homelink FORD E-450 2007 User Guide

6. Firmly press and release the “learn” or “smart” button. (The name and
color of the button may vary by manufacturer.)
Note:There are 30 seconds in which to initiate Step 7.
7. Return to the vehicle and firmlypress, hold for two seconds and
releasethe HomeLinkbutton. Repeat thepress/hold/release
sequence again and, depending on the brand of the garage door opener
(or other rolling code equipped device), repeat this sequence a third
time to complete the programming.
HomeLinkshould now activate your rolling code equipped device. To
program additional HomeLinkbuttons begin with Step 2 in the
“Programming” section. For questions or comments, please contact
HomeLink atwww.homelink.comor1–800–355–3515.
Gate Operator & Canadian Programming
During programming, your
hand-held transmitter may
automatically stop transmitting —
not allowing enough time for
HomeLinkto accept the signal
from the hand-held transmitter.
After completing Steps 1 and 2
outlined in the“Programming”
section, replace Step 3 with the
following:
Note:If programming a garage door opener or gate operator, it is
advised to unplug the device during the “cycling” process to prevent
overheating.
•Continue to press and hold the HomeLinkbutton (note Step 3 in the
“Programming” section) while you press and release —every two
seconds(“cycle”) your hand-held transmitter until the frequency
signal has been accepted by the HomeLink. The indicator light will
flash slowly and then rapidly after HomeLinkaccepts the radio
frequency signal.
•Proceed with Step 4 in the “Programming” section.
2007 Crown Victoria(cro)
Owners Guide (post-2002-fmt)
USA(fus)
Driver Controls
71
ProCarManuals.com

Operating the HomeLinkWireless Control System
To operate, simply press and release
the appropriate HomeLinkbutton.
Activation will now occur for the
trained product (garage door, gate
operator, security system, entry
door lock, or home or office lighting
etc.). For convenience, the
hand-held transmitter of the device
may also be used at any time. In the
event that there are still
programming difficulties, contact
HomeLinkatwww.homelink.comor1–800–355–3515.
Erasing HomeLinkbuttons
To erase the three programmed
buttons (individual buttons cannot
be erased):
•Press and hold the two outer
HomeLinkbuttons until the
indicator light begins to
flash-after 20 seconds. Release
both buttons. Do not hold for
longer that 30 seconds.
HomeLinkis now in the train (or
learning) mode and can be programmed at any time beginning with Step
2inthe“Programming”section.
Reprogramming a single HomeLinkbutton
To program a device to HomeLinkusing a HomeLinkbutton previously
trained, follow these steps:
1. Press and hold the desired HomeLinkbutton.Do NOTrelease the
button.
2. The indicator light will begin to flash after 20 seconds. Without
releasing the HomeLinkbutton, follow Step 2 in the “Programming”
section.
For questions or comments, contact HomeLinkatwww.homelink.com
or1–800–355–3515.
2007 Crown Victoria(cro)
Owners Guide (post-2002-fmt)
USA(fus)
Driver Controls
72
ProCarManuals.com

Exhaust fumes ..........................170
F
Fail safe cooling ........................236
Flexible Fuel Vehicle (FFV) ....237
Floor mats ...................................81
Fluid capacities .........................256
Fuel ............................................237
calculating fuel
economy ......................55, 75, 244
cap ...........................................240
capacity ...................................256
choosing the right fuel ...........241
comparisons with EPA fuel
economy estimates .................247
detergent in fuel .....................242
filling your vehicle with
fuel ...........................237, 240, 244
filter, specifications ........237, 254
fuel pump shut-off switch .....185
improving fuel economy ........244
octane rating ...................242, 259
quality ..............................242–243
running out of fuel .................243
safety information relating to
automotive fuels .....................237
Fuel - flex fuel vehicle
(FFV) .........................237, 241–242
Fuses ..................................186–187
G
Gas cap (see Fuel cap) ............240
Gas mileage
(see Fuel economy) .................244
Gauges .........................................15
H
Hazard flashers .........................184Head restraints ...........................98
Headlamps ...................................38
aiming ........................................40
autolamp system .......................38
bulb specifications ....................42
daytime running lights .............39
flash to pass ..............................39
high beam .................................39
replacing bulbs .........................43
turning on and off ....................38
Heating
heating and air conditioning
system .................................34–35
Homelink wireless control
system ..........................................69
Hood ..........................................223
I
Ignition ...............................167, 259
Illuminated visor mirror .............50
Infant seats
(see Safety seats) .....................134
Inspection/maintenance (I/M)
testing ........................................249
Instrument panel
cleaning ...................................218
cluster ........................................10
lighting up panel and
interior .......................................40
J
Jack ............................................194
positioning ...............................194
storage .....................................194
Jump-starting your vehicle ......201
K
Keyless entry system .................90
2007 Crown Victoria(cro)
Owners Guide (post-2002-fmt)
USA(fus)
Index
266
ProCarManuals.com