ECO mode FIAT IDEA 2007 1.G Owner's Guide

66
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
INSTRUMENT PANEL, DISPLAY AND BUTTON LIGHTING ADJUSTMENT
(LIGHT RHEOSTAT)
With this function it is possible to adjust the lighting (dimming/brightening) of the instrument cluster and two-zone
climate control display (where provided).
To adjust proceed as follows:
See “Initial check”
and “Access to
menu screen”
– +– +
Automatic return to standard screen
after few seconds or by
pressing button
Q
Previously
displayed
screen, e.g.:Use buttons +/– to carry out required
light adjustment.
F0H0040m
Q= Press “MODE” button for less than two seconds
R= Press “MODE” button for over two seconds

125
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
POWER WINDOWS
For the 2-button version (only front power windows)
no type of automatism (either opening or closing) is
provided. For the 4-button version (front and rear
power windows), the driver side is provided with both
opening and closing automatism, whereas the
passenger side is only provided with opening
automatism (where provided also closing automatism).
Rear windows are only provided with opening
automatism.
IMPORTANT In the event that the anti-crushing
function is activated 5 times in only 1 minute, the
system will automatically enter the “recovery” mode
(self-protection). This conditions is pointed out by the
fact that, in the closing phase, the window goes up in
jerks.
WARNINGThe system conforms to Standard 2000/4/EC concerning the safety of
passengers leaning out of the windows. The system guarantees protection only
against obstacles set between the inside and the outside of the car but not
vice versa. So, it is necessary to carry out the system restore
procedure, acting as follows:
❒perform opening control;
or
❒turn the key to STOP and then to MAR.
The logic is restored if no malfunction is present, the
window returns to its normal operation automatically;
otherwise contact a Fiat Dealership.

192
SAFETY
DEVICES
CORRECT USE
OF THE CAR
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
WARNING
LIGHTS AND
MESSAGES
GENERAL WARNINGS
Failure indicationsshown on the reconfigurable
multifunction display together with buzzer sounding
(adjustable) and warning light (if any) coming on on the
cluster, are accompanied by specific warning
messages(e.g.: “Switch off engine”, etc...). These
indications are concise and cautionaryand are
aimed to suggest the prompt actionthe driver must
adopt when a car malfunctioning appears. These
indications, however, shall not be considered as
exhaustive and/or as an alternative to the
specifications contained in this “Owner Handbook”,
which shall always be read through carefully and
thoroughly. In case of failure indication always refer
to the specifications contained in this section.
IMPORTANT Failure indications displayed on the
reconfigurable multifunction display are divided into
two categories: very serious failures and
serious/minor failures.
The message and the warning indication corresponding
to very serious failures are displayed alternately for
few seconds. This “cycle” is repeated indefinitely and it
stops any previous indication on the display. It is
displayed every time the ignition key is turned to MAR,
until the cause of malfunctioning is removed. Should failure disappear, message and warning light will
however stay on for about 2 seconds. Eliminating the
failure, the warning light and the displayed message will
go off. It is possible to stop this “cycle” by pressing
button Q; in this case the screen active before the
failure will be resumed and the warning light will stay
on until eliminating the failure cause.
The message and the warning indication corresponding
to serious/minorfailures are displayed alternately for
few seconds. This “cycle” is repeated for about 20
seconds and then goes off, but it comes on again every
time the ignition key is turned to MAR.
Should failure disappear during the 20 seconds
displaying, message and warning light will stay on for
about 2 seconds. Eliminating the failure, the warning
light and the displayed message will go off.
At the end of the display cycle (which lasts approx. 20
seconds), or if button Qis pressed, the screen active
before the failure will be resumed and the warning
light will stay on until eliminating the failure cause.
Q= Press button “MODE” for less than two seconds
R= Press button “MODE” for over two seconds

219
SAFETY
DEVICES
CORRECT USE
OF THE CAR
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
WARNING
LIGHTS AND
MESSAGES
❒flashing- indicates the possibility of damage
to the catalyst (see “EOBD system” in section
“Dashboard and controls”).
If the light flashes, it is necessary to release the
accelerator pedal to lower the speed of the
engine until the warning light stops flashing; con-
tinue the journey at moderate speed, trying to
avoid driving conditions that may cause further
flashing and contact Fiat Dealership as soon as
possible.U
amber
amber
8:30
continued from previous page
If with ignition key at MAR, the
Uwarning light does not turn on or if it turns on with fixed
light or flashing when the car is travelling (on certain versions together with the message on
the display), contact Fiat Dealership as soon as possible. Warning light
Uoperation can by
checked by traffic agents by proper equipment therefore, comply with laws and regulations
in force in the country where you are driving.
GENERIC FAILURE INDICATION
The warning light on the dial comes on when the
engine oil pressure sensor is faulty and, for
Multijet versions with modal instrument panel,
also when a failure is detected in diesel fuel sen-
sor. Contact Fiat Dealership as soon as possible.
è
Warning
light on dial Message on
multifunction displayMessage on reconfigurable
multifunction display

300
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
INDEX
DASHBOARD
AND CONTROLS
TECHNICAL
SPECIFICATIONS
1.416V1.216V1.3 Multijet
kg
–
–
–
–
–
2.4
2.55
–
–
1.5
–
–kg
–
–
–
–
–
–
–
2.54
2.65
1.8
–
–litres
–
–
47
5 - 7
6.5
–
–
4.2
4.4
1.65
0.45
1.5kg
–
–
–
–
–
–
–
3.75
3.9
1.5
–
–litres
47
5 - 7
–
–
4.5
2.75
2.9
–
–
1.65
0.45
1.5 litres
47
5 - 7
–
–
4.5
2.5
2.7
–
–
1.65
0.45
1.5kg
–
–
–
–
–
2.2
2.35
–
–
1.5
–
–litres
–
–
47
5 - 7
6.0
–
–
2.85
3.0
1.98
0.45
1.51.9 Multijet1.48V (◊)
litres
47
5 - 7
–
–
4.5
2.4
2.6
–
–
1.65
0.45
1.5kg
–
–
–
–
–
2.1
2.25
–
–
1.5
–
–
CAPACITIES
Fuel tank:
including
a reserve of:
Fuel tank:
including
a reserve of:
Engine cooling
system:
Engine sump:
Engine sump
and filter:
Engine sump:
Engine sump
and filter:
Gearbox/
differential casing:
Hydraulic
brake circuit
Windscreen and
rear window washer
fluid reservoir
(❒) For use with very cold temperatures, we recommend using SELENIA PERFORMER MULTIPOWERSAE 5W-30.
(◊) Engine model provided for certain versions/markets onlySpecified fuels
Recommended products
Unleaded Premium petrol
with no less than 95 R.O.N
(EN228 Specifications)
Diesel fuel for motor
vehicles
(Specification EN590)
Mixture of distilled water
and PARAFLU UPat 50%
SELENIA 20K (❒)
SELENIA WR
TUTELA CAR
TECHNYX
TUTELA TOP 4
Mixture of water and
TUTELA
PROFESSIONAL SC 35