bonnet FIAT PANDA 2013 319 / 3.G User Guide
[x] Cancel search | Manufacturer: FIAT, Model Year: 2013, Model line: PANDA, Model: FIAT PANDA 2013 319 / 3.GPages: 284, PDF Size: 11.33 MB
Page 200 of 284

BODY AND UNDERBODY WARRANTY
Your car is covered by warranty against perforation
due to corrosion of any original element of the
structure or body.
For the general terms of this warranty, refer to your
Warranty Booklet.
PRESERVING THE BODYWORK
Paintwork
Touch up abrasions and scratches immediately to
prevent the formation of rust.
Maintenance of paintwork consists of washing the
car: the frequency depends on the conditions and
environment where the car is used. For example, in
highly polluted areas, or if the roads are spread
with salt, it is advisable to wash the car more
frequently.To correctly wash the car, proceed as follows:
❒remove the aerial from the roof to prevent damage
to it if the car is washed in an automatic system;
❒if high pressure jets or cleaners are used to wash
the car, keep a distance of at least 40 cm from
the bodywork to avoid damage or alteration.
It should be remembered that the build up
of water can damage the car over a period of time;
❒wash the body using a low pressure jet of water;
❒wipe a sponge with a slightly soapy solution over
the bodywork, frequently rinsing the sponge;
❒rinse well with water and dry with a jet of air or a
chamois leather.
Dry the less visible parts (e.g. door frames, bonnet,
headlight frames etc.) with special care, as water may
stagnate more easily in these areas. The car should
not be taken to a closed area immediately, but
left outside so that residual water can evaporate.
Do not wash the car after it has been left in the sun
or with the bonnet hot: this may alter the shine of
the paintwork.
Exterior plastic parts must be cleaned in the same
way as the rest of the car.
196
GETTING TO KNOW
YOUR CAR
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCYSERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
Page 205 of 284

BODYWORK PAINT IDENTIFICATION
PLATE
This is applied inside the bonnet (left side) and bears
the following data fig. 160:
APaint manufacturer.
BColour name.
CFiat colour code.
DRespray and touch up code.
CHASSIS MARKING
This is located on the right side of the luggage
compartment floor and gives the following
identification data:
❒type of vehicle;
❒chassis serial number.ENGINE MARKING
This is stamped on the cylinder block and gives the
model and the chassis serial number.
fig. 160
F0W0030
201GETTING TO KNOW
YOUR CAR
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCETECHNICAL
SPECIFICATIONSINDEX
Page 276 of 284

INDEX
A
BS ............................................. 72
ABS (system) ............................. 72
Air Bag
– Deactivation of
passenger front air bag
and side bag ........................ 117
– side bag ................................ 117
– window bag ......................... 118
Air Bags ..................................... 115
Air cleaner ................................ 189
Ashtray ....................................... 54
ASR system................................ 75
ASR (system) ............................. 75
Automatic climate control ..... 37
– controls ................................. 37
– maintenance ......................... 43
B
attery...................................... 190
– advice for extending
lifetime ................................. 190
– replacement ........................ 190
Battery (recharging) ............... 171Bodywork
– bodywork codes ................ 202
– maintenance ........................ 196
– protection against
atmospheric agents ........... 195
– warranty .............................. 196
Bodywork versions ................. 202
Bonnet ........................................ 68
Brake (mechanical wear
detection system) ................. 191
Brakes
– brake fluid level .................. 188
– specifications ...................... 206
bulb replacement ............ 158-160
Bulb replacement
– exterior lights ..................... 157
– interior lights ...................... 162
Bulbs
– bulbs (replacement) .......... 154
– general instructions........... 154
– types of bulbs ..................... 155
C
ar dimensions ....................... 215
Carrying children safely ......... 107
– Carrying children safely.... 107
– child seats ............................ 114Central air diffusers ................. 31
Changing a wheel .................... 144
Checking levels ...............................
183-184-185-186
Children (safe transport)
– "Isofix" child seat setup .... 112
Child seats (compliance for
use) ........................................... 111
City Brake Control -
"Collision Mitigation"
System ....................................... 83
CITY function ........................... 90
Cleaning and maintenance
– bodywork ............................ 195
– car interior .......................... 198
– engine compartment ........ 197
– front headlights .................. 197
– Plastic and coated parts ... 198
– seats...................................... 198
– windows............................... 197
Climate control ........................ 31
– Passenger compartment
air diffusers........................... 32
Climatic comfort ...................... 32
Clutch ........................................ 206
CO2 emissions ........................ 226
272
GETTING TO KNOW
YOUR CAR
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX