key FORD E SERIES 1996 4.G User Guide

71
*
[LG04150(BEF )02/95]
Safety Belt Warning Light and Chime
*
[LG04301(BEF )03/95]
This warning light and chime remind you to
fasten your safety belt. The following conditions
will take place:
*
[LG04325(BEF )03/95]
q
If the safety belt is not buckled when the key
is turned to the ON position, the light comes
on for 1 to 2 minutes and the chime sounds
for 4 to 8 seconds.
*
[LG04351(BEF )02/95]
q
If the safety belt is buckled while the light is
on and the chime is sounding, both the light
and chime turn off.
*
[LG04365(BEF )05/95]
q
If the safety belt is buckled before the
ignition is turned to the ON position, neither
the light nor the chime will come on.
*
[LG04400( ALL)10/92]
one inch art:0020046-B
Safety belt warning light symbol
*
[LG04500( ALL)03/95]
Check Engine Warning Light
*
[LG04525( ALL)05/95]
The Powertrain On-Board Diagnostic II (OBD II)
system consists of the hardware and software
necessary to monitor the operation of the
powertrain. The OBD II system is designed to
check the function of the vehicle's powertrain
control system during normal operation. If an
emission problem is detected, the Check Engine
Warning Light (in the cluster) is turned on.
File:05ltlge.ex
Update:Wed Apr 17 08:49:15 1996

72
*
[LG04550( ALL)05/95]
one inch art:0020048-A
Check engine warning light symbol
*
[LG04575( ALL)05/95]
Modification or additions to the vehicle may
cause incorrect operation of the OBD II system.
Additions such as burglar alarms, cellular
phones, and CB radios must be carefully
installed. Do not install these devices by tapping
into or running wires close to powertrain control
system wires or components.
*
[LG04600( ALL)05/95]
The light comes on briefly when you turn the
ignition key toON, but it should turn off when
the engine starts. If the light does not come on
when you turn the ignition toONor if it comes
on and stays on when you are driving, have
your vehicle serviced as soon as possible. This
indicates a possible problem with one of the
vehicle's emission control systems. You do not
need to have your vehicle towed in.
*
[LG04625( ALL)05/95]
If the light turns on and off at one (1) second
intervals while you are driving the vehicle, it
means that the engine is misfiring. If this
condition persists, damage could occur to the
engine or catalytic convertor. Have your vehicle
serviced at the first opportunity. You do not
need to have your vehicle towed in.
*
[LG04650( ALL)05/95]
If the light turns on and off on rare occasions
while you are driving, it means that a
malfunction occurred and the condition corrected
itself.
File:05ltlge.ex
Update:Wed Apr 17 08:49:15 1996

75
*
[LG06325( E )04/95]
Anti-Theft Alarm Light (If equipped)
*
[LG06335( E )04/95]
This light flashes on and off when the ignition
switch is OFF and any door is opened. As soon
as you lock the doors, the light glows steadily.
Within 30 seconds of closing all the doors, the
light goes out. This indicates that the alarm
system is armed.
*
[LG06345( E )04/95]
one inch art:0020921-A
Anti-Theft Alarm Light
*
[LG06400( ALL)05/94]
Battery Voltage Gauge (Voltmeter)
*
[LG06601( ALL)05/94]
This gauge shows you the battery voltage when
the ignition key is in the ON position.
*
[LG06700( ALL)11/89]
If you are running electrical accessories (when
the engine is off, or idling at a low speed), the
pointer may move toward the lower end of the
normal band. If it stays outside the normal band
area, have your vehicle's electrical system
checked as soon as it is safely possible.
*
[LG06701( ALL)05/95]
If the battery is operating under cold weather
conditions, the pointer may indicate in the upper
range of the NORMAL band while the battery is
charging. If you are running electrical accessories
with the engine off or idling at a low speed, or
the battery is not fully charged, the pointer may
move toward the lower end of the NORMAL
band.
*
[LG06750( ALL)05/94]
If it stays outside the NORMAL band, have your
vehicle's electrical system checked as soon as it
is safely possible.
File:05ltlge.ex
Update:Wed Apr 17 08:49:15 1996

