key FORD CONTOUR 1997 2.G Owners Manual

14
%*
[IS03100(ALL)01/96]
Charging System Light
*
[IS03200(ALL)01/96]
This light indicates that your battery is not being charged and
that you need to have the electrical system checked.
[IS03300(ALL)12/95]
6 pica art:0000293-C*
[IS03400(ALL)03/96]
This light illuminates every time you turn the ignition to the
ON or START position (engine off). The light should go off
when the engine starts and the alternator begins to charge.
*
[IS03500(ALL)03/96]
If the light stays on or illuminates when the engine is running,
have the electrical system checked as soon as possible.
%*
[IS03600(ALL)01/96]
Engine Oil Pressure Warning Light
*
[IS03700(ALL)12/95]
This light indicates the engine's oil pressure, not the oil level.
However, if your engine's oil level is low, it could affect the oil
pressure. The light will come on briefly when you turn your
key to the START and ON position. The light should stay off
when the engine is running with normal oil pressure. If the
light comes on while the engine is running, you have lost oil
pressure and continued operation will cause severe engine
damage.
[IS03800(ALL)12/95]
6 pica art:0000294-BFile:03cdiso.ex
Update:Thu Sep 12 10:58:17 1996

16
[IS04600(ALL)12/95]
6 pica art:0000295-B*
[IS04700(ALL)08/95]
Chime for Headlamps On
[IS04800(ALL)12/95]
This chime sounds if the driver's door is open when the parking
lamps or headlamps are on. The chime sounds until you close
the door or turn off the lamps.
%*
[IS04900(ALL)03/96]
Air Bag Readiness Light
*
[IS05000(ALL)03/96]
The air bag supplemental restraint system uses a readiness light
and a tone to indicate the condition of the system. The
readiness light is in the instrument cluster. When you turn the
ignition key to ON, this light will illuminate for approximately
six (6) seconds and then turn off. This indicates that the system
is operating normally.NOTE:Maintenance of the air bag system
is not required.
[IS05100(ALL)12/95]
A problem with the system is indicated by one or more of the
following: the readiness light will either flash or stay lit, or it
will not light or a group of five beeps will be heard.
*
[IS05200(ALL)03/96]
RWARNING
If any of these things happen, even intermittently, have
the air bag system serviced at your Ford or
Lincoln-Mercury dealer immediately.
File:03cdiso.ex
Update:Thu Sep 12 10:58:17 1996

18
%*
[IS05400(ALL)03/96]
Check Engine Warning Light
[IS05501(ALL)04/96]
This light illuminates when the engine's Emission Control
System requires service. It will also illuminate when the ignition
key is in the ON position and the engine is off.
[IS05700(ALL)12/95]
6 pica art:0000640-B[IS06500(ALL)12/95]
Overdrive Off Indicator (Automatic Transaxle Only)
[IS06600(ALL)12/95]
This light tells you that the Transaxle Control Switch (TCS) on
the gearshift lever has been pushed. When the light is on, the
transaxle will not shift into overdrive. Depressing the TCS
button located below the gearshift release button on the shifter
will return the vehicle to ªoverdrive onº mode. The transaxle
will be in the ªoverdrive onº mode when the vehicle is started
even if the O/D OFF mode was selected when the vehicle was
last shut off.
[IS06700(ALL)12/95]
If the light does not come on when the TCS is depressed or if
the light flashes when you are driving, have your vehicle
serviced at the first opportunity.
[IS06800(ALL)02/96]
6 pica art:0001211-BFile:03cdiso.ex
Update:Thu Sep 12 10:58:17 1996

