Rear seat FORD C MAX 2011 2.G Owner's Manual

Downloaded from www.Manualslib.com manuals search engine 3. Fold the seat back until it engages.
Note:
As the seats slide rearwards, they
also move slightly inboard.
4. Pull the lever on the outer front edge of the outboard seats and push the
seats rearwards.
To return the seats to the forward position,
pull the lever and slide the seats forwards.
To return the centre seat to its original
position, pull the lever on the underside of
the seat. Fold the centre seat forwards and
push it back down fully until it engages.
Install the luggage cover. See Luggage
Covers (page 163).
Folding the seatbacks down WARNING
Do not place hot drinks in the cup
holders when the vehicle is moving.
Note:
All three seatbacks can be folded
forward independently of one another.
Note: A table surface and cup holders are
located on the rear of the centre seatback. Remove the seat belts from the belt guides
on the outboard seatbacks. The seat belt
tongues must be inserted into the retaining
slots. See Fastening the seat belts
(page 29).
Pull the lever on the side of the seatback
and fold the seatback forwards. Push it
down until it engages.
113
SeatsE78064 E78066 E135599

Downloaded from www.Manualslib.com manuals search engine Folding the seatbacks up
WARNING
Make sure the seatback is fully
engaged in its latch.
Note:
When in use, the rear seat belts
should be placed in the belt guides on the
outboard seatbacks. See Fastening the
seat belts (page 29). Pull the lever on the seatback and lift the
seatback up.
Folding the seats forward
Note:
To increase the space in the luggage
compartment, the rear seats can be folded
forward.
Note: All three seats can be folded forward
independently of one another.
Note: If one or both outboard seats is to be
folded forward together with the centre
seat, fold the centre seat forward first. Note:
If only the outboard seats are to be
folded forward, the centre seatback must
be left in the upright position.
Fold the seatback down. See Folding the
seatbacks down. Pull the lower bar on the rear of the seats
to release them from the floor and fold the
seats forward.
WARNING
Always attach the retaining strap to
the front head restraint when a rear
seat is folded forwards.
114
SeatsE135808 E135956 E135957221

Downloaded from www.Manualslib.com manuals search engine Pull out and attach the retaining straps to
the front head restraints to hold the folded
seats in the upright position.
Returning the seats to the seating
position
WARNINGS
To avoid injury, take care when
folding the seats down.
Make sure that the locking hole on
the floor is clear of sand, rock or any
objects which may prevent the seat
from locking. When the retaining strap is detached
from the head restraint, it will recoil
back into the seat.
Note:
If one or both outboard seats are
folded forward together with the centre
seat, the outboard seats must be folded
back down first. Before folding the seats back down, pull
the lower bar on the rear of each seat and
check that the latches are in the extended
position.
Detach the retaining straps.
WARNING
Make sure the seat is securely locked
by pushing forward and rearward on
the top of the seatback or by trying
to pull up the edge of the cushion. 115
SeatsE78071 E78073X E78074121

Downloaded from www.Manualslib.com manuals search engine Fold the seats back down until they
engage.
Raise the seatbacks. See Folding the
seatbacks up.
Install the rear seatbelts in the belt guides
on the outboard seatbacks.
Removing the seats
WARNING
The rear seats are heavy. To avoid
injury, take care when lifting the
seats.
Note:
To increase the space in the luggage
compartment, the rear seats can be
removed completely.
1. Fold the seat forward. See Folding the
seats forward. 2. Fold the seat up to an angle of
approximately 45 degrees to the floor. 3.
Push down both red levers to open the
locking mechanism.
4. Remove the seat.
Installing the seats WARNINGS
To avoid injury, take care when
folding the seats down.
Make sure that the locking hole on
the floor is clear of sand, rock or any
objects which may prevent the seat
from locking. Note:
Make sure the locking mechanism is
fully open.
116
SeatsE78076 E78075