83
*
[IP00500(BEF )06/95]
The Climate Control Systems
*
[IP00601(BEF )12/91]
Your vehicle is equipped with a control
assembly designed to handle either a
combination A/C-Heater System or a
Heater-Only System.
*
[IP00701( E )05/94]
If your vehicle has a factory installed auxiliary
system, the front control will be equipped with a
rear fan control switch. If it is a factory installed
auxiliary system with REAR A/C and REAR
HEATER functions, an auxiliary fan speed
control switch is installed in the rear of the
vehicle.
%*
[IP00801(BEF )10/93]
Instrument Panel Registers
*
[IP00901( E )02/95]
There are four registers in the instrument panel.
Each of these registers contains a louver
assembly which can be manually adjusted to
direct airflow up, down, left and right. An
illustration of the register locations follows.
[IP01101( E )12/91]
quarter page art:0020100-C
Instrument panel registers
%*
[IP01598( E )05/94]
Standard Heater
[IP01599( E )05/94]
The control for your Heater system is located at
the center of the instrument panel and will
operate only when the ignition key is turned to
the RUN position. Your Heater will heat or
ventilate your vehicle interior depending on the
Function lever position and temperature you
select. The bottom lever is the Function Selector
lever which allows you to determine where the
File:06ltipe.ex
Update:Wed Apr 17 08:48:31 1996

87 [IP01765( E )05/94]
Operational Air Conditioner and Heater
[IP01770( E )05/94]
The control for your Air Conditioning and
Heater system is located at the center of the
instrument panel and will operate only when the
ignition key is turned to the RUN position. Your
Air Conditioner & Heater will heat and/or cool
your vehicle interior depending on the Function
lever position and temperature you select. The
bottom lever is the Function Selector lever which
allows you to select heating or cooling and
determine where the air will be directed. The
top lever is the Temperature lever. The setting
or position of the top lever determines the
temperature of the air that flows into the
vehicle.
[IP01775( E )05/94]
quarter page art:0020984-A
Front and Rear A/C and Heater (Main and Auxiliary
system)
[IP01780( E )05/94]
quarter page art:0020985-A
A/C and Heater, front - Heater only, rear
File:06ltipe.ex
Update:Wed Apr 17 08:48:31 1996

101
*
[SC03800( ALL)05/95]
one third page art:0020074-B
Headlamp high beam switch and turn signal lever
*
[SC04200( ALL)05/95]
Flashing the Lights
*
[SC04300( ALL)06/95]
To flash the headlamps, pull the lever toward
you for a moment and then release it. The
headlamps will flash whether the headlamp
knob is in the on or off position.
*
[SC04400( ALL)03/95]
Windshield Wipers and Washer
*
[SC04500( ALL)03/95]
To turn on the windshield wipers, the ignition
key must be turned to the ON or ACC position.
*
[SC04600( ALL)05/95]
Turn the knob on the end of the turn signal
lever toward the front of the vehicle. You can
turn it to either the LO or HI speed position.
File:07ltsce.ex
Update:Wed Apr 17 08:47:45 1996

116
*
[FV09801( E )05/95]
RWARNING
Do not operate your vehicle with the rear
double doors open.
*
[FV14100(BEF )04/95]
Power Door Locks (If equipped)
*
[FV14500(BEF )05/95]
The power door lock switches are located in the
front doors. To lock all doors push the switch
marked L. To unlock all doors push the switch
marked U.
*
[FV14701(BEF )03/91]
The manual door locks will override the power
door lock controls.
*
[FV15001(BEF )05/95]
quarter page art:0020203-C
Power door lock controls
*
[FV15301(BEF )05/95]
Remote Entry System
(If equipped)
*
[FV15401(BEF )06/95]
If your vehicle has the remote entry system, you
can lock or unlock the vehicle doors without
using a key. The remote also has a personal
alarm feature. The buttons for the system are
located on the two hand held transmitters that
came with your vehicle.
*
[FV15600(BEF )06/95]
The system will work with up to four
transmitters. Your vehicle came with two
transmitters. Additional transmitters can be
ordered from your dealer.
File:08ltfve.ex
Update:Wed Apr 17 08:47:13 1996

