change key battery FORD C MAX 2008 1.G Owners Manual

Downloaded from www.Manualslib.com manuals search engine •Press any button on a newremote control. A tone will soundas confirmation. Repeat this laststep for all your remote controls,including your original. Do notremove the key from the ignitionwhen pressing the button on thisremote control.
•Switch the ignition back on(position II) or wait for tenseconds without programminganother remote control to end thekey programming. Only theremote controls which you havejust programmed are now able tolock and unlock the vehicle.
Reprogramming theunlocking function
You can change the unlockingfunction so that pressing the unlockbutton once deactivates the centrallocking or double locking, disarmsthe anti-theft alarm system andunlocks only the driver’s door.Pressing the unlock button twicewithin three seconds also unlocks thepassengers’ doors.
In order to re-programme thefunction, press and hold the unlockand lock buttons simultaneously forat least four seconds with the ignitionswitched off. The direction indicatorswill flash twice to indicate that theunlocking function has beensuccessfully re-programmed.
Pressing and holding both buttonssimultaneously for at least fourseconds again will change thefunction back.
CHANGING THE REMOTE
CONTROL BATTERY
If the range of the transmitter in theremote control decreases gradually,the battery (type 3V CR 2032) shouldbe replaced.
Remote control type 1
First, press the button to release thekey blade.
Passive key
Remove the spare key.
36
Keys and remote controlsE78255

Downloaded from www.Manualslib.com manuals search engine During starting, the fuel injectors areturned off as long as the acceleratorpedal is depressed. This can be usedto drain excessive fuel from theintake manifold after severalunsuccessful starting attempts.
If the battery has been disconnectedor after the fuel type has beenchanged, the idle speed may beirregular. This will improve after 10 to30 seconds.
Vehicles with the key freesystem
Vehicles with a manualtransmission
Note:If the clutch pedal is notdepressed, a message appears inthe information display.
Depress the clutch pedal.
Vehicles with an automatictransmission
Note:If the brake pedal is notdepressed, a message appears inthe information display.
Depress the brake pedal.
All vehicles
Push the ignition switch in and turn itto switch on the ignition and to startthe engine.
Once the system recognizes apassive key, the engine can bestarted. If no passive key is detected,PASSIVE KEY NOT DETECTEDwill appear in the information display.
STARTING A DIESEL
ENGINE
Cold/hot engine
Depress the clutch pedal withouttouching the accelerator.
Turn the key to position IIand ensure the glow plugindicator lamp illuminates.
Wait until the lamp extinguishesbefore starting and continue crankingwithout pausing until the enginestarts.
If the engine stalls, repeat the fullstarting procedure.
144
Starting the engineE87381