width FIAT FULLBACK 2016 1.G Owners Manual
[x] Cancel search | Manufacturer: FIAT, Model Year: 2016, Model line: FULLBACK, Model: FIAT FULLBACK 2016 1.GPages: 312, PDF Size: 13.67 MB
Page 183 of 312
rear view camera images may not be
clear. There is no abnormality.
If a radio set is installed near the
camera, the rear view camera images
may cause electrical system
interference and the system may stop
functioning properly.
It is not possible to fully see obstacles
when the lens is dirty. If the lens
becomes contaminated by water
droplets, snow, mud, or oil, wipe off the
contamination, taking care not to
scratch the lens.
Please observe the following cautions.
Ignoring them could lead to a camera
malfunction.
Do not subject the camera to
physical shook such as striking it
strongly or throwing a thing.
Do not adhere organic substances,
waxes, oil remover, and glass cleaner to
the camera. If adhered to them,
immediately wipe off.
Do not splash the camera with
boiling water.
Never spray or splash water on the
camera or around it.
Do not disconnect, disassemble or
modify the camera.
Do not scratch the camera, as this
may cause damage to the rear view
camera images.
Reference lines on the screen
Reference lines and upper surface of
the rear bumper (A) are displayed on
the screen.
Red line (B) indicates approximately
50 cm behind the rear bumper.
Two Green lines (C) indicate
approximately 20 cm outside of the
vehicle body
Short transverse lines (1 to 3)
indicate distance from the rear bumper.
1. Approximately at the rear edge of
the rear bumper 2. Approximately
100 cm 3. Approximately 200 cm
130)
Errors between the display and the
actual road surface
The reference lines for distance and
vehicle width are based on a level, flat
road surface. In the following cases,
errors are produced between the
display reference lines and the distance
on the actual road surface.
When the rear of the vehicle is
weighed down with the weight of
passengers and luggage in the
vehicle
The reference lines are displayed closer
than the actual distance. Therefore
when there is an obstacle on the
upward slope, it appears farther than its
actual position.
A. Actual objects
B. Objects shown on the screen
A1
CB
3
2
277AG0027115
AB
278AHA104720
181
Page 184 of 312
When there is an upward slope
behind the vehicle
The reference lines are displayed closer
than the actual distance. Therefore
when there is an obstacle on the
upward slope, it appears farther than its
actual position.
A. Actual objects
B. Objects shown on the screen
When there is a downward slope
behind the vehicle
The reference lines are displayed farther
than the actual distance.
Therefore when there is an obstacle on
the downward slope, it appears closer
than its actual position.A. Actual objects
B. Objects shown on the screen
When solid objects are located
close to the vehicle
When solid objects are located close to
the vehicle, the displayed distance on
the screen may differ from the actual
distance.
Because the reference lines do not
contact the body of the truck, it looks
as if it would not hit the vehicle in
following illustration.
However, the vehicle may hit the truck
because the body of the truck strays
onto the course in reality.When approaching solid objects
The reference lines for distance and
vehicle width are intended to indicate
the distance to a flat object such as a
level, flat road surface. This may make
the distance to a projecting object
shown on the screen differ from the
actual distance to the projecting object.
Do not use them as a guide to
distances to solid objects.
Example: On the screen the point B
appears the nearest, then the point C
AB
279AHA103736
BA
280AHA103749
281AHE100241
182
STARTING AND DRIVING
Page 274 of 312
Reference Length
1 Front track1,520 mm
2 Overall width1,815 mm
3 Front overhang865 mm
4 Wheel base3,000 mm
5 Rear overhangWithout rear bumper 1,330 mm
With rear bumper 1,410 mm
6 Overall lengthWithout rear bumper 5,195 mm
With rear bumper 5,275 mm
7 Ground clearance (unladen) 205 mm
8 Overall height (unladen) 1,780 mm
9 Rear track1,515 mm
10 Cargo bed length1,850 mm
11 Cargo bed width1,470 mm
12 Cargo bed height850 mm
Minimum turning radiusBody 6.3 m
Wheel 5.9 m
The vehicle overall length and height may vary depending on the equipment installed.
