stop start FIAT PANDA 2013 319 / 3.G Workshop Manual

ENGINE OIL
Check the oil level a few minutes (about five) after
the engine has stopped, with the vehicle parked
on level ground.
For 1.2 8V 69 HP and 1.3 16V MultiJet
versionsfig. 152 fig. 153
Remove the engine oil dipstick B, clean it with a
cloth that does not leave any trace and reinsert it.
Extract the engine oil dipstick again and check that
the level is between the MIN and MAX marks on the
dipstick.
The range between the MIN and MAX marks
corresponds to about 1 litre of oil.
If the oil level is near or under the MIN mark, add oil
through the filler A until it reaches the MAX mark.
The oil level should never exceed the MAX
mark.
For 0.9 TwinAir 65 HP fig. 150 and 0.9 TwinAir
85 HP versions fig. 151
The engine oil dipstick B is integral with plug A.
Loosen the plug, clean the dipstick with a cloth that
does not leave traces, reinsert the dipstick and
re-tighten the plug. Extract the plug again and check
that the level is between the MIN and MAX marks
on the dipstick.Engine oil consumption
The maximum engine oil consumption is
approximately 400 grams every 1,000 km.
During the initial period of usage for the vehicle, the
engine is bedding in, therefore the engine oil
consumption may settle down only after the first
5,000 - 6,000 km.
IMPORTANT After adding or changing the oil, let the
engine run for a few seconds and wait a few minutes
after switching it off before checking the level.
Do not add oil with characteristics that
are different from those of the oil
currently in the engine.Used engine oil and filter contain harmful
substances for the environment .To change
the oil and filters, we advise you to
contact a Fiat Dealership.
ENGINE COOLANT FLUID
The coolant level must be checked when the engine
is cold and must be between the MIN and MAX
marks on the reservoir.
If the level is too low, undo reservoir cap C (see
previous pages) and add the fluid described in the
chapter "Technical Specifications".
187GETTING TO KNOW
YOUR CAR
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCYSERVICING AND
MAINTENANCETECHNICAL
SPECIFICATIONS
INDEX

WHEELS AND TYRESBefore long trips, and every two weeks, check the
tyre and space-saver wheel inflation pressure (for
versions/markets, where provided). Check the tyres
when cold.
It is normal for the pressure to increase when the
car is used; for the correct tyre inflation pressure,
see “Wheels” in the “Technical specifications”
section.
Incorrect pressure causes abnormal tyre wear
fig. 154:
A normal pressure: tread evenly worn;
B low pressure: tread particularly worn at the edges;
C high pressure: tread particularly worn in the
centre.The tyres must be replaced when the tread is less
than 1.6 mm thick. In any case, follow the laws
in force in the country where you are driving.
IMPORTANT
Take the following precautions to prevent damage to
the tyres:
❒avoid braking suddenly, racing starts and violent
impact against the curb, potholes or other
obstacles and driving for extended periods on
uneven road surfaces;
❒periodically check that the tyres have no cuts in
the side wall, abnormal swelling or irregular tread
wear;
❒avoid travelling with the car overloaded. If a tyre is
punctured, stop immediately and change it;
❒tyres age even if they are not used much. Cracks in
the tread rubber and at the sides are a sign of
ageing. In any case, if the tyres have been on the
car for over 6 years, they should be checked
by specialised personnel. Also remember to check
the space-saver wheel very carefully (for
versions/markets, where provided);
❒change the position of the tyres every 10-15
thousand kilometres, keeping them on the same
side of the car to avoid inverting the rotation
direction;
❒In the case of replacement, always fit new tyres,
avoiding those of dubious origin;
❒if a tyre is changed, also change the inflation valve.
fig. 154
F0W0018
192
GETTING TO KNOW
YOUR CAR
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCYSERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX

Avoid parking under trees as much as possible; the
resin from trees dulls the paintwork and increases
the possibility of corrosion.
IMPORTANT Bird droppings must be washed off
immediately and thoroughly as the acid they contain
is particularly aggressive.
Detergents pollute the environment . Only
wash your car in areas equipped to collect
and treat wastewater from this type of
activity.In order to preserve the aesthetic
appearance of the paint abrasive products
and/or polishes should not be used for
cleaning the car.
Windows
Use specific detergents and clean cloths to prevent
scratching or altering the transparency.
IMPORTANT Wipe the rear window inside gently
with a cloth in the direction of the filaments to avoid
damaging the heating device.
Front headlights
Use a soft, damp cloth soaked in water and
detergent for washing cars.
IMPORTANT Never use aromatic substances (e.g.
petrol) or ketones (e.g. acetone) for cleaning the
plastic lenses of the front headlights.Engine compartment
At the end of every winter, wash the engine
compartment thoroughly, taking care not to aim the
jet of water directly at the electronic control units or
at the windscreen wiper motors. Have this
operation performed at a specialised workshop.
IMPORTANT The washing should take place with the
engine cold and the ignition key in the STOP
position. After the washing operation, make sure
that the various protections (e.g. rubber caps and
guards) have not been removed or damaged.
197GETTING TO KNOW
YOUR CAR
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCYSERVICING AND
MAINTENANCETECHNICAL
SPECIFICATIONS
INDEX

