ignition FORD C MAX 2008 1.G User Guide

Downloaded from www.Manualslib.com manuals search engine Locking the vehicle
WARNING
The vehicle does not lock itselfautomatically. If no lockingbutton is pressed, the vehicle willremain unlocked.
Note:Before leaving the vehicle,ensure that the ignition switch ispulled out. See Ignition switch(page 141).
Note:A valid passive key must belocated within the detection range ofthe respective door. If locking fromthe tailgate, the passive key must bewithin the tailgate detection range.
Note:Once activated, the vehiclewill remain locked for approximatelythree seconds, even if the passivekey is within the detection rangeduring this delay period. This is toallow you to pull a door handle andcheck if the vehicle is locked. Whenthe delay period is over, the doorscan be opened again, provided thepassive key is within the respectivedetection range. The delay periodcan be set to zero by an expert.
Note:If a passive key is left insidethe vehicle PASSIVE KEY LEFTINSIDE appears in the informationdisplay. Remove the passive keyfrom the vehicle interior. All passivekeys left inside the vehicle when it islocked will be disabled.
To activate central locking and armthe alarm:
•Press the locking button on oneof the front doors or the tailgateonce.
•On vehicles without doublelocking, the direction indicatorswill flash twice as confirmation.
To activate double locking, to armthe alarm and the interior sensors:
•Press the locking button on oneof the front doors or the tailgatetwice within three seconds.
•The direction indicators will flashtwice as confirmation.
Deactivating the key freefunction
The key free function can bedeactivated using the informationdisplay. See Information displays(page 96).
Once it is deactivated:
•the vehicle can only be lockedand unlocked using the spare keyin the lock cylinder on the driver’sdoor or using the buttons on thepassive key.
•the engine can only be startedwith the spare key.
49
LocksE78282

Downloaded from www.Manualslib.com manuals search engine GLOBAL OPENING AND
CLOSING
You can also operate the electricwindows with the ignition off via theglobal opening and global closingfunction.
Note:Global closing will only operateif you have set the memory correctlyfor each window. See Electricwindows (page 84).
Global opening
To open all the windows, press andhold the unlock button for at leastthree seconds. Press either the lockor the unlock button again to stopthe opening function.
Global closing
Vehicles without the key freesystem
WARNING
Take care when using globalclosing. In an emergency, pressa button immediately to stop.
To close all the windows, press andhold the lock button for at leastthree seconds. Press any buttonagain to stop the closing function.The anti-trap function is also activeduring global closing.
Vehicles with the key freesystem
50
LocksE71955 E71956 E78275

Downloaded from www.Manualslib.com manuals search engine PRINCIPLE OF
OPERATION
The engine immobiliser is a theftprotection system that preventssomeone from starting the enginewith an incorrectly coded key.
CODED KEYS
Note:Do not shield your keys withmetal objects. This may prevent thereceiver from recognising your keyas a valid one.
Note:Have all of your remainingkeys erased and recoded if you losea key. Ask your dealer for furtherinformation. Have replacement keysrecoded together with your existingkeys.
If you lose a key, you can obtain areplacement from your Ford Dealer.If possible, provide them with the keynumber from the tag provided withthe original keys. You can also obtainadditional keys from your FordDealer.
ARMING THE ENGINE
IMMOBILISER
The engine immobiliser is armedautomatically a short time after youhave switched the ignition off.
The indicator in the instrument clusterwill flash to confirm that the systemis operating.
DISARMING THE ENGINE
IMMOBILISER
The engine immobiliser is disarmedautomatically when you switch theignition on with a correctly coded key.
The indicator in the instrument clusterwill come on for approximately threeseconds and then go out. If theindicator stays on for one minute orflashes for approximately one minuteand then repeatedly at irregularintervals, your key has not beenrecognised. Remove the key and tryagain.
If you attempt to start the engine withan incorrectly coded key, you willneed to wait for approximately 20seconds before attempting to startthe engine again with a correctlycoded key.
If you are unable to start the enginewith a correctly coded key, thisindicates a malfunction. Have theimmobiliser checked immediately.
52
Engine immobiliser

Downloaded from www.Manualslib.com manuals search engine Vehicles without keyless entrysystem
Press the upper part of the switchnext to the driver’s door handle.
Vehicles with keyless entrysystem
Press the lower part of the switchnext to the driver’s door handle.
DISARMING THE ALARM
The anti-theft alarm system can bedeactivated at any time – even whenthe alarm is sounding – by unlockingthe vehicle from the outside.
The anti-theft alarm system for thetailgate is deactivated if the tailgateis unlocked using the button on theremote control or passive key. Onvehicles with the Key Free System, itis deactivated if a passive key islocated within the tailgate detectionrange when the tailgate is opened.
After closure, the alarm is once againarmed.
Britain and Ireland only
If the vehicle is unlocked using thekey or the spare key for the keylessentry system, a 12 second delaychime starts as soon as the driver’sdoor is opened. The alarm should bedeactivated during this period.
Vehicles without keyless entrysystem
To deactivate the alarm, insert thekey into the ignition and turn it toposition II.
Vehicles with keyless entrysystem
The alarm should be deactivated inone of the following ways:
•If a valid passive key is locatedwithin the vehicle interior, depressthe clutch pedal (manualtransmission) or brake pedal(automatic transmission), pushthe ignition switch in and turn it toposition II.
•Insert the spare key into theignition switch, push the ignitionswitch in and turn it to position II.
•Press the unlock button on thepassive key.
54
AlarmE80555 E80556

