automatic transmission FIAT PANDA 2014 319 / 3.G Owners Manual

CITY BRAKE CONTROL - "Collision
Mitigation" SYSTEM(for versions/markets, where provided)
This is a driving assistance system that can detect the
presence of nearby cars in front of the vehicle and,
in case of imminent collision, intervenes
automatically, braking the car to prevent the impact
or mitigate its effects.
The system only works if:
❒the ignition key is at MAR-ON;
❒the car speed is between 5 and 30 km/h;
❒the front seat belts are fastened.
The system can be deactivated (and then reactivated)
with the display setup menu (see paragraph “Menu
items” in this chapter).
The system activates if there is risk of imminent
collision and the driver does not press the brake
pedal promptly.
If the system detects that the vehicle ahead could be
hit, it may prepare the car to a possible emergency
braking.
If the driver does not carry out any action to prevent
the collision, the system may automatically slow
down the car, in order to prepare it to a possible
impact.When there is risk of impact, if the action on the
brake pedal by the driver is not sufficient, the system
may intervene in order to improve the reaction of
the braking system, therefore reducing car speed
further.
When driving uphill on a steep slope, the system may
intervene, activating the braking system.
Versions equipped with Start&Stop system:at
the end of the automatic braking, the Start&Stop
system will activate as described in paragraph
"Start&Stop system" of this chapter.
Versions equipped with manual gearbox:atthe
end of the automatic braking the engine may stall
and turn off, unless the driver presses the clutch
pedal.
Versions equipped with Dualogic automatic
transmission(for versions/markets, where
provided): at the end of braking the last gear stored
remains engaged.
IMPORTANT Both on versions equipped with
manual gearbox and on those with Dualogic
automatic transmission (for versions/markets, where
provided), after the car is stopped the brake calipers
may be stuck for about 2 seconds for safety reasons.
Make sure you press the brake pedal if the car moves
slightly forwards.
IMPORTANT The system doesNOTactivate
engaging the reverse. The system doesNOTactivate
if the front seat belts are not fastened.
83GETTING TO
KNOW YOUR CARSAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX

REGIONAL MODE function
(regional transmission reception)
Some national broadcasters will transmit regional
programmes at certain times of the day (that vary
from region to region).
This function makes it possible to tune into local
(regional) broadcasters automatically (see "EON
function" paragraph).
If you want the radio to automatically tune into the
regional stations being broadcast on the selected
network, the function must be activated.
To activate/deactivate the function use the
or
buttons.
The current status of the function appears on the
display:
❒"Regional On": function activated;
❒"Regional Off": function deactivated.
If the function is deactivated and you have tuned into
a regional station working in a given area and you
enter a different area, then the regional station
received in the new area will be broadcast.
Note
If the AF and REG functions are on at the same time,
once a border between two regions is crossed, the
radio may not switch correctly to a valid alternative
frequency.MP3 DISPLAY function
(MP3 CD data display)
This function makes it possible to select the
information shown by the display when listening to a
CD containing MP3 tracks.
The function can only be selected if an MP3 CD is
inserted: in this case "MP3 Display" will appear on the
display.
To change the function, use the
or
buttons.
The following settings are available:
❒"Title" (track title, if the ID3-TAG is available);
❒"Author" (track author, if ID3-TAG is available);
❒"Album" (track album, the ID3-TAG if available);
❒"Folder" name (name assigned to the folder);
❒"File" name (name assigned to the MP3 file).
249
SOUND-SYSTEM

