ECO mode FORD ESCORT 1996 7.G User Guide

218
*
[AS27100(ALL)08/95]
How to eject the tape
*
[AS27250(ALL)08/95]
To stop the tape and eject the cassette, press the
ªEJECTº button. The radio will resume playing.
*
[AS27300(ALL)08/95]
Using the DolbyHB noise reduction feature
*
[AS27400(ALL)08/95]
NOTE: Noise reduction system manufactured
under license from Dolby Labs
Licensing Corporation. ªDolbyº and
double-D symbol are trademarks of
Dolby Laboratories Licensing
Corporation.
*
[AS27500(ALL)08/95]
Push thek/memory preset #3 button to
activate. Push again to deactivate.
%*
[AS27510(ALL)08/95]
Clock Operation
*
[AS27520(ALL)08/95]
How to view the clock mode
*
[AS27530(ALL)08/95]
Press the ªCLOCKº button to alternate the
frequency and time in the display. In the clock
mode, pressing any radio function will
automatically display the radio frequency for
approximately ten seconds before changing back
to the clock mode.
*
[AS27540(ALL)08/95]
How to set the clock
*
[AS27550(ALL)08/95]
1. Turn the radio on.
*
[AS27560(ALL)08/95]
2. Press and hold in the ªCLOCKº button,
press the ªSEEKº button left (
b) to advance
the hours and right (
a) to advance the
minutes.
*
[AS27570(ALL)08/95]
NOTE: The clock displays 12-hour time with
no AM/PM indications.
File:09ctase.ex
Update:Tue Sep 19 14:51:59 1995

219
*
[AS27600(ALL)08/95]
Tips on Caring for the Cassette Player and
Tapes
*
[AS27700(ALL)08/95]
In order to keep your cassette tape player
performing the way it was meant to, read and
follow these simple precautions:
*
[AS27800(ALL)08/95]
q
Only cassettes that are 90 minutes long or
less should be used. Tapes longer than 90
minutes are thinner and subject to breakage
or may jam the tape player mechanism.
*
[AS27900(ALL)08/95]
q
Protect cassettes from exposure to direct
sunlight, high humidity and extreme heat or
cold. If they are exposed to extreme
conditions, allow them to reach a moderate
temperature before playing.
*
[AS28000(ALL)08/95]
q
Loose labels on cassette tapes can become
lodged in the mechanism. Remove any loose
label material before inserting a cassette.
*
[AS28100(ALL)08/95]
q
If a tape is loose inside the cassette, tighten it
before playing by putting your finger or a
pencil into one of the holes and turning the
hub until the tape is tight.
*
[AS28200(ALL)08/95]
q
Do not leave a tape in the cassette tape
player when not in use. High heat in the
vehicle can cause the cassette to warp.
*
[AS28300(ALL)08/95]
q
Using a Ford Cassette Cleaning Cartridge to
clean the tape player head after 10-12 hours
of play will help maintain the best playback
sound and proper tape operation.
File:09ctase.ex
Update:Tue Sep 19 14:51:59 1995

223
Driving Your Escort
*
[DR00200(ALL)09/93]
Procedures for driving your vehicle will vary
depending on which type oftransaxleyour
vehicle has. You may be familiar with the term
ªtransmission.º We usetransaxlebecause it is a
more accurate term for vehicles that have
front-wheel drive.
*
[DR00300(ALL)07/95]
Your vehicle will have one of the following
types of transaxles:
*
[DR00500(ALL)11/94]
q
an automatic overdrive transaxle, or
*
[DR00600(ALL)11/94]
q
a manual transaxle.
[DR00650(ALL)08/95]
Your vehicle is equipped with an Electronic
Engine Control Module that limits engine speeds
with a cut-out mode to promote durability.
%
*
[DR03500(ALL)01/95]
Driving with an Automatic
Overdrive Transaxle
[DR03600(ALL)06/93]
Your automatic overdrive transaxle provides
fully automatic operation in either
k
(Overdrive) or D (Drive). Driving with the shift
selector in
k(Overdrive) gives the best fuel
economy for normal driving conditions. For
manual control, start in L (Low) and then shift
manually.
File:10ctdre.ex
Update:Tue Sep 19 14:53:34 1995

