Reverse FIAT MAREA 2000 1.G Workshop Manual

Marea- Marea Weekend •
2000 range ©
16v Engine
Fuel feed system
10.
1. Loosen the belt tension using the lock nut
(2) and the adjustment screw (1); then re­
lease the belt from the pulley.
2. Undo the bolts fixing the bracket for the
power assisted steering pump mounting
and detach the pump.
3. Undo the nuts fixing the exhaust manifold
to the cylinder head and detach the mani­
fold.
- To refit, reverse the order of the operations
carried out for the removal; tension the
power assisted steering pump drive belt,
using the adjustment screw; use tool
189576200 to check that the tension is
between 32 and 45 daN.
ELECTRIC FUEL PUMP WITH LEVEL
SENDER UNIT
Removing-refitting
- Disconnect the negative battery terminal.
- Lift up the lining in the luggage compart­
ment and remove the fuel pup protective
cover.
- Disconnect the electrical connection for the
electric pump assembly and the fuel supply
and breather pipes.
4. Undo the ring nut fixing the electric fuel
pump to the tank using tool 1870736000.
The gasket on the tank housing should be
replaced each time the pump drip tray is
removed-refitted.
NOTE The position of the fuel pump is fixed
and is established by a reference in
the housing in the tank which sou Id
correspond to the projection on the
pump drip tray.
Copyright by Fiat Auto 7

Marea- Marea Weekend •
2000 range ©
Engine
Fuel feed system
10.
REMOVING-REFITTING ACCELEROMETER
Removing
- Disconnect the negative battery terminal.
1. Disconnect the electrical connector (1a),
undo the fixing bolts (1b) and remove the
device (1c).
Refitting
- Reverse the order of the operations carried
out for the removal.
REMOVING-REFITTING FRONT LAMBDA
SENSOR
Removing
- Position the vehicle on a lift.
- Disconnect the negative battery terminal.
- Raise the lift.
2. Undo the lower fixing bolts (1a) and the
side fixing bolts (1b) and remove the
shield (1c) under the engine.
3. Undo the fixing nuts (1a) and remove the
lower section (1 b) of the heat shield.
4. Disconnect the electrical connector (1a)
and undo the front Lambda sensor (1b).
Copyright by Fiat Auto 3

Engine
Fuel feed system
Marea- Marea Weekend 9
2000 range ©
- Release the electrical wiring for the front
Lambda sensor from the retaining bands
and remove the sensor.
Refitting
NOTE Apply special grease (e.g. Bosch VS
14016- FT) to the threaded part ot
the sensor
- Place the Lambda sensor in position and
tighten to torque.
E Lambda sensor : 4.5 daNm
Reverse the order of the operations de­
scribed for the removal.
REMOVING-REFITTING REAR LAMBDA
SENSOR
Removing
- Position the vehicle on a lift.
- Disconnect the negative battery terminal.
1. Disconnect the electrical connector (1a)
and release the electrical wiring from the
retaining bands.
- Raise the lift.
2. Undo the lower fixing bolts (1a) and the
side fixing bolts (1b) and remove the
shield (1c) under the engine.
3. Use tool USAG 875 (1a), shown in the
diagram or a similar tool to undo the rear
Lambda sensor.
Refitting
NOTE Apply special grease (e.g. Bosch VS
14016- FT) to the threaded part of
the sensor.
- Place the Lambda sensor in position and
tighten to torque.
E Lambda sensor: 4.5 daNm
Reverse the order of the operations carried
out for the removal.
4 Print n° 506.763/23

Marea- Marea Weekend 9
2000 range ©
Engine
Fuel feed system
10.
REMOVING-REFITTING CATALYTIC
CONVERTER
Removing
- Position the vehicle on a lift.
- Disconnect the negative battery terminal.
- Remove: the upper and lower heat shields,
the front and rear Lambda sensors, carrying
out the operations described in the relevant
chapters.
- Lower the lift.
1. Undo the fixing nuts (1a) and separate the
catalytic converter (1b) from the exhaust
manifold (1c).
E
Nuts la: 3.2 daNm
- Raise the lift.
2. Undo the fixing nuts (1a) and separate the
exhaust pipe (1 b).
EI
Nuts 1a: 4.2 daNm
3. Undo the nuts (1a) and the bolts (1b) and
remove the bracket (1c).
E
E
Nuts 1a: 2.5 daNm
Bolts 1b: 2.5 daNm
- Remove the catalytic converter.
Refitting
- Reverse the order of the operations carried
out for the removal.
Copyright by Fiat Auto 7

