stop start FORD CONTOUR 1997 2.G User Guide

Maintenance and Care
219
%*
[MC32300(ALL)03/96
]
How to Prepare Your Vehicle for
Inspection/Maintenance (I/M) Testing
*
[MC32400(ALL)05/96]
In some localities it may become a legal requirement to pass an
Inspection/Maintenance (I/M) test of the On-Board Diagnostic
(OBD) II system. If the vehicle's powertrain system or its battery
has just been serviced, the OBD II system is reset to a not ready
for I/M testing condition. To prepare for I/M testing, the law
specifies that additional mixed city and highway driving is
required to complete the check of the OBD II system.
*
[MC32500(ALL)05/96]
OBD II Drive Cycle
*
[MC32601(ALL)05/96]
The driving modes required to reach the ready condition consist
of a minimum of 30 minutes of city and highway driving as
described below:
*
[MC32701(ALL)05/96]
n
At least twenty minutes driving in stop and go, city type
traffic with at least four idle periods.
*
[MC32801(ALL)05/96]
n
At least ten minutes of driving on an expressway or
highway.
*
[MC32901(ALL)05/96]
Before completing the above driving modes, the engine must be
warmed up and at operating temperature. Once started, the
vehicle must not be turned off during these driving modes.
%*
[MC34300(ALL)03/96]
Lights and Bulb Replacement
*
[MC34400(ALL)01/96]
It is a good idea to check the operation of the following lights
frequently:
*
[MC34500(ALL)01/96]
n
headlamps
*
[MC34600(ALL)01/96]
n
tail lamps
*
[MC34700(ALL)01/96]
n
brakelamps
*
[MC34800(ALL)01/96]
n
high-mount brakelamp
*
[MC34900(ALL)01/96]
n
hazard flasher
File:11cdmco.ex
Update:Thu Sep 12 11:08:18 1996