233
*
[DR16800(ALL)05/95]
If your vehicle does not have anti-lock brakes,
extreme braking can make the wheels lock and
slide, causing you to lose control of the steering.
If the wheels lock, release the brake pedal and
repeat the ºsqueezeª technique.
*
[DR16900(ALL)05/95]
Do not drive with your foot resting on the brake
pedal; you will wear out the linings and increase
your vehicle's stopping distance. Brake rotor
damage may also eventually occur.
*
[DR17000(ALL)05/95]
RWARNING
If you are driving down a long or steep
hill, shift to a lower gear. Do not apply
your brakes continuously, as they may
overheat and become less effective.
*
[DR17100(ALL)02/95]
Occasional brake squeal during light to moderate
stops does not affect the function of the brake
system and is normal. However, if the squeal
becomes annoyingly loud or increases
significantly in frequency of occurrence, return
the vehicle to your dealer for inspection.
[DR17200(ALL)09/89]
The high-mount brakelamp will light when you
apply the brakes.
[DR17300(ALL)05/95]Anti-lock Brake System
(If equipped)
*
[DR17325(ALL)11/94]
Your vehicle may come with the optional
anti-lock brake system. Whenever your wheels
start to lock (which could result in a skid) the
anti-lock brake system prevents the lock-up by
automatically releasing and re-applying the
brakes. The brake pedal will pulsate as a result
of the automatic releasing and re-applying of the
brakes. In spite of this improvement in braking
performance, you should continue to be cautious
in all hazardous driving situations, especially
when driving on hazardous road surfaces. Even
File:10ctdre.ex
Update:Tue Sep 19 14:53:34 1995

292
*
[SV10237(ALL)08/95]
If you are taking the medication ªAntabuseº or
other forms of disulfiram for the treatment of
alcoholism, vapor or skin contact with a
gasoline-methanol blend may cause the same
kind of adverse reaction as drinking an alcoholic
beverage. In sensitive individuals, serious
personal injury or sickness could result. Consult
a physician promptly if you experience an
adverse reaction.
%*
[SV11300(ALL)05/95]
Running Out of Fuel
[SV11325(ALL)08/95]
NOTE: Avoid running out of fuel because this
situation may have an adverse effect on
modern powertrain components.
[SV11350(ALL)08/95]
If your vehicle runs out of fuel, try to stop on
level ground away from traffic. The engine may
be restarted by adding at least one (1) gallon
(four liters) of fuel to the fuel tank. If the vehicle
is not level, up to three (3) gallons (12 liters) of
fuel may be required to start the engine.
*
[SV11550(ALL)07/95]
You may need to crank the engine several times
before the fuel system starts to pump fuel from
the tank to the engine.
*
[SV11580(ALL)01/95]
RWARNING
Never pour fuel in the throttle body or
attempt to start the engine with the air
cleaner removed. Doing so could result in
fire and personal injury.
%*
[SV11600(ALL)05/95]
Fuel Economy
*
[SV11700(ALL)07/95]
Fuel economy is an estimate of the efficiency of
your vehicle and can be calculated as Miles Per
Gallon (MPG) or Liters Per 100 Kilometers
(L/100K). Do not calculate the fuel economy
during your vehicle's break-in period. This
would not be an accurate estimate of how much
fuel your vehicle will normally use.
File:15ctsve.ex
Update:Tue Sep 19 14:37:50 1995