Electrical system Marea-Marea Weekend
Radio System 2000 range Q
55.
PHONE mode
short press
On/ off:
press
VOL/AUD
adjustment:
Turn left: down.
Turn right: up
Eject
Tape
CD-CHANGER
mode > 2 sec. press Fast
rewind
(continuous) Fast rewind (continuous) fast
forward
(continu­
ous) fast
forward (continu­
ous)
CD-CHANGER
mode
short
press
On/off:
press
VOL/AUD
adjustment:
Turn left: down.
Turn right: up
TP ON/OFF Track - N Track
- N
Track +N Track
+N
Eject
Tape
CASSETTE
mode > 2 sec.
press
CASSETTE
mode
short press
On/off: press VOL/AUD
adjustment:
Turn left: down.
Turn right: up
TP ON/OFF Fast
return (to begin­
ning of tape) Track
-N max. 9)
fast
forward (to end of
tape) Track
+N max.9)
Eject
Tape
Reverse/Normal
RADIO
mode
> 2 sec. press PTY RDF
ON/OFF
FM:MAN
-
AM:MAN
-
PTY:
automatic
search
(within
pro­
gramme) FM:MAN
-
AM:MAN
-
PTY: automatic search
(within
pro­
gramme) FM:MAN
+
AM:MAN
+
PTY: automatic search
(within
pro­
gramme) FM:MAN
+
AM:MAN
+
PTY: automatic search
(within
pro­
gramme)
RADIO
mode
short press
On/off: press VOL/AUD
adjustment:
Turn left:
down.
Turn right:
up TP ON/OFF AF ON/OFF FM: search -AM: search -PTY: Select next programme FM: (store next IS AM: search -PTY: Select next programme FM: search + AM: search + PTY: Select next programme FM: (store next IS AM: search + PTY: Select next programme Eject
Tape
Status EXPERT
Li-Li. O II CO
z o ii CO
LL U_ O II CO CO 5
z o II CO CO
LL LL O II to
z o II CO
LL U_ O II to CO MSS=0N
Function Radio
on/off
VOL/AUD
ad­
justment TP Traffic programme AF: Alternate frequency Previous (left) programme (right) Eject Reverse
Key CM LO CD
28 Publication no. 506.763/24

Electrical system
Radio System
PHONE mode
short
press
On/off: press
VOL/AUD
adjustment:
Turn left:
down.
Turn right: up
CASSETTE
mode
press
> 2
sees
CASSETTE
mode
short press
On/off: press
VOL/AUD
adjustment:
Turn left:
down.
Turn right: up TP ON/OFF Fast
rewind
Fast
forward
Reverse/Normal (IF
PRESSED
HALF
WAY)
Eject
Tape (IF
FULLY
DEPRESSED)
RADIO
mode
press
> 2
sees
NO Aid
RDF
ON/OFF
FM:MAN
-
AM:MAN
-
PTY: Automatic search
(within
programme)
FM:MAN
-
AM:MAN
-
PTY: automatic search
(within
programme)
FM:MAN
+
AM:MAN
+
PTY: automatic search
(within
programme)
FM:MAN
+
AM:MAN
+
PTY: automatic search
(within
programme)
FM/AM:
store preset
station 1 PTY: store
programme
FM/AM:
store preset
station 2 PTY: store programme FM/AM:
store preset
station 3 PTY: store
programme
RADIO
mode
short press
On/off: press
VOL/AUD
adjustment:
Turn left:
down.
Turn right: up TP ON/OFF AF ON/OFF FM: Search -AM: Search -PTY: Select next programme FM: Store next IS AM: Search -PTY: Select next programme FM: Search + AM: Search + PTY: Select next programme FM: Store next IS AM: Search + PTY: Select next programme FM/AM/PTY:
recall preset sta­
tion! FM/AM/PTY:
recall preset sta-
tion2
I
FM/AM/PTY:
recall preset sta­
tions
Status EXPERT
LL LL O
to
z o II CO IS=OFF
NO=SI
Function
radio
on/off
VOL/AUD
adjustment
TPTraffic programme AF: Alternate frequency Previous (left) programme (destra) Fast
rewind
Fast
forward
Reverse
or Eject
(IF PRESSED
TO­
GETHER) Preset
station
1
Preset
station2
Preset
station3
Key CM CO LO CD r^ co co
Marea-Marea Weekend
2000 range Q
Copyright by Fiat Auto 31

Marea- Marea Weekend Electrical system
2000 range (§) Radio System
55.
TAPE PLAYER; - version H3
Activating tape operation
Place a tape in the slot. «TAPE A» or«TAPE B» appears on the display.
/T the slot already contains a tape, press the SRC repeatedly until «TAPE» appears on the display.
SRC = Source; the sources are: RADIO, TAPE, CDC.
4F047LL01
Changing tape side
Press the D REVERSE key briefly.
When the end of the tape is reached the side changes automatically.
The meanings of the symbols on the display are as follows:
«TAPE A» : top side of tape
«TAPE B» : bottom side of tape.
MSS function
MSS = Music-Search-System
This function can be used to forward/rewind to the beginning of the track to obtain the "skip track" or
"repeat track" function.
Pauses of at least 3 seconds are left between tracks for the MSS function (without an announcement
text). Musical pieces with very low passages (e.g. classical music) are not suitable because these are
treated as pauses.
Activating MSS
The MSS function can be turned on or off from the EXPERT menu; the standard condition is MSS ON
In this configuration, press key B to make the radio skip a number of tracks corresponding to the number
of presses on the key; «+ --« appears on the display.
Example: 3 short presses on the key: skip three tracks;; «+3» appears on the display.
When keys A or B are pressed for longer than 2 seconds, the CD player is made to forward/rewind fully
to the end of the tape.
If the MSS function is deactivated ( from EXPERT) a short press on key A or B allows fast forward or
fast rewind of the tape.
Copyright by Fiat Auto Xfl-00 - Update 47