check engine light FORD EXPEDITION 2006 2.G Quick Reference Guide

2
ABS Warning Lamp
This lamp illuminates briefly when the
ignition is turned to the ON position.
In an emergency, apply continuous
force on the brake to prevent wheel
lock when braking on slippery surfaces do
notpump your brakes. Any pulsation or noise
you may feel or hear is normal.
Service Engine Soon Lamp
This lamp illuminates briefly to
ensure the system is functional. If
the lamp comes on after the engine
is started, refer to your Owner’s
Guide. To help prevent activation, always
secureyour fuel cap by turning it clockwise 1/4
of a turn until at least a few clicks are heard.
Please note that if the fuel cap is not properly
secured, the warning "Check Fuel Cap" will be
displayed on the optional message center. The
warning will be reset once the cap is properly
tightened and your vehicle is driven a short
distance. If your vehicle is not equipped with a
message center, the Service Engine Soon lamp
will illuminate.
Hazard Flasher Control
Press to activate all hazard flashers simultaneously
in an emergency to warn traffic of vehicle
breakdown, approaching danger,etc. Press the
control again to turn the flashers off. The hazard
flashers can be operated when the ignition is off.
Message Center (if equipped)
Please see “Additional Features” for more details.
Air Flow Adjust
You can direct or shut off the air flow from the
instrument panel registers. Turn the steel
portion on the round register module either
clockwise or counterclockwise with the vents
open to adjust the airflow. Close the vents flat
to shut off the air flow.
1
4
5
6
Turn Signal and
Wiper/Washer
Control
3ABS
Warning
Lamp
Service
Engine Soon
LampAudiophile
SatelliteReady InDash
Six CD Radio
(if equipped)
11Gearshift/Overdrive
Control
10Control Trac
FourWheel
Drive Control
(if equipped)
13Speed
Control
12Steering
Wheel Controls
(if equipped)
5Hazard
Flasher
Control
15Hood
Release
9Rear Window
Defroster
4
Audiophile SatelliteReady
InDash Six CD Radio (if equipped)
Please see reverse side for more details.
Rear Window Defroster
Press to activate rear window defrost. The
rear defrost indicator will illuminate. When
in operation, the rear window defroster
also defrosts the side view mirrors. The rear
window defroster will automatically turn
off after approximately 10 minutes of
operation. Press the control again to
reengage if needed.
Control Trac FourWheel Drive Control (if equipped)
2H (2WD HIGH) delivers power to
the rear wheels only, and is the
optimum position for
smoothness and fuel economy.
A4WD (4X4 AUTO) automatically
delivers power to all four wheels,
as required, for increased traction. 4H (4X4
HIGH) provides mechanically locked fourwheel
drive power to all four wheels. 4L (4X4 LOW)
provides mechanically locked fourwheel drive
when extra power at reduced speeds is required.
To shift from 2H to A4WD or 4H, move the
control at any forward speed up to 55 mph
(88 km/h). To shift from A4WD to 4H, move the
control at a stop or while driving at any speed. To
shift to or from 4L, bring the vehicle to a stop and
keep the brake pedal depressed. Next, place the
gearshift in N (Neutral), and then move the
control to 4L.
When shifting from one fourwheel drive position
to the next, a mechanical noise may be heard. This
is normal and no service should be required.
Gearshift/Overdrive Control
Overdrive is the normal drive
position for the best fuel
economy. Only deactivate
(O/D OFF) overdrive when:
drivingwith a heavy load,
towing a trailer up or
down steep hills, or when
additional engine braking is desired. To
83
AdvanceTracTM with RSC(if equipped)
The AdvanceTrac™ with Roll
Stability Control (RSC) system
provides stability enhancement
features for certain driving
situations when driver assistance
is needed. It helps your vehicle
maintain traction when driving on slippery
and/or hilly road surfaces. If your vehicle
should become stuck, tryswitching the
system off by pressing the button on the
center console.
Keyless Entry System (if equipped)
With this control you can lock or unlock
all doors without using a key. First, enter
your fivedigit program code and then
press the corresponding quick key:
Unlock all doors = 34
Lock all doors = 78 and 90
simultaneously
Heated and Cooled Seats(if equipped)
The driver and passenger heated and
cooled seat buttons ar
e located on the
climate control. Press the heated seat
button once for full heat, twice for
medium heat and three times for low
heat. Pressing a fourth time will turn off
this feature.
Note:Heated seats will turn
offautomatically after 15 minutes of use.
Press the cooled seat button once for full
cool, twice for medium cool and a third
time for low cool. Pressing a fourth time
will turn off this feature.
Note:Cooled
seats will automatically turn off after 30
minutes of use.
