radio FORD ESCAPE HYBRID 2005 2.G Quick Reference Guide

HYBRID ENERGY FLOW WITH AUDIOPHILE AND NAVIGATION(if equipped)
1 AM/FM:Pressing AM/FM in navigation
mode will return the system to the
audio screen.
2 Fuel Economy Function:Press to view
average and instantaneous fuel
economy screen.
3 Seek:Use to find next/previous listenable
radio station or to advance tracks, if in CD mode.
4 HOME:Press and hold HOME key to
store current vehicle location as home.
Pressing HOME after the home location
has been set will calculate a route to
return to that set home location when innavigation mode.
5 Energy Flow Function:Press for status of
engine and battery. To disengage, press
the control again. Your energy flow
screen displays how power is used and
transferred between the electric motor,
the high voltage battery, and the gasolineengine. It also indicates which mode you
are currently operating in. Please see your
Owner’s Guide for more information.
6 Current Location:Press for information
on current location.
7 Memory Presets:Stores favorite AM/FM
stations and allows CD access when in CD
mode. To store, press and hold until
PRESET SAVED appears in display.
8 Navigation:Press NAV to access the
navigation system menu. Make sure the
vehicle is in Park (P) before you entera destination.
9 MAP:The control works in all modes.
Press MAP to show current location.
10 Back:Works only in navigation mode.
Press to return to previous screen
11 ENTER:Use ENTER to view a menu in
the navigation system. Press the controlup, down, left, or right to highlight an
item in the display. Press the center of
the control to make selection.
NOTE:With
this system, the Six CD Changer is locatedunder the passenger seat.
1357810
264911

1 AM/FM and CD Select:In radio mode,
press AM/FM to select AM or FM frequency
bands. In CD mode, press AM/FM to stop
play and begin radio play. To begin CD play
while in radio mode, press the CD control.
2 CD/AUX:Press to select CD/AUX modes.
No CD will display if there is not a CD
present in the audio system. If a disc is
loaded, there will be a number (16) inside
the circle on the display.
3 Loading CD:Press to open the CD door,
thenload the CD into the player. Press
LOAD and then a preset number to select
a slot. Press and hold LOAD to activate
autoload. In radio mode, press to begin
CD play.
4 Scan Function:In radio mode, press to
hear a sampling of all listenable stations.
In CD mode, press to hear a brief sampling
of all selections on the current CD.
5 Volume / Power Control:Push the control
to turn the audio system on or off. Turn the
control to raise or lower volume.
Automatic Volume Control:(if equipped)
This audio system has speed sensitive
volume control. Press and hold the volume
control for five seconds; press the SEL
control to increase or decrease volume levels.
6 Disc / Tune CAT:In radio mode, press to
move to the next frequency up or down
the band. In CD mode, press to select a
disc in the CD player. CAT is onlyavailable when equipped with satellite
radio. The kit to enable satellite reception
is available through your Ford dealer.
Detailed satellite instructions are included
with the dealerinstalled kit.
7 Setting Memory Preset Stations:Select
AM, FM1, or FM2 band, then select a
station. Next, press and hold a control
until the sound returns.
8 Digital Signal Processing (DSP):Press
DSP and then SEL to choose the desiredsignal mode (NEWS, JAZZ CLUB, etc).
9 Setting the Clock:Press MENU until
SELECT HOUR or SELECT MINS is
displayed. Press SEL to set the time. PressMENU again to disengage the clock mode.
SIX CD CHANGER(if equipped)
13
4
5
679
2
8

9 Ready Indicator:Illuminates after the vehicle has successfully
started. The vehicle is ready to drive even if
you don't hear the engine running.
10 Service Soon:Illuminates when the vehicle has detected
a malfunction. Report the fault to your
Escape Hybrid certified dealer at the
earliest opportunity.
11 Master Electrical Hazard Warning Lamp:Indicates a major hybrid component failure
or other major vehicle failure that will cause
the vehicle to shut down or fail to start.
Please see your Owner’s Guide for
additional information.
12 Service Engine Soon Lamp:Illuminates briefly when ignition is turned to
the RUN position. Solid illumination after
start indicates the on board diagnosticssystem has detected a malfunction. Have your
vehicle serviced immediately at an Escape
Hybrid certified dealer.
13 Front and Rear Wiper / Washer Control:
Front:Move the control down one position for
intermittent operation. Rotate the speed control
up for fast intervals and down for slow intervals.
Move the control down two positions from OFF
for normal or lowspeed wiper operation. Move
the control down three positions from OFF for
highspeed wiper operation. Pull the control
toward you to activate the windshield washer.
Release the control to stop washer fluid spray.
Move the control up and release for one wipewith mist.
Rear:Rotate the end of the control
upward to the INT position for intermittent
operation. Adjust the speed control for fast or
slow intervals. Rotate the control upward to ONfor normalspeed operation. Rotate the control
down one position and release to activate the
rear washer.
14 Power Point (12V):The 12V power point
outlet, located to the left of the 110 VAC
outlet, is designed for accessory plugs only.
Do not insert any other object; damage willoccur and blow the fuse. This power outlet
will require an adapter in order to plug in anelectric device.
15 Rear Window Defroster Control:Push to
clear the rear window of thin ice and frost.
The rear window defroster control has an auto
timeout feature that will electronically turn
the system off after 15 minutes. If the heated
rear window
is still in operation when the
ignition is switchedoff, the heating function
will be reactivated when the ignition isswitched on again.
16 Power Point (110 VAC):This outlet,
located on the center console in front of thegearshift, is used for powering electrical
devices that require up to 150W. Exceedingthis limit will cause the power point to cut
off the power temporarily to provide overload
protection. The green indicator light will
illuminate when the power point is ready to
supply power, blink when it is in fault mode,
and turn off when the power supply is off
(ignition is not in the RUN position). This
outlet does not require an adapter in orderto plug in an electrical device.
17 Passenger Airbag Off: The passenger airbag
off indicator, located just below the radio,
will illuminate when the passenger’s frontal
airbag is off. Please see your Owner’s Guide
for additional information.