted, the electric windows remain
activated for about 3 minutes and are then deactivated
immediately when one of the doors is opened.
Incorrect use of the electric windows
may be dangerous. Before and during
operation, always check that no-one is exposed
to the risk of being injured either directly by the
moving window or through objects getting
caught and being dragged. When leaving the
vehicle, always remove the key from the ignition
to avoid the risk of injury to anyone remaining
in the car due to accidental operation of the
electric windows.
WARNING
Front passenger side door
A dedicated switch for operating the window is located
on the inner armrest of the passenger side front door.
Page 109 of 287

105
KNOWING
YOUR CAR
SAFETY
STARTING
AND
DRIVING
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
MAINTENANCE
AND CARE
TECHNICAL
SPECIFICATIONS
INDEX
F0N0323mfig. 124F0N0065mfig. 125
CLOSURE
Proceed as follows:
❒hold the bonnet up with one hand and with the
other remove the rod C-fig. 126 from the housing E
and fit it back into its locking device D-fig. 125;
❒lower the bonnet to approximately 20 centimetres
from the engine compartment, then let it drop. Make
sure that the bonnet is completely closed and not
fastened only by the safety catch. If it is not perfectly
closed, do not try to press the bonnet lid down but
open it and repeat the procedure.
IMPORTANT Always check that the bonnet is closed
properly to avoid it opening while the car is travelling.
The bonnet must always be perfectly
closed while travelling for safety reasons.
Make sure that the bonnet is properly closed
and that the lock is engaged. If you notice
whilst driving that the lock is not perfectly
engaged, stop at once and close the bonnet
properly.
WARNING
Page 280 of 287

276
KNOWING
YOUR CAR
SAFETY
STARTING
AND
DRIVING
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
MAINTENANCE
AND CARE
TECHNICAL
SPECIFICATIONS
INDEX
– washer fluid for
windscreen/rear
window/headlamps ............ 214
Cigar lighter .............................. 88
Cleaning and maintenance
– bodywork ............................ 223
– engine compartment .......... 225
– front headlights .................... 225
– glasses ................................... 225
– interiors ............................... 225
– leather upholstery .............226
– paintwork ............................ 224
– plastic parts .......................... 226
– rubber tubes ....................... 221
– seats and fabric parts ........ 226
– windows ................................ 225
CO
2emissions........................... 268
Instrument panel .................... 14
Code card................................... 5
Compartment under front
passenger seat ........................ 86
Compartment under the seat .. 36
Controls .................................... 79Cruise Control (constant speed
regulation) ............................... 74
Cruise Control (constant speed
regulator) ................................ 74
Cup/can holder ........................ 87
Dashboard ................................ 3
Daytime lights
– bulb replacement ............... 186
– control ................................. 68
Dead lock (device) .................. 99
Desk/bookrest........................... 90
Dimensions ............................... 237
Dipped beam headlights
– bulb replacement ............... 186
– control ................................. 68
Dipped headlights
– bulb replacement ............... 186
– control................................... 74
Direction indicators
– bulb replacement ....... 187-189
– control ................................. 69Direction indicators
– control ................................. 69
– front bulb replacement ..... 187
– rear bulb replacement ...... 189
Door lock .................................. 81
Door pockets ........................... 86
Doors ......................................... 96
DPF (diesel particulate filter).... 124
DPF (diesel particulate filter).... 124
EBD system .............................. 108
Electric windows ...................... 103
Electrical power supply and fuel
cut off switch .......................... 82
Electrical/electronic devices
(installation) ............................ 121
Electronic alarm ....................... 10
Engine codes ............................. 228
Engine compartment
– bonnet opening/closing ..... 104
– checking the levels ............. 209
– washing.................................. 225
Engine coolant fluid
– checking the level ............... 214