TPMS FORD CROWN VICTORIA 2010 2.G User Guide
[x] Cancel search | Manufacturer: FORD, Model Year: 2010, Model line: CROWN VICTORIA, Model: FORD CROWN VICTORIA 2010 2.GPages: 308, PDF Size: 2.5 MB
Page 275 of 308
WHEELS/TIRES/BRAKES
Wheel rims - police
To withstand the demands placed on vehicles driven under heavy-duty
service conditions, Ford Motor Company installs heavy-duty steel wheels.
Tires - police
Tires (including the spare) are speed-rated radials for police use. Use
only the recommended tire size and speed ratings.
In regions with snow and ice during the winter months, installation of
snow tires may be desirable. Snow tires will usually exhibit a drop in dry
pavement handling, but many show an increase in snow and ice traction.
When snow tires are used, they should be installed on all four wheels,
never on the drive wheels only.
Tires - long term storage
Most high performance tires are made with a nylon overlay.
As such, the following steps should be taken to avoid flatspotting when
the vehicles are not used for a period of time.
•Fleets should store the vehicles with 44 psi (303 kPa) in the tires.
•If the vehicle is stored for periods longer than 30 days, it should be
moved several feet at least once during each 30-day period, so that a
different portion of the tread contacts the ground.
•Tire pressure should be reduced to the recommended pressure shown
on the vehicle certification label before the vehicle is placed back into
service.
Training the Tire Pressure Monitoring System (TPMS)
All Crown Victorias are equipped
with the Tire Pressure Monitoring
System (TPMS) that illuminates a
low tire pressure telltale on the
instrument cluster when one or
more of your tires is significantly under-inflated.
Crown Victoria Severe Duty
275
2010 Crown Victoria(cro)
Owners Guide, 2nd Printing
USA(fus)
Page 276 of 308
Each road tire, as well as the spare,
is equipped with a tire pressure
sensor fastened to the inside of the
rim, opposite (180 degrees) from
the valve stem. The signal from each
transmitter is digitally unique to
avoid interference from transmitters
on other nearby vehicles.
Note:The spare has a TPMS
sensor, but is not programmed to
the module.
Changing tires with the TPMS
Care should be taken avoid damaging the sensor and band during
mounting or dismounting. Please refer to the Crown Victoria shop
manual for the complete mount and dismount procedure. This is critical,
as the procedure is different from previous model years due to the
introduction of TPMS.
When a new tire/wheel is installed
When one of your road tires is replaced by a new tire/wheel, the TPMS
sensor located in the new tire/wheel needs to betrainedto the vehicle.
TPMS system training tools
An inexpensive TPMS training tool, P/N 8C2Z-1A203-A, can be
purchased from any Ford dealer for use by the driver or shop technician
for training the system after maintenance has been performed that
requires system training. The Tire Pressure Monitor Activation Tool, P/N
204-363, has more functionality and is designed primarily for shop use.
For either tool, follow the training instructions as outlined below.
Note:This procedure is also included in the Crown Victoria Service
Manual.
Crown Victoria Severe Duty
276
2010 Crown Victoria(cro)
Owners Guide, 2nd Printing
USA(fus)
Page 277 of 308
TPMS reset tips:
•To reduce the chances of interference from another vehicle, TPMS
reset should be performed at least three feet (one meter) away from
another Ford Motor Company vehicle undergoing the TPMS reset
procedure at the same time.
•Do not wait more than two (2) minutes between resetting each tire
sensor or the system will timeout and the entire procedure will have
to be repeated on all four wheels.
•A double horn chirp indicates the need to repeat the procedure.
TPMS reset procedure
Note:It is recommended that you read the entire procedure before
attempting.
Note:To enter the reset mode, Steps 1–6 MUST be completed within
60 seconds.
1. Place the ignition in the off position and keep the key in the ignition.
2. Press and release the brake
pedal.
3. Cycle the ignition from off to on
three (3) times ending in the on
position—DO NOTstart the engine.