121
% [FV19103( E )04/95]
Anti-theft system (If equipped)
*
[FV19106( E )05/95]
When armed, this system helps protect your
vehicle against break-ins or theft.
%*
[FV19109( E )05/95]
When an unauthorized entry occurs, the system
triggers and will:
*
[FV19112( E )05/95]
q
flash the headlamps, parking lamps, and
alarm indicator lamp
*
[FV19115( E )06/95]
q
honk the horn
*
[FV19118( E )05/95]
q
disable the starting circuit to prevent the
vehicle from being started
%*
[FV19121( E )05/95]
Arming the system
*
[FV19124( E )05/95]
1. Remove the key from the ignition.
*
[FV19130( E )05/95]
2. Open any door. The alarm indicator light
will start flashing to remind you to arm the
system.
*
[FV19133( E )05/95]
3. Lock the doors by using the power door
lock switch. The alarm indicator light will
now glow steadily.
*
[FV19134( E )04/95]
NOTE: The system can also be armed by
pressing the LOCK button on the
remote transmitter after the doors have
been closed.
*
[FV19136( E )04/95]
4. Close all doors. The alarm indicator light
will then remain on steadily for
approximately 30 more seconds and then go
out. When the light goes out the system is
armed.
File:08ltfve.ex
Update:Wed Apr 17 08:47:13 1996

122
*
[FV19139( E )06/95]
NOTE: Be sure to close all doors completely. If
not, the alarm indicator light will
remain on. Remember, your anti-theft
system is armed only after the alarm
indicator light remains on steadily for
approximately 30 seconds after the last
door is closed, and then goes out.
*
[FV19154( E )04/95]
The anti-theft system is designed to work with
the factory installed remote entry system. It may
not work with other remote entry systems.
%*
[FV19157( E )05/95]
Disarming an untriggered anti-theft system
[FV19160( E )03/93]
You can disarm the system by unlocking either
front door or the rear door with your door key.
Turn the key all the way to the end of travel or
the system will not disarm.
*
[FV19163( E )04/95]
You can also disarm the system by unlocking
the driver's door by using the UNLOCK button
of the remote entry transmitter.
*
[FV19166( E )04/95]
If the system is armed and you remain in your
vehicle, simply insert the key into the ignition
and turn it to ON. This disarms the system and
allows you to open the door and exit without
triggering the system.
%*
[FV19187( E )05/95]
Disarming a triggered system
*
[FV19190( E )05/95]
The alarm can be disarmed by:
*
[FV19196( E )04/95]
q
unlocking any door with the key, or
*
[FV19199( E )05/95]
q
using the UNLOCK button of the remote
entry transmitter
*
[FV19202( E )05/95]
NOTE: The flashing lights and honking horn
will shut off automatically within 2
minutes 45 seconds after the system is
triggered. It will trigger again if
another intrusion occurs. However, the
starter circuit remains disabled until
the system is disarmed.
File:08ltfve.ex
Update:Wed Apr 17 08:47:13 1996

126 [FV27901( E )12/91]
one third page art:0020224-CReclining bucket seat
%*
[FV31201( E )12/91]
Quick Release Rear Captain Chairs
[FV31301( E )12/91]
Second row
*
[FV31400( E )12/91]
To remove:
[FV31700( E )12/91]
1. Disengage the lap/shoulder safety belt from
the seat by inserting a key or similar device
into the slot in the detachable anchor and
lifting upward. Stow the tongue end of the
detachable anchor as shown.
[FV31901( E )02/92]
2. Pull the seat latch handle, located on the
right hand side of the seat base, and pull
seat toward the right hand side of vehicle to
disengage four pins from the floor mount.
[FV32001( E )12/91]
one third page art:0020915-A
Removing the quick release rear captains chair
File:08ltfve.ex
Update:Wed Apr 17 08:47:13 1996