Message Center (if equipped)
The message center
displays important
vehicle information
through a constant monitor of vehicle systems
(with the ignition in the ON position). The
system will notify you of potential vehicle
problems with a display of system warnings
followed by a long indicator chime. You may
select display features on the message center
by pressing the Info or Setup buttons. The
Reset button may be used to reset select
functions in the Info and Setup menus.
For complete details on the message center
display features, please consult your
Owner’s Guide.
Reverse Sensing System (RSS) (if equipped)
This sonar and radar system sounds a tone to
warn the driver if an obstacle is detected
within approximately 6 feet (2 m) behind the
rear bumper while the vehicle moves in
reverse at speeds less than 3 mph (5 km/h).
RSS defaults to ON, but can be disabled
using the message center functions when
the ignition is ON, and the gearshift is in R (Reverse).
Tire Pressure Monitoring System (TPMS)(if equipped)
Using radiofrequency pressure sensors, this
system monitors tire pressure on all road tires
and provides the driver with a yellow warning
light when air needs to be added. Message
center equipped vehicles provide additional
warning messages.
The TPMS warning light
will reset itself (turn off) after the tires are
set to specification and the vehicle is either
parked up to 1 hour or by driving the vehicle
above 20 mph (30 km/h) for two minutes.
Note:Outside temperature affects tire
pressure. Please consult your Owner’s Guide.
8
14
Power Adjustable
Foot Pedals (if equipped)
In order to help you fully appreciate the
countless features of your new Expedition,
we invite you to explore this easytouse
Quick Reference Guide.
This vehicle handles differently from an
ordinary passenger car in driving
conditions which may occur on streets
and highways and offroad. DRIVE
WITH CARE AND WEAR A SAFETY BELT AT ALL TIMES. Ford urges
you to read the Owner’s Guide and Driving Your SUV or Truck
Supplement for further information on safe driving precautions
and instructions.
Message
Center
(if equipped)
1
6
Headlamp
and Panel
Dimmer Control
9
7
Headlamp and Panel Dimmer Control
Rotate clockwise to
the first position to
turn on the parking
lamps. Rotate to the
second position to also
turn on the headlamps. Rotate counterclockwiseto activate the autolamp, which provides
lightsensitive automatic onoff control of
the exterior lights and keeps them on for a
short period of time after the ignition is
turned OFF. When the control is in any
position except high beams or off, pull the
control toward you to activate the foglamps.
Turn Signal and Wiper/Washer Control
Push down
to activate
the left
turn signal,
or up to activate the right turn signal. On
equipped vehicles, the lower portion of the
corresponding side view mirror will blink to
provide an additional warning to other
drivers that your vehicle is about to turn.
For front wiper operation, rotate the ring
on the left to the desired interval, low or
highspeed position. When in the
intermittent position, rotate the control up
for fast, or down for slow inter
vals. The
speedsensitive feature also allows the wipers
to adjust automatically as the vehicle’s speed
changes when the wiper control is set on the
intermittent settings. Push the end of the
stalk briefly for a single wipe (no wash).
Push and hold to activate the washer.
The ring on the right operates the rear
window wiper.Rotate the control to INT 2
(normal speed), INT 1 (intermittent), or
washer position.
For extended wiper blade quality, occasional
cleaning of the wiper blades is required.
2
deactivate, press the switch located on the end
of the gearshift lever.
Note:The transmission shift strategy will
slightly delay transmission upshifts in cold
weather to decrease the time required to
warm up the engine and produce heat in
the passenger compartment.
Steering Wheel Controls (if equipped)
For audio control operation, press the
control with the musical note to select
which media to play. Depending on the
mode, press MEM to select a preset station,
the next selection on a tape, or the next
track on a disc. Use VOL to adjust volume.
For climate control operation, press TMP up
or down to adjust temperature. Press the
control with the fan icon up or down to
adjust fan speed.
Speed Control
To operate, the speed control
must be ON and the vehicle
speed must be greater than
30 mph (48 km/h). To set a
speed, press SET +. To set a
higher speed, press SET +
again. To set a lower
speed, press CST .
Pressing RES will return to
apr
eviously set speed. To
turn the speed control off,
press the OFF button, or depress the brake
pedal to disengage.
Power Adjustable Foot Pedals (if equipped)
Press and hold the rocker control
to adjust the accelerator and
brake pedal toward you or away
from you. Adjust the pedals
only when the vehicle is stopped
and the gearshift lever is in the
P (Park) position.
Hood Release
Pull the hood release handle toward you.
Next, release the auxiliary latch located
under the front center of the hood. Lift the
hood until the lift cylinders hold it open.
10
13
14
15
11
12
Air Flow
Adjust7
EXPEDITION
Quick Reference Guide
2006 2006model