Downloaded from www.Manualslib.com manuals search engine ADJUSTING THE
STEERING WHEEL
WARNING
Never adjust the steering wheelwhen the vehicle is moving.
Note:Make sure that you are sittingin the correct position. See Sittingin the correct position (page 120).
WARNING
Make sure that you fully engagethe locking lever when returningit to its original position.
HORN
The horn can also be operated whenthe ignition is off.
AUDIO CONTROL
Select radio, CD or cassette modeon the audio unit.
The following functions can beoperated with the remote control:
55
Steering wheel122E95178 3E95179 E78023

Downloaded from www.Manualslib.com manuals search engine WARNINGS
Replace the wiper blades assoon as they begin to leavebands of water and smears or whenthey do not completely remove waterfrom the windscreen. If the bladesare not replaced, the rain sensor willcontinue to detect water on thewindscreen. This will result in thewipers continuing to operatealthough the majority of thewindscreen is dry.
In icy conditions, make sure thatthe windscreen has been fullydefrosted before selectingautowipers.
Switch off the autowipersbefore entering a car wash.
Note:The autowipers feature isintended for use during wet weatherconditions only. It should not beselected in dry weather conditionsas the system is very sensitive toobjects such as dirt, mist or flieshitting the windscreen near the rainsensor. This may cause the wipersto wipe even though the screen ismostly dry.
Note:The autowipers functionshould not be selected when it issnowing or foggy, or when the roadshave been salted. In these weatherconditions, select position A, C or D,if necessary.
When the lever is moved to positionB with the ignition switched on, thewipers will cycle once regardless ofwhether the front screen is wet ordry.
Depending on the equipment fitted,when the ignition is switched on withthe lever already in position B, thewipers will not cycle until water isdetected on the windscreen.Alternatively, move the lever toanother position and then back to B,or operate the washer.
Thereafter, the rain sensor willcontinuously measure the amount ofwater on the windscreen and adjustthe speed of the front wipersautomatically (single wipe,intermittent, normal or high speedwipe).
Low sensitivityA
High sensitivityB
A.The wipers will only wipe when alarger amount of water isdetected on the windscreen
B.The wipers will wipe even if only asmall amount of water is detectedon the windscreen.
Six settings are available from low tohigh sensitivity.
60
Wipers and washersE71015BA

Downloaded from www.Manualslib.com manuals search engine LIGHTING CONTROL
Lighting control positions
OffA
Side and tail lampsB
HeadlampsC
Front fog lampsD
Rear fog lampsE
Parking lampsF
Parking lamps
CAUTION
Prolonged use of the parkinglamps will discharge the battery.
Switch off the ignition.
Push the lighting control inwards andturn it to position F.
Main and dipped beam
Pull the lever fully towards thesteering wheel to switch betweenmain and dipped beam.
Headlamp flasher
Pull the lever slightly towards thesteering wheel.
Home safe lighting
Switch the ignition off and pull thedirection indicator lever towards thesteering wheel to switch theheadlamps on. You will hear a shorttone. The headlamps will go offautomatically after 3 minutes with anydoor open, or 30 seconds after thelast door has been closed.
With all doors closed, but within the30 second delay, opening any doorwill result in the 3 minute timerstarting again.
The home safe lights can becancelled by either pulling thedirection indicator lever towards thesteering wheel again or by turningthe ignition switch ON.
64
LightingE71094DBCAFE E71095

Downloaded from www.Manualslib.com manuals search engine INTERIOR LAMPS
Courtesy lamp
OffA
Door contactB
OnC
If you set the switch to position B, thecourtesy lamp will come on when youunlock or open a door or the luggagecompartment lid. If you leave a dooropen with the ignition switch off, thecourtesy lamp will go offautomatically after some time toprevent the vehicle battery fromdischarging. To switch it back on,switch on the ignition for a short time.
The courtesy lamp will also come onwhen you switch off the ignition. It willgo off automatically after a short timeor when you start or restart theengine.
If you set the switch to position Cwith the ignition switch off, thecourtesy lamp will come on. It will gooff automatically after a short time toprevent the vehicle battery fromdischarging. To switch it back on,switch on the ignition for a short time.
Reading lamps
If you switch off the ignition, thereading lamps will go off automaticallyafter some time to prevent thevehicle battery from discharging. Toswitch them back on, switch on theignition for a short time.
Vanity mirror lamps
OffA
OnB
72
LightingCBAE71945 E71946 ABE72900

Downloaded from www.Manualslib.com manuals search engine If you switch off the ignition, the vanitymirror lamps will go off automaticallyafter a short time to prevent thevehicle battery from discharging. Toswitch them back on, switch on theignition for a short time.
73
Lighting

Downloaded from www.Manualslib.com manuals search engine CHANGING A BULB
WARNINGS
On vehicles fitted with Xenonheadlamps, have the headlampbulbs changed by an expert. Thereis a risk of injury due to high voltage.
During operation, the bulbs andtheir surroundings get hot.Switch off the lights and let the bulbscool down before replacing them.
Always switch off lights and ignitionbefore replacing any bulb.
Never touch the glass of the bulbs.Fit only bulbs having a UV filter.Always replace a faulty bulb with anew one of the same type. Afterreplacing a bulb, check that the lightsoperate correctly.
Headlamps, side lamps,direction indicators
Note:It is necessary to remove theheadlamp assembly to remove anyof the bulbs.
Removing the headlampassembly
Open the bonnet.
Remove the screw.
WARNING
When re-installing the lampassembly, make sure that thewiring connectors and retaining clipsare engaged properly.
Press down the retaining clips at therear of the lamp assembly using ascrewdriver and carefully pull out thelamp assembly.
74
LightingE78106 E78107