311
represent higher levels of performance on the
laboratory test wheel than the minimum
required by law. Warning: The temperature
grade for this tire is established for a tire that is
properly inflated and not overloaded. Excessive
speed, underinflation, or excessive loading, either
separately or in combination, can cause heat
buildup and possible tire failure.
%*
[SV28500(ALL)04/95]
Snow Tires and Chains
*
[SV28600(ALL)01/95]
The tires on your vehicle have all-weather treads
that provide traction in rain or snow. However,
during the winter months in some climates, you
may need to use snow tires and occasionally
chains for your tires.
*
[SV28700(ALL)05/95]
RWARNING
Snow tires must be the same size and
grade as the tires you currently have on
your vehicle.
*
[SV28810(ALL)02/95]
Use chains on the tires only in an emergency or
if the law requires them where you live. If you
choose to use chains on your vehicle's tires, be
aware of the following:
*
[SV28820(ALL)11/94]
q
Local regulations may prohibit or restrict the
use of tire chains. Investigate the laws and
regulations in your area before installing
chains.
*
[SV28830(ALL)08/93]
q
Tire chains may scratch or chip aluminum
wheels. IT IS RECOMMENDED THAT TIRE
CHAINS ARE INSTALLED ON STEEL
WHEELS ONLY. Be sure to remove wheel
covers (if equipped) from steel rims before
using tire chains to avoid scratches or
damage.
*
[SV28850(E )06/93]
q
Do not use tire chains if you have the GT
model.
File:15ctsve.ex
Update:Tue Sep 19 14:37:50 1995

343 %
*
[SV42405(ALL)07/95]
Readiness for Inspection/Maintenance
Testing
*
[SV42410(ALL)07/95]
In some localities it may become a legal
requirement to pass an
Inspection/Maintenance (I/M) test of the
On-Board Diagnostic (OBD) II system. If the
vehicle's powertrain system or its battery has
just been serviced, the OBD II system is reset to
a not ready for I/M testing condition. To
prepare for I/M testing, the law specifies a
ªneed for additional mixed city and highway
driving to complete the checkº of the OBD II
system. As soon as all of the OBD II system
checks are successfully completed, the OBD II
system is set to the ready condition. The amount
of driving required to reach the ready condition
varies with individual driving patterns. To
complete this requirement in the minimum
amount of time, refer to the OBD II Drive Cycle
defined below. If the vehicle owner cannot or
does not want to do the additional driving
required by law, a service center can perform
this drive cycle as it would any other type of
repair work.
[SV42415(ALL)09/95]
OBD II Drive Cycle (1.9L Engine only)
[SV42416(ALL)08/95]
The following steps must be run in the order
shown. If any steps are interrupted, repeat the
preceding step. Any safe driving mode is
acceptable between steps.
[SV42417(ALL)09/95]
NOTE: Always drive vehicle in a safe manner
according to traffic conditions and obey
all traffic laws.
File:15ctsve.ex
Update:Tue Sep 19 14:37:50 1995

344
*
[SV42420(ALL)07/95]
The engine must be warmed up and at
operating temperature before proceeding with
the drive modes of the following OBD II Drive
Cycle.
[SV42425(ALL)08/95]
1. Start the engine. Drive the vehicle or idle in
neutral for 4 minutes.
[SV42430(ALL)08/95]
2. Idle the vehicle in D (drive) (neutral for
manual transaxles) for 40 seconds.
[SV42435(ALL)08/95]
3. Accelerate the vehicle to 35 mph (55 km/h)
(manual transaxles upshift from 1st to 3rd
gear) at 1/2 to 3/4 throttle for 10 seconds.
[SV42440(ALL)08/95]
4. Drive the vehicle with a steady throttle at
35 mph (55 km/h) (manual transaxles use
3rd gear) for 30 seconds.
[SV42445(ALL)08/95]
5. Idle the vehicle in D (drive) (neutral for
manual transaxles) for 40 seconds.
[SV42450(ALL)08/95]
6. Continue to drive the vehicle in city traffic at
speeds between 25 and 40 mph
(40-64 km/h) (manual transaxles primarily
use 3rd and 4th gear when possible) for 15
minutes. During the 15 minute drive cycle
the following modes must be achieved:
*
[SV42455(ALL)07/95]
a. at least 5 stop and idle modes at 10
seconds each
[SV42460(ALL)06/95]
b. acceleration from idles at 1/2 to 3/4
throttle position, and
*
[SV42465(ALL)07/95]
c. choose 3 different speeds to do 1.5
minute steady state throttle drives.
[SV42470(ALL)08/95]
7. Accelerate the vehicle up to between 45 and
60 mph (72-97 km/h) (manual transaxles
upshift to 5th gear). This should take
approximately 5 minutes.
File:15ctsve.ex
Update:Tue Sep 19 14:37:50 1995