fuses FORD ASPIRE 1996 1.G Owners Manual
[x] Cancel search | Manufacturer: FORD, Model Year: 1996, Model line: ASPIRE, Model: FORD ASPIRE 1996 1.GPages: 268, PDF Size: 2.2 MB
Page 26 of 268
24 %
*
[SR13500(ALL)05/95]
The air bag system uses a readiness light on the
instrument cluster and a tone to indicate the
condition of the system. When you turn the
ignition key to the ON position, this light will
illuminate for approximately six (6) seconds and
then turn off. This indicates that the system is
operating normally. NOTE: Maintenance of the
air bag system is not required.
%*
[SR13700(ALL)06/95]
A problem with the system is indicated by one
or more of the following:
*
[SR13800(ALL)06/95]
q
the readiness light will either flash or stay lit,
*
[SR13900(ALL)06/95]
q
or it will not light immediately after ignition
is turned on,
*
[SR14000(ALL)06/95]
q
or a group of five beeps will be heard. The
tone pattern will repeat periodically until the
problem and light are repaired.
*
[SR14100(ALL)07/95]
If any of these things happen, have the air bag
system serviced at your Ford or Lincoln-Mercury
dealer immediately. Unless serviced, the air bag
Supplemental Restraint System may not function
properly in the event of a collision.
*
[SR14400(ALL)05/95]
RWARNING
Do not attempt to service, repair, or
modify the Air Bag Supplemental
Restraint System or its fuses. See your
Ford or Lincoln-Mercury dealer.
%*
[SR15225(ALL)05/95]
Disposal of air bags or air bag equipped
vehicles
*
[SR15240(ALL)06/95]
For disposal of air bags or air bag equipped
vehicles, see your local Ford or Lincoln-Mercury
dealer. Air bagsMUSTbe disposed of by
qualified personnel.
File:03icsrf.ex
Update:Wed Jan 24 14:30:01 1996
Page 47 of 268
45
*
[ST02820(ALL)06/93]
3. Push and hold the thumb button.
[ST02830(ALL)09/93]
4. Move the gearshift lever.
*
[ST02832(ALL)07/95]
If you need to shift out of P (Park) by using the
alternate procedure described above, it is
possible that a fuse has blown and that your
brakelamps may also not be functional. Please
refer to the chapter titledServicing Your Aspirein
this Owner Guide for instructions on checking
and replacing fuses.
*
[ST02835(ALL)05/95]
RWARNING
DO NOT DRIVE YOUR VEHICLE UNTIL
YOU VERIFY THAT THE BRAKELAMPS
ARE WORKING.
%*
[ST02850(ALL)03/95]
Ignition Key Chime
*
[ST02875(ALL)10/90]
If the driver or passenger door is open while the
key is still in the ignition, a warning chime
sounds.
%*
[ST02900(ALL)02/95]
Removing the Key From the Ignition
*
[ST03000(ALL)09/93]
1. Put the gearshift selector lever in P (Park)
(automatic transaxle) or 1 (First) (manual
transaxle).
*
[ST03100(ALL)01/95]
2. Set the parking brake fully.
[ST03450(ALL)12/93]
3. Push the key in (manual transaxle) and turn
it to the LOCK position.
*
[ST03500(ALL)03/95]
4. Remove the key.
*
[ST03700(ALL)06/95]
RWARNING
Always set the parking brake fully and
make sure that the gearshift is securely
latched in P (Park) (automatic transaxle) or
in 1 (First) (manual transaxle).
File:04icstf.ex
Update:Wed Jan 24 14:30:41 1996
Page 214 of 268
215 [SV33500(ALL)07/93]
one third page art:0032225-B
Where to check the power steering fluid
[SV33600(ALL)07/93]
5. If the power steering fluid is low, add fluid
in small amounts, continuously checking the
level, until you reach the F (Full) line. Do
not overfill.