272
TECHNICAL SPECIFICATIONS
Page 276 of 312
Item 2WD2WD Hi-Rider
Vehicles without wide
fender2WD Hi-Rider
Vehicles with wide fender
1 Front track 1,520 mm
2 Overall width 1,785 mm 1,785 mm 1,815 mm
3 Front overhang
860 mm, 865 mm
(1)
4 Wheel base 3,000 mm
5 Rear overhangWithout rear
bumper1,340 mm
With chrome
rear bumper1,485 mm
With silver rear
bumper— 1,420 mm
6 Overall lengthWithout rear
bumper5,200 mm, 5,205 mm
(1)
With chrome
rear bumper5,345 mm, 5,350 mm(1)
With silver rear
bumper——
5,280 mm, 5,285 mm(1)
7Ground clearance
(unladen)200 mm 200 mm 205 mm
8Overall height
(unladen)1,655 mm 1,775 mm 1,780 mm
9 Rear track 1,515 mm
10 Cargo bed length 1,520 mm
11 Cargo bed width 1,470 mm
12 Cargo bed height 715 mm 845 mm 850 mm
(1) Vehicles equipped with licence garnish
274
TECHNICAL SPECIFICATIONS
Page 277 of 312
Item 2WD2WD Hi-Rider
Vehicles without wide
fender2WD Hi-Rider
Vehicles with wide fender
Minimum turning radiusBody 6.1 m 6.3 m
Wheel 5.7 m 5.9 m
Item4WD Hi-Rider
Vehicles without wide fender4WD Hi-Rider
Vehicles with wide fender
1 Front track1,520 mm
2 Overall width 1,785 mm 1,815 mm
3 Front overhang
860 mm, 865 mm
(1)
4 Wheel base 3,000 mm
5 Rear overhang Without rear bumper 1,340 mm
With chrome rear
bumper1,485 mm
With silver rear
bumper1,420 mm
6 Overall length Without rear bumper
5,200 mm, 5,205 mm
(1)
With chrome rear
bumper5,345 mm, 5,350 mm(1)
With silver rear
bumper5,280 mm, 5,285 mm(1)
7Ground clearance
(unladen)200 mm, 220 mm(2)205 mm, 220 mm(2)
8 Overall height (unladen)
1,775 mm, 1,795 mm(2)1,780 mm, 1,795 mm(2)
(1) Vehicles equipped with licence garnish
(2) Vehicles with 265/70 R16 size tyre or 245/75 R16 size tyre
275
Page 278 of 312
Item4WD Hi-Rider
Vehicles without wide fender4WD Hi-Rider
Vehicles with wide fender
9 Rear track1,515 mm
10 Cargo bed length 1,520 mm
11 Cargo bed width 1,470 mm
12 Cargo bed height
845 mm, 865 mm
(2)850 mm, 865 mm(2)
Minimum turning radiusBody 6.3 m
Wheel 5.9 m
(2) Vehicles with 265/70 R16 size tyre or 245/75 R16 size tyre
276
TECHNICAL SPECIFICATIONS
Page 280 of 312
Item 2WD 2WD Hi-Rider 4WD
1 Front track1,520 mm
2 Overall width1,785 mm
3 Front overhang 860 mm, 865 mm
*1865 mm 860 mm, 865 mm*1
4 Wheel base3,000 mm
5 Rear overhangWithout rear bumper 1,215 mm
With rear bumper 1,360 mm - 1,360 mm
6 Overall lengthWithout rear bumper 5,075 mm, 5,080 mm
*15,080 mm 5,075 mm, 5,080 mm*1
With rear bumper 5,220 mm, 5,225 mm*1- 5,220 mm, 5,225 mm*1
7 Ground clearance (unladen) 200 mm
8 Overall height (unladen) 1,655 mm 1,765 mm, 1,780 mm
*21,780 mm
9 Rear track1,515 mm
10 Cargo bed length 2,265 mm
11 Cargo bed width 1,470 mm
12 Cargo bed height 710 mm 840 mm 845 mm
Minimum turning radiusBody 6.1 m 6.3 m
Wheel 5.7 m 5.9 m
*1: Vehicles equipped with licence plate garnish*2: Vehicles equipped with rear guard frame
278
TECHNICAL SPECIFICATIONS