clutch FORD ESCAPE 2008 2.G User Guide

vehicle is not ready for I/M testing, the following driving cycle consisting
of mixed city and highway driving may be performed:
15 minutes of steady driving on an expressway/highway followed by 20
minutes of stop-and-go driving with at least four 30-second idle periods.
Allow the vehicle to sit for at least eight hours without starting the
engine. Then, start the engine and complete the above driving cycle. The
engine must warm up to its normal operating temperature. Once started,
do not turn off the engine until the above driving cycle is complete. If
the vehicle is still not ready for I/M testing, the above driving cycle will
have to be repeated.
BRAKE/CLUTCH FLUID
Brake and clutch systems are supplied from the same reservoir.
The fluid level will drop slowly as
the brakes wear, and will rise when
the brake components are replaced.
Fluid levels between the “MIN” and
“MAX” lines are within the normal
operating range; there is no need to
add fluid. If the fluid levels are
outside of the normal operating
range the performance of the
system could be compromised; seek
service from your authorized dealer immediately.
TRANSMISSION FLUID
Checking automatic transmission fluid (if equipped)
Refer to yourscheduled maintenance informationfor scheduled
intervals for fluid checks and changes. Your transaxle does not consume
fluid. However, the fluid level should be checked if the transaxle is not
working properly, i.e., if the transaxle slips or shifts slowly or if you
notice some sign of fluid leakage.
Automatic transmission fluid expands when warmed. To obtain an
accurate fluid check, drive the vehicle until it is warmed up
(approximately 20 miles [30 km]). If your vehicle has been
operated for an extended period at high speeds, in city traffic
during hot weather or pulling a trailer, the vehicle should be
turned off for about 30 minutes to allow fluid to cool before
checking.
1. Drive the vehicle 20 miles (30 km) or until it reaches normal operating
temperature.
2008 Escape(204)
Owners Guide (post-2002-fmt)
USA(fus)
Maintenance and Specifications
278

MAINTENANCE PRODUCT SPECIFICATIONS AND CAPACITIES
Item CapacityFord part name or
equivalentFord part number /
Ford Specification
Brake fluid and (clutch
fluid –if equipped)Between MIN and
MAX on reservoirMotorcraft High
Performance DOT 3
Motor Vehicle Brake
FluidPM-1-C /
WSS-M6C62-A
Door weatherstrips — Silicone LubricantXL-6 /
ESR-M13P4-A
Body hinges, latches,
door striker plates and
rollers, seat tracks, fuel
filler door hinge and
spring, primary and
auxiliary hood latches— Multi-Purpose GreaseXG-4 or XL-5 /
ESB-M1C93-B
Engine coolant 2.3L
engine
(manual transaxle)5.3 quarts (5.0L)
Motorcraft Premium
Gold Engine Coolant
with bittering agent
(yellow-colored)
1
VC-7-B /
WSS-M97B51-A1 Engine coolant 2.3L
engine
(automatic transaxle)6.3 quarts (6.0L)
Engine coolant
3.0L engine10.6 quarts
(10.0L)
Cooling system stop
leak pellets—Motorcraft Cooling
System Stop Leak PelletsVC-6 /
WSS-M99B37-B6
2008 Escape(204)
Owners Guide (post-2002-fmt)
USA(fus)
Maintenance and Specifications
283

Child safety seats - booster
seats ...........................................132
Cleaning your vehicle
engine compartment ..............243
instrument panel ....................246
interior .....................................246
plastic parts ............................245
washing ....................................242
waxing .....................................243
wheels ......................................243
wiper blades ............................245
Climate control (see Air
conditioning or Heating) ......34, 37
Clutch
fluid ..........................................278
operation while driving ..........195
recommended shift speeds ....196
Compass, electronic ....................58
calibration .................................60
set zone adjustment .................59
Console ........................................54
overhead ....................................54
Controls
power seat .................................96
steering column ........................64
Coolant
checking and adding ..............261
refill capacities ................265, 283
specifications ..........................283
Cruise control
(see Speed control) ....................61
Customer Assistance ................206
Ford Extended Service
Plan ..........................................238
Getting assistance outside the
U.S. and Canada .....................239
Getting roadside assistance ...206
Getting the service you
need .........................................234Ordering additional owner’s
literature .................................240
Utilizing the
Mediation/Arbitration
Program ...................................238
D
Daytime running lamps
(see Lamps) ................................43
Dipstick
automatic transmission
fluid ..........................................278
engine oil .................................255
Driving under special
conditions ..................194, 200, 203
sand .........................................201
snow and ice ...........................204
through water .................202, 205
E
Electronic message center .........66
Emergencies, roadside
jump-starting ..........................227
Emergency Flashers .................208
Emission control system ..........275
Engine ........................................286
cleaning ...................................243
coolant .....................................261
fail-safe cooling .......................266
idle speed control ...................259
lubrication specifications .......283
refill capacities ........................283
service points ..................251–252
starting after a collision .........208
Engine block heater .................181
Engine oil ..................................255
checking and adding ..............255
dipstick ....................................255
2008 Escape(204)
Owners Guide (post-2002-fmt)
USA(fus)
Index
292