Electronic Sound Systems
31
*
[AS07750(ALL)10/95]
How to stop and restart the CD player
*
[AS07800(ALL)02/96]
When a disc is loaded, the unit automatically enters the play
mode and the play indicator (
a) illuminates. To stop
temporarily, press the ªPLAY/STOPº button or the ªAM/FMº
button. The stop indicator (
X) in the display illuminates and
operation returns to the radio mode. To resume CD play, press
the ªPLAY/STOPº button once again.
*
[AS07850(ALL)10/95]
NOTE: If the ignition key is turned OFF during play and
then is set to the ON or ACCESSORY position, the
CD player will resume playing in the mode it was in
when ignition was turned off.
*
[AS07860(ALL)03/95]
How to locate a selection on your CD player using
Automatic Music Search (AMS)
*
[AS07880(ALL)06/95]
An ªAMSº (Automatic Music Search) control on your CD player
allows you to quickly find a particular selection on the disc.
Press the left
fside of the ªAMSº control to locate a
previous selection or the right
eside of the ªAMSº control
to locate a later selection.
*
[AS07900(ALL)10/95]
How to fast forward or reverse your CD player
[AS07950(ALL)05/95]
To quickly search for a particular point in a selection, press the
right
ebutton (to fast forward) or the left
fbutton (to
reverse). While either button is pressed, the disc goes forward
or backward at two different speeds depending on how long the
button is held down. (Pressing either button for more than
approximately three seconds will speed up the process.) Release
the button at the desired point (found by watching the elapsed
playing time in the display or listening to the sound during fast
forward or reverse).
*
[AS08000(ALL)06/95]
When you have reached the end of the disc by keeping the fast
forward
eside of the button pressed, the display will show
the end time of the last track and the sound will be muted.
When the fast forward
eside of the button is released, the
player resumes play at the beginning of the first track.
File:04cdaso.ex
Update:Thu Sep 12 10:59:17 1996

47
Controls and Features
%*
[CF00200(ALL)03/96]
The Climate Control Systems
[CF00300(ALL)12/95]
Your vehicle has one of the following:
[CF00400(ALL)12/95]
n
Heating Only System (Without Air Conditioning)
[CF00500(ALL)04/96]
n
Heating and Air Conditioning System
*
[CF00600(ALL)12/95]
If you are not sure which system your vehicle has, see the
diagrams on the following pages.
[CF00700(ALL)12/95]
Heating Only System
[CF00800(ALL)12/95]
The control for your heater system is located at the center of the
instrument panel below the radio. The heater will operate only
when the ignition key is turned to the ON position. Your heater
will heat and/or ventilate your vehicle interior depending on
the function selector knob position and temperature you select.
The function selector knob allows you to select heating or
ventilation and determine where the air will be directed. The
temperature control knob setting determines the temperature of
the air that flows into the vehicle.
[CF00900(O )05/96]
10-1/2 pica
art:0001181-C
The control for the heating only system
[CF01100(ALL)12/95]
To turn your heater system on, select any position except OFF.
This will turn the fan on and allow air flow into the vehicle. To
turn your heater off, select OFF. This will turn the fan off and
stop air flow from coming into the vehicle.
File:05cdcfo.ex
Update:Fri Sep 13 08:48:17 1996

Controls and Features
51
[CF04300(ALL)12/95]
Passenger Compartment Air Filter (if equipped)
[CF04400(ALL)04/96]
Your vehicle may have an air filter that removes pollen and
road dust from outside air before it is directed to the interior of
the vehicle. For maintenance of this filter, see theMaintenance
and Carechapter.
% [CF04500(ALL)03/96]
Rear Window Defroster (If equipped)
[CF04600(ALL)04/96]
The defroster for the rear window clears frost, fog, or thin ice
from both the inside and outside of the rear window.
[CF04700(ALL)12/95]
The button for the rear window defroster is on the instrument
panel, to the right of the steering wheel.
[CF04800(ALL)12/95]
6 pica art:0001180-C
The rear window defroster and heated side view mirrors
[CF04900(ALL)12/95]
Clear away any snow that is on the rear window before using
the defroster. With the engine running, push the defroster
button.
*
[CF05000(ALL)01/96]
After approximately 10 minutes, the defroster will turn off. If
the window is still not clear, turn the defroster on again.
*
[CF05100(ALL)01/96]
The defroster will turn off when the ignition key is turned to
the OFF or START position.
File:05cdcfo.ex
Update:Fri Sep 13 08:48:17 1996