Crown Victoria Severe Duty
277
2010 Crown Victoria(cro)
Owners Guide, 2nd Printing
USA(fus)
Page 278 of 308
4. Press and hold the brake pedal
for two (2) seconds, then release.
5. Turn the ignition to off—DO
NOTremove the key.
6. Cycle the ignition from off to on three (3) times ending in on—DO
NOTstart the engine.
If the reset mode has been entered successfully, the horn will sound
once, and the TPMS indicator
will flash.
If after repeated attempts to enter the reset mode, the horn does not
sound, and the TPMS indicator
does not flash, seek service from
your authorized dealer.
7. Train the TPMS sensors in the tires using the following TPMS reset
sequence starting with theleft front tirein the following clockwise
order:
1. Left front tire (Front driver’s side)
2. Right front tire (Front passenger’s side)
3. Right rear tire (Rear passenger’s side)
4. Left rear tire (Rear driver’s side)
Crown Victoria Severe Duty
278
2010 Crown Victoria(cro)
Owners Guide, 2nd Printing
USA(fus)
Page 279 of 308
8.Left front tire:Place the TPMS reset tool against the left front tire
where the tire meets the rim, opposite from the valve stem (1) as shown.
This is where the sensor is located inside the rim.
Both tools, the TPMS training tool (part number 8C2Z-1A203-A)
or the Tire Pressure Monitor Activitation Tool (part number
204-363) must be held against the tire sidewall opposite the valve
stem as illustrated. For the TPMS training tool, the device should
be held as illustrated, with the arrow on the tool pointing
towards the rim; do not use the tool with the arrow pointing away
from the rim as it may not activate the sensor.
9. Press and release the activation button while holding either tool to the
side wall until the horn sounds. The horn will sound once within
approximately 10 seconds to indicate the process was successful.
Note:
•If a double horn chirp is heard, repeat the procedure. If a single horn
chirp is not heard, move the vehicle to rotate the wheels at least a
1 4-turn and repeat the procedure starting with Step 1.
•If the horn does not sound while attempting to reset any wheel, seek
service from your authorized dealer.
10. Perform Steps 8 and 9 on the right front tire, right rear tire and
finally the left rear tire. Training is complete after the horn sounds for
the last tire trained (left rear tire).
Turn the ignition to off. If two short horn beeps are heard, the reset
procedure was unsuccessful and must be repeated.
Crown Victoria Severe Duty
279
2010 Crown Victoria(cro)
Owners Guide, 2nd Printing
USA(fus)
Page 308 of 308
tilting .........................................66
Suspension
heavy duty (police) ................274
T
Tilt steering wheel ......................66
Tire Pressure Monitoring
System (TPMS)
Tires, Wheels and Loading ....157
Police and fleet vehicles ........275
Tires ...................................142–143
alignment ................................150
care ..........................................146
changing ..................................205
checking the pressure ............146
inflating ...................................144
label .........................................156
police vehicles ........................275
replacing ..................................148
rotating ....................................151
safety practices .......................149
sidewall information ...............152
snow tires and chains ............162
spare tire .........................201, 203
terminology .............................143
tire grades ...............................143
treadwear ........................142, 147
Towing .......................................169
recreational towing .................172
trailer towing ..........................169
wrecker ....................................213
Traction control ........................182Traction-lok rear axle ...............184
Transmission .............................185
brake-shift interlock (BSI) ....184
fluid, checking and adding
(automatic) .............................258
fluid, refill capacities ..............263
lubricant specifications ..........263
Trunk ...........................................78
Pack and loading ....................282
remote release ....................75, 81
Turn signal ..................................52
V
Vehicle Identification Number
(VIN) ..........................................267
Vehicle loading ..........................163
Ventilating your vehicle ...........176
W
Warning lights (see Lights) .......12
Washer fluid ..............................232
Water, Driving through .............188
Windows
power .........................................68
Windshield washer fluid and
wipers ..........................................65
checking and adding fluid .....232
replacing wiper blades ...........232
Wrecker towing .........................213
Index
308
2010 Crown Victoria(cro)
Owners Guide, 2nd Printing
USA(fus)