heating FORD FUSION 2010 User Guide

Whenever coolant has been added, the coolant level in the coolant
reservoir should be checked the next few times you drive the vehicle. If
necessary, add enough 50/50 concentration of engine coolant and
distilled water to bring the liquid level to the proper level.
If you have to add more than 1.0 quart (1.0 liter) of engine coolant per
month, have your authorized dealer check the engine cooling system.
Your cooling system may have a leak. Operating an engine with a low
level of coolant can result in engine overheating and possible engine
damage.
Recycled engine coolant
Ford Motor Company does NOT recommend the use of recycled engine
coolant since a Ford-approved recycling process is not yet available.
Used engine coolant should be disposed of in an appropriate
manner. Follow your community’s regulations and standards for recycling
and disposing of automotive fluids.
Coolant refill capacity
To find out how much fluid your vehicle’s cooling system can hold, refer
toMaintenance product specifications and capacitiesin this chapter.
Fill your engine coolant reservoir as outlined inAdding engine coolant
in this section.
Severe climates
If you drive in extremely cold climates (less than –34°F [–36°C]):
•It may be necessary to increase the coolant concentration
above 50%.
•NEVER increase the coolant concentration above 60%.
•A coolant concentration of 60% will provide freeze point
protection down to -62°F [-52°C]. Increased engine coolant
concentrations above 60% will decrease the overheat
protection characteristics of the engine coolant and may cause
engine damage.
•If available, refer to the chart on the coolant container to
ensure the coolant concentration in your vehicle will provide
adequate freeze protection at the temperatures in which you
drive in the winter months.
Maintenance and Specifications
293
2010 Fusion(fsn)
Owners Guide, 4th Printing
USA(fus)
ProCarManuals.com

Low fluid level
Do not drive the vehicle if the fluid
level does not show at all on the
dipstick.
Driving the vehicle with less than
the recommended fluid level may result in transmission failure. An under
fill condition of transmission fluid may cause shift and/or engagement
concerns and/or possible damage to the transmission.
High fluid level
Fluid levels above the normal
operating range may result in
transmission failure. An overfill
condition of transmission fluid may
cause shift and/or engagement
concerns and/or possible damage to
the transmission.
High fluid levels can be caused by an overheating condition.
Adjusting automatic transmission fluid levels
Before adding any fluid, make sure the correct type is used. The type of
fluid used is normally indicated on the dipstick and also in the
Maintenance product specifications and capacitiessection in this
chapter.
Note:Only one ATF fluid specification has been tested and approved for
use with the automatic 6-speed: Premium Automatic Transmission fluid.
MERCONfluids cannot be used with the automatic 6-speed without
damage or voiding warranty.
Use of a non-approved automatic transmission fluid may cause
internal transmission component damage.
If necessary, add fluid in 1/2 pint (250 ml) increments through the filler
tube until the level is correct.
If an overfill occurs, excess fluid should be removed by an authorized
dealer.
An overfill condition of transmission fluid may cause shift and/or
engagement concerns and/or possible damage.
Do not use supplemental transmission fluid additives, treatments or
cleaning agents. The use of these materials may affect transmission
operation and result in damage to internal transmission components.
Maintenance and Specifications
312
2010 Fusion(fsn)
Owners Guide, 4th Printing
USA(fus)
ProCarManuals.com

High fluid level
Type A
Type B
Fluid levels above the zone, identified by the arrows in the above figures,
may result in transmission failure. An overfill condition of transmission
fluid may cause shift and/or engagement concerns and/or possible
damage.
High fluid levels can be caused by an overheating condition.
Adjusting automatic transmission fluid levels
Before adding any fluid, make sure the correct type is used. The type of
fluid used is normally indicated on the dipstick blade. Refer to
Maintenance product specifications and capacitiesin this chapter.
Use of a non-approved automatic transmission fluid may cause
internal transmission component damage.
If necessary, add fluid in 1/2 pint (250 ml) increments through the filler
tube until the level is correct.
Type A
Type B
If an overfill occurs, excess fluid should be removed by an authorized
dealer.
DO NOT ADD
ADD (CHECK HOT)
DO NOT ADD
ADD (CHECK HOT)
Maintenance and Specifications
315
2010 Fusion(fsn)
Owners Guide, 4th Printing
USA(fus)
ProCarManuals.com

