heater FORD AEROSTAR 1996 1.G Owners Manual
[x] Cancel search | Manufacturer: FORD, Model Year: 1996, Model line: AEROSTAR, Model: FORD AEROSTAR 1996 1.GPages: 353, PDF Size: 2.87 MB
Page 69 of 353
68
*
[ST07450(ALL)05/95]
RWARNING
Do not park, idle, or drive your vehicle in
dry grass or other dry ground cover. The
emission system heats up the engine
compartment and exhaust system, which
can start a fire.
*
[ST07500(ALL)03/95]
If you consistently start your vehicle in subzero
temperatures, use an engine block heater (if
your vehicle has this option).
%*
[ST07600(ALL)06/95]
Engine Block Heater (If equipped)
*
[ST07700(ALL)03/95]
Engine block heaters are strongly recommended
if you live in a region where temperatures reach
-10ÊF (-23ÊC) orbelow. An engine block heater
warms the engine coolant, which improves
starting, warms up the engine faster, and allows
the heater-defrost system to respond quickly.
*
[ST08000(ALL)05/95]
RWARNING
To prevent electrical shock, do not use
your heater with ungrounded electrical
systems or two-pronged (cheater) adapters.
*
[ST08100(ALL)03/95]
For best results, plug the heater in at least three
hours before you start your vehicle. Using the
heater for longer than three hours will not
damage the engine, so you can plug it in at
night to start your vehicle the following
morning.
*
[ST08150(ALL)12/91]
NOTE: Be sure to disconnect the engine block
heater before driving your vehicle.
File:04cpsta.ex
Update:Tue Aug 29 17:35:31 1995
Page 207 of 353
227
*
[RE01500(ALL)03/95]
4. Check all battery terminals and remove any
excessive corrosion before you attach the
jumper cables.
[RE01600(ALL)08/95]
5. Turn on the heater fan in both vehicles. Turn
the function selector knob to theV
position. Turn off all other switches and
gauges.
%*
[RE01700(ALL)05/95]
Connecting the jumper cables
*
[RE01800(ALL)03/95]
1. Connect one end of the first jumper cable to
the positive (+) terminal of the discharged
battery. (You can connect either jumper cable
to the positive (+) terminal, as long as you
use the same cable for both positive
terminals.) Most jumper cables have a red
cable and a black cable. The red cable is
generally used for the positive terminals and
the black for the negative ones.
*
[RE01900(ALL)04/95]
2. Connect the other end of the first cable to
the positive (+) terminal of the booster
battery.
*
[RE02000(ALL)07/95]
3. Connect one end of the second cable to the
negative (S) terminal of the booster battery
Ð NOT to the discharged battery.
*
[RE02100(ALL)03/95]
4. Connect the other end of that cable to a
good metallic surface on the engine or frame
of the disabled vehicle. The following
illustration shows where you can find a
metallic surface.
*
[RE02200(ALL)07/95]
RWARNING
Do not connect the end of the second
cable to the negative (S) terminal of the
battery to be jumped. A spark may cause
an explosion of the gases that surround
the battery.
File:12cprea.ex
Update:Tue Aug 29 17:46:27 1995
Page 266 of 353
288 [SV20375()08/95]Always dispose of used automotive fluids in a
responsible manner. Follow your community's
regulations and standards for recycling and
disposing of automotive fluids.
[SV20400()08/95]
Coolant refill capacity
[SV20425()08/95]
To find out how much fluid your vehicle's
cooling system can hold, seeRefill capacities for
fluidsin the Index.
[SV20450()08/95]
Have your dealer check the engine cooling
system for leaks if you have to add more than a
quart (liter) of engine coolant per month.
[SV20475()08/95]
Severe winter climate
[SV20490()08/95]
If you drive in extremely cold climates (less than
-34ÊF [-36ÊC]), it may benecessary to increase
the coolant concentration above 50%. Refer to
the chart on the coolant container to ensure the
coolant concentration in your vehicle is such that
the coolant will not freeze at the temperature
level in which you drive during winter months.
Never increase the engine coolant concentration
above 60%. Leave a 50/50 mixture of engine
coolant and water in your vehicle year-round in
non-extreme climates.
%*
[SV20500(ALL)08/95]
Checking Hoses
*
[SV20600(ALL)10/89]
Inspect all engine and heater system hoses for
deterioration, leaks and loose clamps before
adding or replacing engine coolant. Make
whatever repairs or replacements that are
necessary using Motorcraft parts or their
equivalents.
File:15cpsva.ex
Update:Tue Aug 29 17:51:51 1995
Page 268 of 353
290 [SV22000(ALL)03/91]3. Turn the heater (temperature and mode
selection) knobs to maximum heat positions
and operate the engine at fast idle
(approximately 2000 RPM) for three to four
minutes.