56
*
[CF09100(ALL)01/96]
Ignition
%*
[CF09200(ALL)01/96]
Understanding the Positions of the Ignition
[CF09300(ALL)12/95]
10-1/2 pica
art:0001185-D
The positions of the key in the ignition
[CF09400(ALL)12/95]
LOCK and ACCESSORY lock the gearshift for all vehicles with
an automatic transaxle.
*
[CF09500(ALL)01/96]
RWARNING
LOCK position does not lock the gearshift on
floor-mounted manual transaxle gearshifts. If the parking
brake is not set and the gearshift is moved out of gear,
your vehicle may move unexpectedly and injure someone.
*
[CF09600(ALL)12/95]
The automatic transaxle gearshift must be in P (Park) to move
the key to the LOCK position.
*
[CF09700(ALL)01/96]
LOCK is the only position that allows you to remove the key.
The LOCK feature helps to protect your vehicle from theft.
*
[CF09800(ALL)01/96]
If your key is stuck in the LOCK position and will not turn,
move your steering wheel left or right until the key turns freely.
File:05cdcfo.ex
Update:Fri Sep 13 08:48:17 1996

Controls and Features
57
[CF09900(ALL)12/95]
ACCESSORY allows some of your vehicle's electrical accessories
to operate while the engine is not running. For example, you
can use ACCESSORY to turn on the radio without starting the
engine.
*
[CF10000(ALL)01/96]
ON allows you to test your vehicle's warning lights (except the
brake system warning light) to make sure they work before you
start the engine. The key returns to the ON position once the
engine is started and remains in this position while the engine
runs.
*
[CF10100(ALL)01/96]
START cranks the engine. Release the key once the engine starts
so that you do not damage the starter. The key should return to
ON when you release it. The START position also allows you to
test the brake warning light.
%*
[CF10200(ALL)03/96]
Removing the Key From the Ignition
[CF10300(ALL)04/96]
Procedures for removing your key from the ignition vary,
depending on whether your vehicle has an automatic or manual
transaxle.
[CF10400(ALL)04/96]
If your vehicle has an automatic transaxle:
*
[CF10500(ALL)01/96]1.
Put the gearshift lever in P (Park).
*
[CF10600(ALL)01/96]2.
Set the parking brake fully.
[CF10700(ALL)12/95]3.
Rotate the ignition key to the LOCK position.
[CF10800(ALL)12/95]4.
Remove the key from the ignition.
File:05cdcfo.ex
Update:Fri Sep 13 08:48:17 1996

58
[CF10900(ALL)04/96]
If your vehicle has a manual transaxle:
[CF11000(ALL)04/96]1.
Put the gearshift lever in 1 (First).
*
[CF11100(ALL)01/96]2.
Set the parking brake fully.
[CF11200(ALL)12/95]3.
Rotate the ignition key to the LOCK position.
[CF11300(ALL)12/95]4.
Remove the key from the ignition.
[CF11400(ALL)12/95]
The steering wheel locks when the key is removed.
%*
[CF11500(ALL)12/95]
If the driver's door is open while the key is still in the ignition,
a warning chime sounds.
*
[CF11600(ALL)01/96]
RWARNING
Always set the parking brake fully and make sure that
the gearshift is securely latched in P (Park) (automatic
transaxle) or in 1 (First) (manual transaxle).
*
[CF11700(ALL)03/96]
RWARNING
Do not leave children, unreliable adults, or pets
unattended in your vehicle.
File:05cdcfo.ex
Update:Fri Sep 13 08:48:17 1996

60
*
[CF12800(ALL)08/95]
High Beams and Flashing the Lamps
[CF12900(ALL)12/95]
To turn on the high beams, turn the headlamp control knob to
the headlamp ON position and push the turn signal lever away
from you until it latches. When the high beams are on, the high
beam indicator light on the instrument cluster comes on.
[CF13000(ALL)12/95]
To turn off the high beams, pull the lever back to the off
position.
*
[CF13100(ALL)01/96]
To flash the headlamps, pull the lever toward you for a moment
and then release it. The headlamps will flash whether the
headlamp knob is in the on or off position.
%*
[CF13200(ALL)01/96]
Windshield Wipers and Washer
[CF13300(ALL)04/96]
To turn on the windshield wipers, the ignition key must be
turned to the ON position.
[CF13400(ALL)12/95]
10-1/2 pica
art:0001189-D
Using the windshield wiper
[CF13500(ALL)12/95]
The windshield wipers can be set on high, low speed or interval
wipe. Turn the ring on the lever to set a longer or shorter pause
between wiping cycles.
File:05cdcfo.ex
Update:Fri Sep 13 08:48:17 1996