adding oil FORD ASPIRE 1996 1.G Owners Manual
[x] Cancel search | Manufacturer: FORD, Model Year: 1996, Model line: ASPIRE, Model: FORD ASPIRE 1996 1.GPages: 268, PDF Size: 2.2 MB
Page 63 of 268
61
*
[LG03615(ALL)02/95]
Engine Oil Pressure Warning Light
[LG03715(ALL)07/93]
This light indicates low oil pressure, not low oil
level. However, if the engine's oil level is low, it
could affect the oil pressure. This light comes on
every time the ignition key is turned to ON or
START, but it normally turns off when the
engine starts.
[LG03800(ALL)05/93]
one inch art:0030173-C
Engine oil pressure light
[LG03900(ALL)02/95]
If the light stays on or turns on while the engine
is running:
*
[LG04000(ALL)03/95]
1. Pull off the road as soon as safely possible.
[LG04100(ALL)03/94]
2.Shut off the engine immediately.Continued
operation could cause severe engine damage.
[LG04200(ALL)02/95]
3. Check the engine oil level. Make sure the car
is on level ground.
[LG04300(ALL)07/93]
4. Add oil to the full mark on the dipstick
before you drive your car again. Do not
overfill. Do not operate the engine when the
oil light is on. For more information about
adding oil, seeEngine oil recommendationsin
the Index.
[LG04350(ALL)05/95]
RWARNING
Do not rely on the oil light to tell you
when the oil is low. Have the oil checked
often. It is possible for damage to occur if
an engine is operated with a low oil level.
File:05iclgf.ex
Update:Wed Jan 24 14:32:51 1996
Page 187 of 268
188
*
[SV13775(ALL)01/95]
Checking and Adding Engine Oil
*
[SV13800(ALL)03/95]
Since the proper amount of engine oil is
important for safe engine operation, check the oil
using the dipstick each time you put fuel in
your vehicle. Remember the engine must be off,
the oil must be warm and the vehicle must be
parked on level ground.
*
[SV13900(ALL)04/95]
Checking the engine oil level:
*
[SV14000(ALL)02/95]
1. Turn the engine off after it has warmed up
and allow a few minutes for the engine oil
to drain back into the oil pan.
[SV14050(ALL)04/95]
2. Set the parking brake fully and make sure
the gearshift is securely latched in P (Park)
or 1 (First).
*
[SV14100(ALL)02/95]
3. Open the hood. Protect yourself from engine
heat.
[SV14200(ALL)03/95]
4. Locate the dipstick (highlighted in yellow)
and carefully pull it out of the engine.
[SV14300(ALL)05/93]
5. Wipe the dipstick clean and put it back into
position, making sure it is fully seated.
[SV14400(ALL)07/93]
quarter page art:0032227-B
Engine oil dipstick
[SV14500(ALL)02/95]
6. Carefully pull the dipstick out again. If the
oil level is at or below the ªLº line, add
engine oil as necessary. If the oil level is
beyond the letter ªFº, engine damage or
high oil consumption may occur and some
oil must be removed from the engine.
File:15icsvf.ex
Update:Wed Jan 24 14:56:41 1996
Page 188 of 268
189 [SV14550(ALL)12/93]
NOTE: The distance between the L (low) and
F (full) marks on the dipstick
represents 1.0 liter (1.06 U.S. qts and
0.88 Imp. qts).
*
[SV14600(ALL)01/95]
7. Put the dipstick back in and make sure it is
fully seated.
*
[SV14800(ALL)01/95]
It may be necessary to add some oil between oil
changes. Make sure you use a CERTIFIED
engine oil of the preferred viscosity. Your
vehicle's warranty coverage may not apply if
engine damage is caused by the use of improper
engine oil.
*
[SV15000(ALL)03/95]
Add engine oil through the oil filler cap
highlighted in yellow. To add oil, remove the
filler cap and use a funnel to pour oil into the
opening. Be careful not to overfill the engine.
Recheck the oil level after you finish adding oil.
*
[SV16300(ALL)06/95]
Changing the Engine Oil and the Oil Filter
*
[SV16400(ALL)04/95]
Change the engine oil and oil filterper the
following, whichever occurs first.
*
[SV16500(ALL)04/95]
one third page art:0060618-C
Oil change intervals
*
[SV16600(ALL)06/95]
Refer to theMaintenance Schedule and Record
booklet for additional information.
File:15icsvf.ex
Update:Wed Jan 24 14:56:41 1996
Page 206 of 268
207 %
*
[SV29530(ALL)04/95]
Cleaning the Wheels
*
[SV29535(ALL)05/95]
Wash the wheels with the same detergent you
use to wash your vehicle's body. Do not use
acid-based wheel cleaners, steel wool, abrasives,
fuel, or strong detergents. These substances will
damage protective coatings. Use tar and road oil
remover to remove grease and tar.
[SV29540(ALL)05/95]
NOTE: Before going to a car wash, find out if
the brushes are abrasive.
*
[SV29610(ALL)05/95]
Battery
*
[SV29612(ALL)02/95]
The Motorcraft maintenance-free battery does
not require additional water during its life of
service. The vents are part of the cover and
cannot be removed. For longer, trouble-free
operation, keep the top of the battery clean and
dry. Also, make certain the battery cables are
tightly fastened to the battery terminals.
*
[SV29614(ALL)02/95]
If you see any corrosion on the battery cables or
terminals, remove the cables from the terminal
and clean them both with a wire brush. You can
neutralize the acid with a solution of baking
soda and water. Reinstall the cables when you
are done cleaning them, and apply a small
quantity of grease to the top of each battery
terminal to help prevent corrosion.
*
[SV29616(ALL)07/95]
Battery replacement
[SV29620(ALL)09/93]
If the original equipment battery requires
replacement (under warranty), it may be
replaced by a Motorcraft Low-Maintenance
battery.
[SV29625(ALL)04/95]
The Low-Maintenance battery has removable
vent caps for checking the electrolyte level and
adding water, if necessary. The electrolyte level
should be checked at least every 24 months or
24,000 miles (40,000 km) in temperatures up to
File:15icsvf.ex
Update:Wed Jan 24 14:56:41 1996