C
Capacities for refilling fluids ....321
CD ................................................28
Cell phone use ..............................8
Changing a tire .........................246
Child safety seats ......................154
attaching with tether straps ..162
in front seat ............................155
in rear seat ..............................155
LATCH .....................................160
recommendations ...................152
Child safety seats - booster
seats ...........................................165
Cleaning your vehicle
engine compartment ..............269
instrument panel ....................271
interior .....................................272
plastic parts ............................270
washing ....................................267
waxing .....................................268
wheels ......................................268
wiper blades ............................271
Climate control (see Air
conditioning or Heating) ......47, 50
Clutch
fluid ..........................................310
operation while driving ..........217
recommended shift speeds ....217
Compass, electronic ....................74
calibration .................................75
set zone adjustment .................75
Console ........................................76
overhead ....................................74
Controls
power seat ...............................112
steering column ........................84Coolant
checking and adding ..............289
refill capacities ................293, 321
specifications ..........................321
Cross Traffic Alert ....................223
Cruise control (see Speed
control) ........................................81
Cupholder(s) .............................120
Customer Assistance ................236
Ford Extended Service
Plan ..........................................331
Getting assistance outside the
U.S. and Canada .....................264
Getting roadside assistance ...236
Getting the service you
need .........................................260
Ordering additional owner’s
literature .................................265
Utilizing the
Mediation/Arbitration
Program ...................................264
D
Daytime running lamps (see
Lamps) .........................................56
Defrost
windshield .................................50
Dipstick
automatic transmission
fluid ..................................310, 313
engine oil .................................281
Driving under special
conditions ..................216, 230, 232
sand .........................................231
snow and ice ...........................233
through water .................231, 234
Index
335
2010 Fusion(fsn)
Owners Guide, 4th Printing
USA(fus)
ProCarManuals.com

flash to pass ..............................57
high beam .................................57
replacing bulbs .........................62
turning on and off ....................55
Heating
heating and air conditioning
system .................................47, 50
manual heating and air
conditioning system .................45
Hood ..........................................276
I
Ignition ...............................198, 325
Illuminated visor mirror .............73
Infant seats
(see Safety seats) .....................154
Inspection/maintenance (I/M)
testing ........................................308
Instrument panel ........................77
cleaning ...................................271
cluster ........................................12
lighting up panel and
interior .......................................57
J
Jack ............................................246
positioning ...............................246
storage .....................................246
Jump-starting your vehicle ......253
K
Keyless entry system
autolock .....................................89
keypad .....................................100
locking and unlocking doors ..101
programming entry code .......100Keys .....................................88, 103
positions of the ignition .........198
L
Lamps
autolamp system .......................55
bulb replacement
specifications chart ..................61
daytime running light ...............56
fog lamps ...................................56
headlamps .................................55
headlamps, flash to pass ..........57
instrument panel, dimming .....57
interior lamps .....................59, 62
replacing bulbs .........................62
LATCH anchors .........................160
Lights, warning and indicator ....12
anti-lock brakes (ABS) ..........204
Load limits .................................190
Locks
autolock .....................................89
childproof ..................................93
doors ..........................................89
Lubricant specifications ...........321
Lug nuts ....................................251
Lumbar support, seats .............110
M
Manual transmission .................217
fluid capacities ........................321
lubricant specifications ..........321
reverse .....................................218
Message center .....................18–19
english/metric button ...............23
system check button ................21
warning messages .....................24
Index
337
2010 Fusion(fsn)
Owners Guide, 4th Printing
USA(fus)
ProCarManuals.com