PRESET BUTTONS
The buttons numbered from 1 to 6 are used to set
the following preset stations:
❒18 in the FM band (6 in FM1, 6 in FM2, 6 in FMT or
"FMA" (on some versions);
❒12 in the MW band (6 in MW1, 6 in MW2).
To listen to a preset station, select the desired
frequency band and then briefly press the
corresponding preset button (from 1 to 6).
By pressing the preset button for more than 2
seconds, the tuned station will be stored. The storing
phase is confirmed by an acoustic signal.
STORING THE LAST STATION LISTENED
TO
The radio automatically stores the last station that
was selected for each reception band, which is then
tuned into when the radio is turned on or when the
reception band is changed.AUTOMATIC TUNING
Briefly press the
or
button to start the
automatic tuning search for the next station that can
be received in the selected direction.
If the
or
button is pressed down longer, the fast
search starts. When the button is released, the tuner
will stop on the next station that can be received.
If the TA function (traffic alerts) is on, the tuner will
only search for stations that broadcast traffic news.
MANUAL TUNING
This is used to manually search for stations in the
preselected band.
Select the desired frequency band and then press the
or
button briefly and repeatedly to start the
search in the desired direction.
If the or
buttons are pressed longer, the fast
search will start and then stop when the button is
released.
255
SOUND-SYSTEM

DISPLAY INFORMATION
When the CD player is in operation, information
appears on the display with the following meanings:
❒"CD Track 5": indicates the number of the CD
track;
❒"03.42": indicates the time elapsed since the start
of the track (if the relevant Menu function is
activated).
TRACK SELECTION (forward/backward)
Briefly press the
button to play the previous CD
track and the
button to play the next track.
The tracks are selected cyclically: the first track is
selected after the last track and vice versa.
If the track has been played for more than 3 seconds,
pressing thebutton will cause the track to be
started again from the beginning.
In this case, if you want to play the previous track,
press the button twice consecutively.
TRACK FAST FORWARD/REWIND
Keep the
button pressed down to fast forward the
selected track and hold the
button down to fast
rewind the track.
The fast forward/rewind will stop once the button is
released.PAUSE FUNCTION
To pause the CD player, press the
button. The text
“CD Pause” appears on the display.
To resume listening to the track, press the
button
again. If another audio source is selected, the pause
function is turned off.
259
SOUND-SYSTEM

Sensors
– parking................................... 88
Servicing and care ................... 175
– heavy-duty use of the
car ......................................... 181
– periodic checks .................. 181
– scheduled servicing ........... 175
– scheduled servicing plan... 176
Side air diffusers ....................... 31
Side Bag ..................................... 117
Side
– bags ....................................... 117
Snow chains .............................. 130
Sound system (wiring)............. 91
Speedometer ............................. 6
Speedometer (speed
indicator) .................................. 6
Starting the engine ......... 121-143
Starting up and driving ........... 121
Start&Stop system ................... 79
Start&Stop (system) ................ 79
Steering lock.............................. 22
Steering system ....................... 208
Steering wheel .......................... 28
Steering wheel stalks– left stalk ................................ 45
Storing the car ......................... 131
Sun roof ...................................... 56
Sun visors ................................... 55
Suspension ................................ 207
T
echnical data ......................... 200
Third brake lights .................... 160
Top speed ................................. 217
Towing the car ......................... 173
Towing trailers ......................... 128
Traction Plus system................ 78
Transmission ............................ 206
TRIP button ............................... 17
Trip computer
– TRIP button ......................... 17
– Trip Computer .................... 16
– Trip Computer values........ 16
Tyres
– FIX&GO automatic (kit).. 149
– inflation pressure ............... 213
– reading the tyre code ....... 209
– Rim Protector tyres .......... 214
– snow tyres........................... 210
– tyres provided .................... 210Tyres - maintenance ............... 192
"Universal" child seat
fitting........................................ 114U
niversal Isofix (child
seat) ......................................... 112
Using the gearbox ................... 125
W
arning lights on panel ....... 132
Weights and loads ................... 218
Wheel rims
– correct reading of the
rim code .............................. 210
– dimensions .......................... 210
– rim protector ..................... 214
– rims and tyres..................... 209
Wheels and tyres
– changing a wheel ................ 144
– FIX&GO automatic (kit).. 149
– spare wheel ......................... 209
– tyre inflation pressure ...... 213
– Wheels and tyres .............. 192
Window bag ............................. 118
Window cleaning...................... 47
Windows (cleaning)................ 197
276
GETTING TO KNOW
YOUR CAR
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX