brake fluid FORD EXPEDITION 1997 1.G Owners Manual
[x] Cancel search | Manufacturer: FORD, Model Year: 1997, Model line: EXPEDITION, Model: FORD EXPEDITION 1997 1.GPages: 224, PDF Size: 2.2 MB
Page 8 of 224
Low washer fluid
Illuminates briefly when the
ignition is turned to On. Also
illuminates when the windshield
washer fluid is low.
Oil pressure
Illuminates briefly when the
ignition key is turned to On.
Illuminates when the oil pressure
is low. Stop the engine and check
the engine oil level as soon as
possible. Refer toChecking and
adding engine oilin the
Maintenance and caresection.
The oil pressure and engine
coolant warning lights share the
same lightbulb Ð if one of the
warning lights illuminates, they
both do.
Door ajar
Illuminates when the ignition
switch is in the ON or START
position and any door is open.
Charging system
Briefly illuminates when the
ignition is turned on and the
engine is off. The light also
illuminates when the battery is not
charging properly, requiring
electrical system service.
LOW
WASH
DOOR
AJAR
exd_oil_pressure_light
exd_door_ajar_light
exd_charging_system
com_brake_system.01
Instrumentation
9
Page 9 of 224
Brake system warning
Extinguishes when the parking
brake is released. Illumination after
releasing the parking brake
indicates low brake fluid level.
Safety belt
Illuminates when the ignition is
switched on to remind you to
fasten your safety belts. For more
information, refer toUsing the
safety restraints properlyin the
Seating and safety restraints
chapter.
Air bag readiness
Briefly illuminates when the
ignition is turned to On. If the light
fails to illuminate, continues to
flash or remains on, have the
system serviced. For more
information, refer to
Supplemental restraints system
(SRS)in theSeating and safety
restraintschapter.
Check engine warning light
This light illuminates when the
engine's Emission Control System
requires service. It will also
illuminate when the ignition key is
in the On position and the engine
is off. Refer toWhat you should
know about the On-board
diagnostic (OBD II) systemin the
Maintenance and carechapter.
!
BRAKE
CHECK
ENGINE
com_safety_belt.01
exd_air_bag
exd_check_engine
exd_tcil_light
Instrumentation
10
Page 158 of 224
3. Engine oil dipstick (For more
information on the engine oil
dipstick location and maintenance,
refer toChecking and adding
engine oilin this chapter.)
4. Brake fluid reservoir
5. Engine compartment fuse panel
6. Engine coolant reservoir
7. Air cleaner filter
8. Power steering fluid reservoir
9. Engine oil filler cap
10. Washer fluid reservoir
CHECKING AND ADDING
ENGINE OIL
Use WSS-M2C153±F motor oil
CERTIFIED FOR GASOLINE
ENGINES by the American
Petroleum Institute.
Engine oils with an SAE 5W-30
viscosity and displaying the
American Petroleum Institute
certification mark are preferred for
your vehicle. They provide the best
engine performance, fuel economy
and engine protection for all
climates down to ±25ÉC (-15ÉF).
Do not use:
²ªnon-detergentº oils
²oils labeled API SA, SB, SC, SD,
SE, SF or SG
²additional engine oil additives,
oil treatments or engine
treatments
Additional engine oil additives, oil
treatments or engine treatments
com_check-add_oil.01
Maintenance and care
159
Page 161 of 224
Changing the engine oil and
filter
Change your engine oil and filter
according to the following
kilometers (mileage) and time
requirements, whichever occurs
first:
²Normal Schedule ± 8,000 km
(5,000 miles) or six months.
²Severe Duty Schedule ± 5,000
km (3,000 miles) or three
months. Severe duty operation
would include extensive idling,
trailer towing, driving in severe
dust and police, taxi or delivery
service.
Ford production and aftermarket
(Motorcraft) oil filters are designed
for added engine protection and
long life. If a replacement oil filter
is used that does not meet Ford
material and design specifications,
startup engine noises or knock
may be experienced.
It is recommended you use the
appropriate Motorcraft oil filter (or
another brand meeting Ford
specifications) for your engine
application.
Checking and adding brake
fluid
Brake fluid should be checked and
refilled as needed at least once
each year:
exd_fix-me
com_checking-adding_fluid.01
Maintenance and care
162
Page 162 of 224
²Clean the reservoir cap before
removal to prevent dirt or water
from entering the reservoir.
²Visually inspect the fluid level.
²If necessary, add brake fluid
until the level reaches MAX. Do
not fill above this line.
²Use only a DOT 3 brake fluid
certified to meet Ford
specifications. Refer to
Lubricant specificationsin the
Capacities and specifications
chapter.
Brake fluid is toxic.
If you use a brake fluid
that is not DOT 3, you will
cause permanent damage to your
brakes.
Do not let the reservoir for
the master cylinder run
dry. This may cause the brakes
to fail.
MAX
MIN
exd_washer-fluid
Maintenance and care
163
Page 172 of 224
approximately 32 km (20 miles) of
driving. However, you can check
the fluid level without driving to
obtain a normal operating
temperature if the outside
temperature is above 10ÉC (50ÉF).
If your vehicle has been operated
for an extended period at high
speeds, in city traffic during hot
weather or pulling a trailer, the
vehicle should be turned off for
about 30 minutes to allow the fluid
to cool before checking.
1. Park the vehicle on a level
surface.
2. Start the engine and move the
gearshift lever through all of the
gear ranges. Allow sufficient time
for each gear to engage.
3. Latch the gearshift lever in
P(Park), set the parking brake and
leave the engine running.
4. Remove the dipstick, wiping it
clean with a clean, dry rag.
5. Install the dipstick.
6. Remove the dipstick and inspect
the fluid level.
Maintenance and care
173
Page 206 of 224
such as antennas, before entering
a car wash.
²After washing, apply the brakes
several times to dry them.
Waxing your vehicle
The best way to determine when
the paintwork needs waxing is by
noting when water stops beading
on the surface. This could be every
three or four months, depending
on operating conditions.
Use only carnauba or
synthetic-based waxes. Remove
any bugs and tar before waxing
vehicle. Use cleaning fluid or
alcohol with a clean cloth to
remove. Use tar remover to
remove any tar spots.
Repairing paint chips
Minor scratches or paint damage
from road debris may be repaired
with touch-up paint, paint repair
foil or aerosol paint spray from the
Ford accessory line. Observe the
application instructions on the
products.
Remove particles such as bird
droppings, tree sap, insect
remains, tar spots, road salt and
industrial fallout immediately.
com_waxing_vehicle.01
com_repairing_chips
com_wheels_cleaning.01
Maintenance and care
207
Page 214 of 224
SPECIFICATIONS
Lubricant specifications
Item Ford part nameFord part
numberFord
specification
Windshield
washer fluid
reservoirFord Ultra-Clear
Windshield
Washer Fluid
ConcentrateC9AZ-19550-AA
OR -BAESR-M17P5-A
Body hinges,
latches, door
striker plates
and rotors, seat
tracks, fuel filler
door hinge and
spring, hood
latch, auxiliary
latchMulti-Purpose
GreaseD7AZ-19584-AA
OR
D0AZ-19584-AAESR-M1C159-A
AND
ESB-M1C93-B
Lock cylinders,
swing-away
spare tire carrier
padlockPenetrating
LubricantE8AZ-19A501-B ESB-M2C75-B
Parking brake
linkage pivots
and clevisesPremium Life
Long GreaseXG-1-C ESA-M1C75-B
Brake master
cylinderHigh
Performance
DOT 3 Brake
FluidC6AZ-19542-AA ESZ-M6C25-A
Brake pedal
pivot points and
clevisesEngine Oil
SAE-10W- WSS-M2C153-F
exd_lubricant_specifications
Capacities and specifications
215
Page 216 of 224
Item Ford part nameFord part
numberFord
specification
Speedometer,
parking brake
cableSpeedometer
Cable LubricantE6TZ-19581-A ESF-M1C160-A
Engine oil filter Motorcraft
Long Life
Oil Filter(FL-1A)
D9AZ
-6731-AES-E1ZE
-6714-AA
Disc brake
caliper railsDisc Brake
Caliper Slide
GreaseD7AZ-19590-A ESA-M1C172-A
Accelerator
throttle lever
and
transmission
kickdown lever
ball studsPremium Long
Life GreaseXG-1-C ESA-M1C175-B
Ford
conventional
and traction lock
rear axleMotorcraft High
Performance
Synthetic Rear
Axle LubeF1TZ-19580-B WSL-M2C192-A
Ford front axle Thermally
Stable
Motorcraft Front
Axle LubricantXY-75W90-QL WSP-M2C201-A
Transfer case -
Four wheel
driveMotorcraft
MERCONT
Automatic
Transmission
FluidXT-2-QDX MERCONT
Exhaust control
valveRust penetrant
and inhibitorF219A501-A ESR-M99C56-A
Capacities and specifications
217
Page 221 of 224
Air bag supplemental restraint
system ..........................................87
and child safety seats ..............88
description ................................87
disposal ......................................91
indicator light ...........................90
passenger air bag .....................89
Air cleaner filter .......................179
Air conditioning
auxiliary heater and air
conditioner ................................37
Air suspension ...........................111
Anti-theft system ........................67
Battery .......................................176
jumping a disabled battery ....151
Brakes ........................................107
adjustment ..............................107
anti-lock ...................................107
fluid, checking and adding ....162
Brake-shift interlock .................117
Break-in period .............................3
Bulbs, replacing .................198,205
headlamps ...............................199
rear lamps ...............................204
specifications ..........................205
Capacities for refilling fluids ...213,
215
Changing a tire .........................147
Cleaning your vehicle ...............206
engine compartment ..............208
fabric ........................................211
instrument panel ....................211
plastic parts ............................209
tail lamps .................................210
washing ....................................206
waxing .....................................207
wheels ......................................208
Climate control system .........27,28
air conditioning ...............32,33,34
defrosting ..................................65
heating .......................................33Compass, electronic
calibration .................................52
set zone adjustment .................52
Console, description ...................63
Controls .......................................64
Defrost
windshield .................................34
Emission control system ..........194
Engine .................................158,218
Engine block heater .................104
Engine coolant ..........................165
checking hoses .......................168
disposal ....................................167
refill capacities ........................167
Engine oil
changing oil and oil filter .......162
specifications ..........................159
Entry system
illumination ...............................54
Exhaust fumes ..........................106
Fail safe cooling ........................169
Floor mats ..............................65,66
Foglamps ..............................20,203
Four-Wheel Drive vehicles
control trac .............................119
special driving instructions ...120,
121
Fuel
calculating fuel economy .......193
improving fuel economy ........133
octane rating ...........................191
quality ......................................191
safety information relating to
automotive fuels .....................189
Fuel pump shut-off switch .......134
Gauges, Electronic ......................14
GVWR (Gross Vehicle Weight
Rating) .......................................123
Hazard flashers .........................134
Hitch ..........................................131
Identification Number, Vehicle
(VIN) ..........................................219
Index
222