*
[SV22200(ALL)05/95]
4. Shut off the engine and allow the engine to
cool. Cover the radiator cap with a thick
cloth and cautiously remove it. Step back
while the pressure releases.
[SV22300(ALL)05/89]
5. Add the engine coolant mixture to a level
approximately 1 to 1 1/2 inches (38 mm)
below the filler neck seat.
[SV22400(ALL)05/89]
6. Reinstall the radiator cap fully and back off
to the first stop. Once again, turn the engine
at fast idle until the upper radiator hose is
warm and the thermostat is open.
[SV22550(ALL)05/89]
7. Finally, check the radiator and add more
engine coolant if needed, following the
procedures noted above. Reinstall the
radiator cap securely, when finished.
[SV22555(ALL)05/95]
8. If more engine coolant is necessary, remove
the small plug from the top of the engine
coolant recovery reservoir (not the large cap
of the windshield washer reservoir) and add
1.1 quarts (1 liter) of the 50/50 engine
coolant mixture. Replace the plug in its
original position.
*
[SV22565(ALL)08/95]
NOTE: Due to air being trapped in the 4.0L
engine cooling system, it is not
unusual to experiencea4to7ounce
(120 to 210 ml) coolant loss up to 7,500
miles (12,000 km) after initial system
fill.
File:15cpsva.ex
Update:Tue Aug 29 17:51:51 1995
Page 332 of 353
Index 359
Index
A
Accessory position on the ignition..... 61
Additives, engine oil.......... 282
Air bag supplemental restraint system . . . 26
and child safety seats.......... 34
description............. 26,28
disposal................ 32
driver air bag........... 26,28
indicator light............. 81
operation............... 28
proper seating............. 27
service and information labels...... 28
tone generator............. 31
wearing safety belts........... 27
Air cleaner filter
location............... 269
specifications............. 337
Air conditioning
auxiliary heater and air conditioner . . . 98
manual heating and air conditioning
system............... 92
Alcohol, in fuel............. 277
Antenna, radio
(see Electronic sound system) . . . 149, 182
Antifreeze (see Engine coolant)...... 284
Anti-lock brake system (ABS)
description.............. 193
see also Brake............ 193
Appeals (see Dispute settlement board) . . 248
Assistance (see Customer assistance) . . . 245
Audio system
(see Electronic sound system)..... 149
Autolamp system (see Headlamps) . . 102, 104
File:cpixa.ex
Update:Tue Aug 29 17:47:05 1995
Page 338 of 353
Index 365
Electronic stereo cassette radio
(see Electronic sound system)..... 175
Electronic stereo radio
(see Electronic sound system)..... 174
Emergencies, roadside
assistance.............. 245
battery acid spills.........225, 306
fuel................. 278
jump-starting............. 225
towing................ 243
Emergency brake (parking brake)..... 197
Emission control system......... 331
catalytic converter.......... 331
emissions warranty......... 4,331
Engine
check engine warning light....... 78
does not start............. 69
fuel injected engine, starting....... 63
fuel pump shut-off switch........ 69
preparing to start............ 64
refill capacities............ 335
service points............ 269
starting.............. 61,64
starting after a collision......... 69
storing your vehicle.......... 343
Engine block heater............ 68
Engine coolant............. 284
checking and adding......... 284
checking hoses............ 288
disposal............... 288
drain and flush............ 289
preparing for storage......... 344
proper solution............ 286
recovery reservoir........269, 284
refill capacities............ 335
refill procedure............ 289
specifications............. 338
temperature gauge........... 85
File:cpixa.ex
Update:Tue Aug 29 17:47:05 1995
Page 342 of 353
Index 369
H
Hazard flashers............. 113
Headlamps
aiming................ 322
autolamp system........... 102
checking alignment.......... 323
cleaning............... 102
daytime running lights........ 104
flashing............... 110
high beam.............. 110
replacing bulbs............ 322
turning on and off.......... 101
warning chime............. 84
Heating
heating and air conditioning system . . . 92
rear seat controls............ 98
standard heater system......... 95
High beams.............. 110
indicator light............. 84
operation............101, 110
High-mount brakelamp, description.... 106
Hitch................. 218
Hood................. 268
latch location............. 268
lubrication specifications........ 338
release lever............. 268
working under the hood....... 266
Horn.................. 114
Hoses, checking............. 288
I
Identification Number, Vehicle (VIN).... 5
Idle
relearning.............. 305
speed................. 67
Ignition
chime................. 62
positions of the ignition......... 61
removing the key............ 62
File:cpixa.ex
Update:Tue Aug 29 17:47:05 1995