*
[SV34000(ALL)01/95]
If the power steering fluid is low, do not drive
your vehicle for a long period of time before
adding fluid. This can damage the power
steering pump.
*
[SV34200(ALL)01/94]
If you must check the power steering fluid
before it reaches normal operating temperature,
make sure that the fluid reaches the ªLº (or
LOW) line range in the reservoir. The reading
will only be accurate if the fluid temperature is
approximately 70Ê to100ÊF (21Ê to 38ÊC).
[SV34300(ALL)07/95]Fuses
[SV34400(ALL)07/93]
Fuses protect your vehicle's electrical system
from overloading. If electrical parts in your
vehicle are not working, the system may have
been overloaded and blown a fuse. Before you
replace or repair any electrical parts, check the
appropriate circuit protectors.
File:15icsvf.ex
Update:Wed Jan 24 14:56:41 1996
Page 215 of 268
216 [SV34500(ALL)07/93]The following charts tell you which fuses protect
each electrical part of your vehicle. If a fuse
blows, all the parts of your car that use the
circuit will not work.
[SV34600(ALL)02/95]
Once you have determined which fuses to check,
follow the procedures underChecking and
replacing fuseslater in this chapter.
[SV35370(ALL)09/93]
Your Aspire has a main fuse block under the
hood and a regular fuse box mounted in the
instrument panel behind a cover.
[SV35390(ALL)05/93]
Main fuse block
[SV35420(ALL)03/94]
If the 80 Amp. fuse is blown, it must be
replaced. To remove the main fuse block and
replace the fuse:
[SV35430(ALL)07/95]
one third page art:0032220-B
Main fuse block location
[SV35440(ALL)05/93]
1. Disconnect the negative battery cable.
[SV35460(ALL)05/93]
2. Remove the nuts on either end.
[SV35480(ALL)05/93]
3. Lift the fuse block and open the flaps on the
side of the fuse block.
[SV35520(ALL)05/93]
4. Remove the bolts on either side of the block.
[SV35540(ALL)05/93]
5. Replace the fuse with a new one of the same
rating.
File:15icsvf.ex
Update:Wed Jan 24 14:56:41 1996
Page 220 of 268
221 [SV36575(ALL)07/95]
fourteen pica chart:0032237-C
%*
[SV36600(ALL)06/95]
Checking and Replacing Fuses
[SV36800(ALL)05/95]
1. Find the fuse panel and remove the cover.
[SV36900(ALL)05/95]
2. Find the position of the fuse you want to
check.
[SV37000(ALL)05/95]
3. To remove the fuse, use the fuse puller
provided (located on the cover of the interior
fuse panel).
*
[SV37100(ALL)05/95]
quarter page art:0030248-B
Fuse puller tool and fuse
File:15icsvf.ex
Update:Wed Jan 24 14:56:41 1996
Page 221 of 268
222 [SV37200(ALL)05/95]4. Look through the transparent side of the
fuse to see if the metal wire inside is
separated. If it is, replace the fuse with one
of the same amperage only. You can use the
amp rating number on the fuse as well as
the color to identify the correct replacement.
*
[SV37300(ALL)05/95]
RWARNING
Always replace a fuse with one that has
the specified amperage rating. Using a
fuse with a higher amperage rating can
cause severe wire damage and could start
a fire.
[SV37350(ALL)05/95]
5. Reinstall the fuse puller on the inside of the
fuse panel cover.
[SV37400(ALL)05/95]
6. Install the fuse panel cover.
*
[SV37500(ALL)05/93]
Even after you replace a fuse, it will continue to
blow if you do not find what caused the
overload. If the fuse continues to blow, have
your electrical system checked.
*
[SV37525(ALL)03/94]
The following chart indicates the colors and
amperage ratings of standard fuses.
[SV37550(ALL)03/94]
twelve pica chart:0032119-AFile:15icsvf.ex
Update:Wed Jan 24 14:56:41 1996