Downloaded from www.Manualslib.com manuals search engine Holding the seat at an angle of
approximately 45 degrees to the floor,
lower the seat onto the retaining bar.
Before folding the seats back down, pull
the lower bar on the rear of each seat and
check that the latches are in the extended
position.
Push the seat back down until it engages. Second row seats - Grand C-MAX
Folding the seatback forwards or
backwards
Lift the lever and push the seatback. It will
move in steps.
Stowing the centre seat
WARNING
Make sure the centre seat back is in
the upright position when the vehicle
is moving.
Note:
You can use the space between the
outboard seats to access the third row seats
when the centre seat has been stowed. 117
SeatsE78077 E78073X E135422 E129302

Downloaded from www.Manualslib.com manuals search engine 1. Pull the strap and lift the cushion.
2. Lift the lever and push the seatback
down until it locks.
Easy entry position WARNING
Do not use the seat when it is in the
easy entry position.
Note:
You can move the outboard seats
forwards to allow access to the third row
seats. 1. Either pull the lever on the side of the
seat cushion or pull the strap at the
rear of the seat. The seat will move
forward.
2. Fold the seatback forward.
Third row seats - Grand C-MAX
Note: Remove the luggage cover. See
Luggage Covers (page 163).
Note: When not in use, the seat belts
should be placed in the clips on the
outboard trim. See Fastening the seat
belts (page 29).
Folding the seats flat CAUTIONS
When transporting a load with the
seats folded flat, fold the relevant
carpet forwards to cover the folded
seat back. Do not place heavy objects in the area
marked on the carpet.
119
SeatsE129298 E129296

Downloaded from www.Manualslib.com manuals search engine Seat back trays
WARNING
Do not use the trays when the vehicle
is moving. Make sure that you secure
the trays in the lowered position
before setting off. STORAGE COMPARTMENTS
Rear storage compartment GLASSES HOLDER
124
Convenience featuresE72630 E72982 E75193 E91508

Downloaded from www.Manualslib.com manuals search engine GENERAL INFORMATION
WARNINGS
Use load securing straps to an
approved standard, e.g. DIN.
Make sure that you secure all loose
items properly.
Place luggage and other loads as low
and as far forward as possible within
the luggage or loadspace.
Do not drive with the tailgate or rear
door open. Exhaust fumes may enter
the vehicle.
Do not exceed the maximum front
and rear axle loads for your vehicle.
See Vehicle Identification Plate
(page 214). Heavy loads, when placed in the
passenger compartment, should be
on or behind folded rear seats as
shown. See Rear Seats (page 112). CAUTION
Do not allow items to contact the rear
windows. C-Max
Grand C-Max
LUGGAGE ANCHOR POINTS
Note:
Item D is available only on vehicles
with a tyre repair kit.
161
Load CarryingE98627 E97377

Downloaded from www.Manualslib.com manuals search engine LUGGAGE COVERS
WARNING
Do not place objects on the luggage
cover.
Pull out the cover and secure it in the
retaining points.
Release it from the retaining points and let
it roll back into the case. Clip the retaining
hook onto the case.
To remove or install the cover, push either
end of the case inwards. REAR UNDER FLOOR
STORAGE WARNING
When you are using a child restraint
with a support leg on a second row
seat, make sure that you locate the
support leg securely on the under floor
storage compartment lid. Make sure that
you install the foam spacer correctly inside
the storage compartment and that you
position the lid correctly. CARGO NETS
C-MAX
WARNING
Luggage retention net anchor points
are not fitted behind the first or
second row seats.
163
Load CarryingE72969 E72970 E78097

Downloaded from www.Manualslib.com manuals search engine Grand C-MAX
WARNING
Luggage retention net anchor points
are not fitted behind the first row
seats, but are fitted behind the
second row seats. Luggage retention net
Installing the net
CAUTIONS
Do not move the rear seats when the
cargo net is installed.
Do not use the cargo net if the third
row seats are in use.
1.
Push the ends of the upper bar towards
each other and insert them into the
retainers on the roof. Push the bar
forwards into the narrow section of the
retainers. Note:
Make sure the centre seat is upright.
Note: Only install the cargo net behind the
rear seats.
2. Attach the net to the luggage anchor points. See Luggage Anchor Points
(page 161). 3. Tighten the belts.
164
Load CarryingE87052 E130320 E130321