reset FIAT PANDA 2013 319 / 3.G User Guide

USER EQ SETTINGS FUNCTION
(equaliser settings only if the USER setting has
been selected)
To set a customised equaliser adjustment, move to
"User" using the
or
buttons and press the
MENU button.
A 7-bar graph appears on the display, in which each
bar represents a frequency.
Select the bar to adjust using the
or
buttons; the
selected bar will start to flash and it can be adjusted
using the
or
buttons.
To store the setting, press the
button again. The
display will show the source activated at that time
followed by the text “User”. If the mode is “FM” the
display will show the text "FM EQ User".
MENU
Menu button functions
Press the Menu function briefly to activate the
MENU function. The display will show the first menu
item that can be adjusted (AF) ("AF Switching On" on
the display).
Use the
or
buttons to scroll through the menu
functions. To change the setting of the function
selected use the
or
buttons.
The current status of the function selected will be
shown on the display.
The functions managed by the Menu are:
❒AF SWITCHING (ON/OFF);❒TRAFFIC INFORMATION (ON/OFF);
❒REGIONAL MODE regional programmes
(ON/OFF);
❒MP3 DISPLAY (CD MP3 display settings);
❒SPEED VOLUME (speed-dependent automatic
volume control);
❒RADIO ON VOLUME (maximum radio volume
limit activation/deactivation);
❒SPEECH VOLUME (telephone volume setting);
❒AUX OFFSET (alignment of the portable device
volume to that of the other sources);
❒RADIO OFF (switching-off mode);
❒SYSTEM RESET Press the Menu button again to
exit the Menu function.
Note
The AF SWITCHING, TRAFFIC INFORMATION and
REGIONAL MODE adjustments are only possible in
FM mode.
246
SOUND-SYSTEM

Note
If the TA function is activated with an audio source
other than Tuner (Radio) (CD, MP3, telephone or
Mute/Pause), the radio can carry out an automatic
search and therefore it is possible, when reactivating
the Tuner (Radio) source, that the frequency tuned
into is different from the one previously set.
With the TA function, it is possible to:
❒search only for RDS stations that broadcast in FM
and are enabled to broadcast traffic information;
❒receive traffic information even when the CD
player is in operation;
❒receive traffic information at a minimum preset
volume even with the radio volume off.Note
In some countries there are radio stations that, even
with the TP function activated, do not transmit traffic
information (the icon "TP" appears on the display).
If the radio is tuned to a station in the AM band,
when TA is activated it will tune to the last selected
station in the FM1 band.
The volume at which the traffic news is transmitted
depends on the listening volume:
❒listening volume below 5: traffic news volume 5
(fixed value);
❒listening volume above 5: traffic news volume equal
to listening volume +1.
If the volume is changed during traffic news, the level
will not be shown on the display; the new level will
only be maintained during the news.
While traffic information is being received, “TRAFFIC
INFORMATION” will appear on the display.
The TA function can be interrupted by pressing any
button on the car radio.
248
SOUND-SYSTEM

SYSTEM RESET function
This function is used to restore all settings to the
factory values.
The options are:
❒NO: no restore intervention;
❒YES: the default parameters will be restored.
During this operation, the text “Resetting” appears
on the display. At the end of the operation, the
source does not change and the previous situation
will be displayed.
PHONE SET-UP
If a hands-free kit is installed on the car, when there
is an incoming phone call the radio audio will be
connected to the telephone output. The incoming
telephone sound always arrives at a fixed volume, but
it can be adjusted during the conversation using the
ON/OFF button/knob.
The fixed telephone audio volume can be adjusted
using the "SPEECH VOLUME" function in the Menu.
The text “PHONE” appears on the display during the
telephone audio deactivation.ANTI-THEFT PROTECTION
The radio is equipped with an anti-theft protection
system based on the exchange of information
between the radio and the electronic control unit
(Body Computer) on the car.
This system guarantees maximum safety and prevents
the secret code from being entered each time the
radio power supply is disconnected.
If the check has a positive outcome, the radio will
start to function, whereas if the comparison codes
are not the same or if the electronic control unit
(Body Computer) is replaced, the device will ask the
user to enter the secret code according to the
procedure described in the paragraph below.
Entering the secret code
When the radio is switched on, if the code is
requested, the display will show "Radio code" for
about 2 seconds followed by four dashes "----".
The code is made up of four numbers from 1 to 6,
each corresponding to one of the dashes.
To enter the first digit of the code, press the
corresponding button of the pre-selected stations
(from 1 to 6). Enter the other code digits in the same
way.
If the four digits are not entered within 20 seconds,
the display will show "Enter code----".Ifthis
occurs, it is not considered an incorrect code entry.
After entering the fourth digit (within 20 seconds),
the car radio will start to work.
252
SOUND-SYSTEM

PRESET BUTTONS
The buttons numbered from 1 to 6 are used to set
the following preset stations:
❒18 in the FM band (6 in FM1, 6 in FM2, 6 in FMT or
"FMA" (on some versions);
❒12 in the MW band (6 in MW1, 6 in MW2).
To listen to a preset station, select the desired
frequency band and then briefly press the
corresponding preset button (from 1 to 6).
By pressing the preset button for more than 2
seconds, the tuned station will be stored. The storing
phase is confirmed by an acoustic signal.
STORING THE LAST STATION LISTENED
TO
The radio automatically stores the last station that
was selected for each reception band, which is then
tuned into when the radio is turned on or when the
reception band is changed.AUTOMATIC TUNING
Briefly press the
or
button to start the
automatic tuning search for the next station that can
be received in the selected direction.
If the
or
button is pressed down longer, the fast
search starts. When the button is released, the tuner
will stop on the next station that can be received.
If the TA function (traffic alerts) is on, the tuner will
only search for stations that broadcast traffic news.
MANUAL TUNING
This is used to manually search for stations in the
preselected band.
Select the desired frequency band and then press the
or
button briefly and repeatedly to start the
search in the desired direction.
If the or
buttons are pressed longer, the fast
search will start and then stop when the button is
released.
255
SOUND-SYSTEM

AUTOSTORE FUNCTION
(automatic station storing)
To activate the Autostore function, hold the FM AS
button down until a beep is heard. With this
function, the radio automatically stores the 6 stations
with the strongest signal in a decreasing order on the
FMA frequency band.
During the automatic storing process, the text
“Autostore” flashes on the display.
Press the FM AS button again to stop the Autostore
function: the radio will again tune into the station
listened to before the activation of the function.
When the Autostore function has finished, the radio
automatically tunes into the first preselected station
on the FMA band on the preset side 1.
The stations that have a strong signal at that moment
are then automatically stored in the preselected band
on the buttons numbered 1 to 6.
When the Autostore function is activated within the
MW band, the FMA band is automatically selected
and the function is performed there.
Note
Sometimes the Autostore function is not able to find
6 stations with a strong signal. In this case, the
strongest stations stored will be duplicated in the
free preset buttons.Note
When the Autostore function is activated, the
stations that were previously stored in the FMA band
are deleted.
EMERGENCY ALARM RECEPTION
The radio is configured to receive emergency alerts
in RDS mode in exceptional circumstances or where
dangerous situations are present (earthquakes,
floods, etc.) if these are being transmitted by the
current broadcaster.
This function is activated automatically and cannot be
turned off.
The word “Alarm” will be shown in the display during
the transmission of an emergency announcement.
The volume of the radio changes during this
announcement in the same way as during traffic
news.
256
SOUND-SYSTEM