AUTOSTORE FUNCTION
(automatic station storing)
To activate the Autostore function, hold the FM AS
button down until a beep is heard. With this
function, the radio automatically stores the 6 stations
with the strongest signal in a decreasing order on the
FMA frequency band.
During the automatic storing process, the text
“Autostore” flashes on the display.
Press the FM AS button again to stop the Autostore
function: the radio will again tune into the station
listened to before the activation of the function.
When the Autostore function has finished, the radio
automatically tunes into the first preselected station
on the FMA band on the preset side 1.
The stations that have a strong signal at that moment
are then automatically stored in the preselected band
on the buttons numbered 1 to 6.
When the Autostore function is activated within the
MW band, the FMA band is automatically selected
and the function is performed there.
Note
Sometimes the Autostore function is not able to find
6 stations with a strong signal. In this case, the
strongest stations stored will be duplicated in the
free preset buttons.Note
When the Autostore function is activated, the
stations that were previously stored in the FMA band
are deleted.
EMERGENCY ALARM RECEPTION
The radio is configured to receive emergency alerts
in RDS mode in exceptional circumstances or where
dangerous situations are present (earthquakes,
floods, etc.) if these are being transmitted by the
current broadcaster.
This function is activated automatically and cannot be
turned off.
The word “Alarm” will be shown in the display during
the transmission of an emergency announcement.
The volume of the radio changes during this
announcement in the same way as during traffic
news.
256
SOUND-SYSTEM

EON FUNCTION (Enhanced Other Network)
In some countries, there are circuits that group
multiple broadcasters that transmit traffic
information together. In this case, the programme of
the station that is being listened to will be
temporarily interrupted to:
❒receive traffic alerts (only with the TA function
activated);
❒listen to regional transmissions each time these are
broadcast by one of the broadcasters on the same
circuit.
STEREOPHONIC BROADCASTERS
If the incoming signal is weak, the reproduction is
automatically switched from Stereo to Mono.
CD PLAYERINTRODUCTION
This section describes the variants regarding the
operation of the CD player: as far as the operation of
the radio is concerned, refer to the description in the
"Functions and Adjustments" chapter.
SELECTING THE CD PLAYER
To activate the CD player built into the equipment,
proceed as follows:
❒insert a CD with the equipment switched on: the
first track will start to play;
or
❒if a CD has already been loaded, turn on the car
radio and then briefly press the CD button to
select the “CD” operating mode: the last track
listened to will start to play.
It is advisable to use original CDs to ensure optimum
playback. If CD-R/RWs are used, we recommend
using good quality media that are burnt at the
slowest speed possible.
257
SOUND-SYSTEM

Sensors
– parking................................... 88
Servicing and care ................... 175
– heavy-duty use of the
car ......................................... 181
– periodic checks .................. 181
– scheduled servicing ........... 175
– scheduled servicing plan... 176
Side air diffusers ....................... 31
Side Bag ..................................... 117
Side
– bags ....................................... 117
Snow chains .............................. 130
Sound system (wiring)............. 91
Speedometer ............................. 6
Speedometer (speed
indicator) .................................. 6
Starting the engine ......... 121-143
Starting up and driving ........... 121
Start&Stop system ................... 79
Start&Stop (system) ................ 79
Steering lock.............................. 22
Steering system ....................... 208
Steering wheel .......................... 28
Steering wheel stalks– left stalk ................................ 45
Storing the car ......................... 131
Sun roof ...................................... 56
Sun visors ................................... 55
Suspension ................................ 207
T
echnical data ......................... 200
Third brake lights .................... 160
Top speed ................................. 217
Towing the car ......................... 173
Towing trailers ......................... 128
Traction Plus system................ 78
Transmission ............................ 206
TRIP button ............................... 17
Trip computer
– TRIP button ......................... 17
– Trip Computer .................... 16
– Trip Computer values........ 16
Tyres
– FIX&GO automatic (kit).. 149
– inflation pressure ............... 213
– reading the tyre code ....... 209
– Rim Protector tyres .......... 214
– snow tyres........................... 210
– tyres provided .................... 210Tyres - maintenance ............... 192
"Universal" child seat
fitting........................................ 114U
niversal Isofix (child
seat) ......................................... 112
Using the gearbox ................... 125
W
arning lights on panel ....... 132
Weights and loads ................... 218
Wheel rims
– correct reading of the
rim code .............................. 210
– dimensions .......................... 210
– rim protector ..................... 214
– rims and tyres..................... 209
Wheels and tyres
– changing a wheel ................ 144
– FIX&GO automatic (kit).. 149
– spare wheel ......................... 209
– tyre inflation pressure ...... 213
– Wheels and tyres .............. 192
Window bag ............................. 118
Window cleaning...................... 47
Windows (cleaning)................ 197
276
GETTING TO KNOW
YOUR CAR
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX