bulb FORD ESCAPE 2001 1.G Owners Manual

FORD ESCAPE 2001 1.G Owners Manual ESCAPE 2001 1.G FORD FORD https://www.carmanualsonline.info/img/11/4852/w960_4852-0.png FORD ESCAPE 2001 1.G Owners Manual

Page 10 of 280

FORD ESCAPE 2001 1.G Owners Manual WARNING LIGHTS AND CHIMES
Service engine soon
Your vehicle is equipped with a
computer that monitors the engines
emission control system. This
system is commonly known as the
On Board Diagnostics Sys

Page 11 of 280

FORD ESCAPE 2001 1.G Owners Manual These temporary malfunctions can be corrected by filling the fuel tank
with high quality fuel of the recommended octane and/or properly
installing and securely tightening the fuel cap. After three dri

Page 12 of 280

FORD ESCAPE 2001 1.G Owners Manual Safety belt
Momentarily illuminates when the
ignition is turned to the RUN
position to remind you to fasten
your safety belts. For more
information, refer to theSeating
and safety restraintschapter.
B

Page 15 of 280

FORD ESCAPE 2001 1.G Owners Manual Check fuel cap
Momentarily illuminates when the
ignition is turned to the ON position
to ensure your bulb is working.
When this light turns on, check the
fuel filler cap. Continuing to operate
the veh

Page 235 of 280

FORD ESCAPE 2001 1.G Owners Manual Allow the vehicle to sit for at least eight hours without starting the
engine. Then, start the engine and complete the above driving cycle. The
engine must warm up to its normal operating temperature.

Page 236 of 280

FORD ESCAPE 2001 1.G Owners Manual 4. Remove the rubber boot from the
lamp assembly by pulling on one of
the tabs.
5. Press the retainer spring forward
and spread the spring releasing it
from bulb hooks and rotate it away
from the bulb

Page 237 of 280

FORD ESCAPE 2001 1.G Owners Manual 7. Insert the glass end of the new bulb into the headlamp assembly.
When the bulbs three metal tabs are aligned with the grooves in the
plastic base, push the bulb into the lamp assembly until the bu

Page 238 of 280

FORD ESCAPE 2001 1.G Owners Manual 5. Pull the bulb straight out of the
socket and push in the new bulb.
6. To complete installation, follow
the removal procedure in reverse
order.
Replacing license plate lamp bulbs
1. Remove the licen

Page 239 of 280

FORD ESCAPE 2001 1.G Owners Manual 3. Pull the bulb straight out of the
socket and push in the new bulb.
To complete installation, follow the
removal procedure in reverse order.
Replacing front parking lamp/turn signal bulbs
For bulb r

Page 240 of 280

FORD ESCAPE 2001 1.G Owners Manual Function Number of bulbs Trade number
Center High-mount
stop lamp5
168
Rear license plate
lamp2
W5W
All replacement bulbs are clear in color except where noted.
To replace all instrument panel lights
Page:   1-10 11-20 next >