low beam FORD E-250 2012 Owners Manual

FORD E-250 2012 Owners Manual E-250 2012 FORD FORD https://www.carmanualsonline.info/img/11/57765/w960_57765-0.png FORD E-250 2012 Owners Manual

Page 53 of 335

FORD E-250 2012  Owners Manual VERTICAL AND HORIZONTAL AIM ADJUSTMENT (SEALED BEAM
HEADLAMPS)
The headlamps on your vehicle are intended to be aimed using
mechanical aimers. If mechanical aimers are used and the cross-car sight
lin

Page 54 of 335

FORD E-250 2012  Owners Manual 5. Locate the vertical adjuster (1)
for each headlamp. Adjust the aim
by turning the adjuster control
either clockwise (to adjust up) or
counterclockwise (to adjust down).
6. In addition to the horizo

Page 55 of 335

FORD E-250 2012  Owners Manual 3. Turn on the low beam headlamps to illuminate the wall or screen and
open the hood. Cover one of the headlamps so no light hits the wall.
4. On the wall or screen you will
observe a light pattern wi

Page 59 of 335

FORD E-250 2012  Owners Manual Replacing exterior bulbs
Check the operation of all bulbs frequently.
Replacing headlamp bulbs (aerodynamic)
1. Make sure the headlamp switch is in the off position, then open the
hood.
2. Remove the

Page 60 of 335

FORD E-250 2012  Owners Manual 2. Remove the four screws from the
headlamp assembly and carefully
remove the lamp/bezel.
3. Remove the four screws and the
retaining ring.
4. Disconnect the electrical
connector from the lamp and
rem

Page 61 of 335

FORD E-250 2012  Owners Manual Replacing side marker bulbs
1. Make sure the headlamp control is in the off position.
2. Remove the headlamp assembly. Refer toReplacing headlamp bulbs
in this section.
Aerodynamic
Sealed beam
3. Rota

Page 219 of 335

FORD E-250 2012  Owners Manual The fuses are coded as follows.
Fuse/Relay
LocationFuse Amp
RatingProtected Circuits
1 30A Not used (spare)
2 15A Not used (spare)
3 15A Not used (spare)
4 30A Not used (spare)
5 10A Passenger compart