spare wheel FORD EXPEDITION 2007 3.G User Guide

FORD EXPEDITION 2007 3.G User Guide EXPEDITION 2007 3.G FORD FORD https://www.carmanualsonline.info/img/11/4922/w960_4922-0.png FORD EXPEDITION 2007 3.G User Guide

Page 191 of 328

FORD EXPEDITION 2007 3.G User Guide When you believe your system is not operating properly
The main function of the Tire Pressure Monitoring System is to warn you
when your tires need air. It can also warn you in the event the system is

Page 192 of 328

FORD EXPEDITION 2007 3.G User Guide Low Tire Pressure
Warning LightPossible cause Customer Action Required
Flashing Warning
LightSpare tire in use Your temporary spare tire is in
use. Repair the damaged road
wheel and re-mount it on the

Page 250 of 328

FORD EXPEDITION 2007 3.G User Guide Fuse/Relay
LocationFuse Amp
RatingPower Distribution Box
Description
61 — A/C clutch diode
62 — Fuel pump diode
63 15A* Trailer tow connector (back-up
lamp)
64 — Not used
65 10A* Air suspension

Page 251 of 328

FORD EXPEDITION 2007 3.G User Guide The use of tire sealants may damage your tires. The use of tire
sealants may also damage your Tire Pressure Monitoring System.
If your vehicle is equipped with a Tire Pressure Monitoring System,
refer

Page 252 of 328

FORD EXPEDITION 2007 3.G User Guide Use of one of the dissimilar spare tires listed above at any one wheel
location can lead to impairment of the following:
•Handling, stability and braking performance
•Comfort and noise
•Ground c

Page 253 of 328

FORD EXPEDITION 2007 3.G User Guide Spare tire information
Note:If your vehicle is equipped with the tire pressure monitoring
system (TPMS), the system indicator light will illuminate when the spare
is in use. To restore the full functi

Page 254 of 328

FORD EXPEDITION 2007 3.G User Guide Removing the spare tire
1. Fold the rear seat down. Refer to
Rear seatsin theSeating and
safety restraintschapter.
2. Remove the jack handle and
winch extension from the tray and
assemble them.
3. Ope

Page 255 of 328

FORD EXPEDITION 2007 3.G User Guide 1. Park on a level surface, activate
hazard flashers and set the parking
brake.
2. Place gearshift lever in P (Park),
turn engine OFF and block the
wheels (both front or both rear) on
the opposite end

Page 256 of 328

FORD EXPEDITION 2007 3.G User Guide 6. Position the jack according to the
jack locator arrows found on the
frame and turn the jack handle and
extension tool assembly clockwise.
Note:Use the frame rail as the
jacking location point, NOT

Page 257 of 328

FORD EXPEDITION 2007 3.G User Guide To lessen the risk of
personal injury, do not put
any part of your body under the
vehicle while changing a tire. Do
not start the engine when your
vehicle is on the jack. The jack is
only meant for ch
Page:   < prev 1-10 11-20 21-30 next >