lock FORD MONDEO 2006 2.G Owner's Manual

Downloaded from www.Manualslib.com manuals search engine ARMING THE ENGINE
IMMOBILISER
The system is armed five secondsafter switching off the ignition. Theindicator lamp in the clock will flash.
DISARMING THE ENGINE
IMMOBILISER
Switching on the ignition disarms thesystem if the correct code isrecognised. The indicator lamp in theclock illuminates for approximatelythree seconds and thenextinguishes.
If the indicator lamp flashes forapproximately one minute and thenrepeatedly at irregular intervals, thesystem did not recognise the keycode. Remove the key and try again.
If a key with an incorrect code wasused, a waiting period of about 20seconds is required before startingthe vehicle with a correctly codedkey.
If the engine does not start, a systemmalfunction has occurred. Have thesystem checked by an expertimmediately.
43
Engine immobiliserE70359

Downloaded from www.Manualslib.com manuals search engine ARMING THE ALARM
Note: If the vehicle is locked with thekey, this does not activate the alarmsystem (vehicles with 3.0 l Duractec−VE/-ST or 2.5l Duractec−VE engineand enhanced security).
The system is armed as soon as thevehicle is locked and acts as adeterrent to unauthorised personswho attempt to open the doors,bonnet or luggage compartment, orremove the audio system.
Interior sensors
Note: The interior sensors functioncorrectly only if all windows and thesunroof are completely closed. Inaddition to this, the sensors must notbe covered up. The system shouldnot be activated if any persons,animals or other moving objects areinside the vehicle.
Note: Do not activate the interiorsensors if an additional heatingsystem is used, as the alarm couldotherwise be set off.
The interior sensors monitor anymovement within the vehicle.
The interior sensors are activatedtogether with the double lockingsystem.
Automatic arming delay
Up to 20 seconds after activating theanti-theft alarm system, it is stillpossible to open the vehicle againwithout triggering the alarm. Afterthat, the anti-theft alarm system willmonitor all doors, the bonnet and thetailgate, provided that they areclosed.
If a door, the bonnet or the tailgate isclosed later, the system will monitorit after 20 seconds.
Alarm
The alarm sounds for 30 seconds ifan unauthorised person opens adoor, the luggage compartment orthe bonnet, or if the interior sensors(optional) register any movementinside the vehicle.
The hazard warning flashers will flashfor five minutes.
Any attempt to start the engine or toremove the audio system sounds thealarm again.
DISARMING THE ALARM
The anti-theft alarm system can bedeactivated at any time – even whenthe alarm is sounding – by unlockingthe driver’s door with the key or withthe remote control.
44
Alarm

Downloaded from www.Manualslib.com manuals search engine The anti-theft alarm system for thetailgate is deactivated when theluggage compartment is unlockedwith a key (4-door models) or theremote control (all models). Afterclosure, the alarm is once againarmed.
Vehicles with 3.0 l Duratec-VE/-ST or 2.5 l Duratec-VEengine
Note: Unlocking a front door with akey will not deactivate this alarm.
On vehicles with enhanced security(certain markets only), the anti-theftalarm system is deactivated bypressing the unlock button on theremote control.
To deactivate with a non-remote key,open the driver’s door with themechanical key. This starts a 12second delay chime before the alarmsounds. During this period the alarmsystem can be deactivated by turningthe key in the ignition to position II.
45
Alarm

Downloaded from www.Manualslib.com manuals search engine ADJUSTING THE
STEERING WHEEL
WARNING
Never adjust the steering wheelwhen the vehicle is moving.
Release the locking lever to adjustthe height of the steering wheel andits distance from the driver.
Return the lever to its original positionto secure the wheel.
See Sitting in the correct position(page 90).
HORN
The horn can also be operated whenthe ignition is off.
AUDIO CONTROL
Select radio, CD or cassette modeon the audio unit.
The following functions can beoperated with the remote control:
Volume
Volume up: Pull the VOL+ switchtowards the steering wheel.
46
Steering wheelE70358 E70360 E70361

Downloaded from www.Manualslib.com manuals search engine LIGHTING CONTROL
Lighting control positions
OffA
Side and tail lampsB
HeadlampsC
Parking lampsD
Parking lamps
Push in and turn anticlockwise.
Autolamps
WARNING
The autolamps feature is anauxiliary system which is notintended to relieve the driver of hisresponsibility for the vehicle’s exteriorlighting.
When the switch is set to AUTO, thedipped beam headlamps will switchon and off automatically dependingon the ambient light.
Note: Main beam can be activatedonly when the autolamps feature hasturned on the headlamps.
If the headlamps switch offautomatically with main beamactivated, the next time theautolamps feature switches on theheadlamps, main beam will still be on.Dipped beam may be selected bypulling the multi-function levertowards the steering wheel.
Main/dipped beam
To switch over pull the lever towardsthe steering wheel.
53
LightingABCE72161 E72162 E72168

Downloaded from www.Manualslib.com manuals search engine Headlamps, side lamps,direction indicators
Note: It is necessary to remove theheadlamp assembly to remove anyof the bulbs.
Removing the headlampassembly
Open the bonnet.
Remove the rotary clip on both endsof the radiator grille and pull out theradiator grille.
Grasp one of the tabs and pull outthe retaining pin. Repeat with theother tab.
Carefully pull out the headlampassembly and disconnect the wiringconnector.
Front direction indicators
21 watt spherical bulb, orange
•Turn the bulb holder anticlockwiseand pull out.
•Turn the bulb under slightpressure anticlockwise andremove it.
•Replace the bulb.
When installing in the reverse order,pay attention to the guide tabs.
Side lamps
5 watt wedge base bulb
58
LightingE72536 E72537 E72538

Downloaded from www.Manualslib.com manuals search engine •Turn the cover anticlockwise, andremove.
•Using a flat-bladed screwdriver,carefully prise out the socket.
•Pull out the bulb and replace it.
When installing in the reverse order,pay attention to the guide tabs.
Opening the headlampassembly
•Disconnect the wiring connector.
•Release the clips on the rear ofthe headlamp assembly andremove the cover.
When installing in the reverse order,make sure the clips engage properly.
Headlamps – dipped beam
H7, 55 watt halogen bulb
•Disconnect the wiring connector.
•Release the wire clip and pull outthe bulb.
•Replace the bulb.
Install in the reverse order.
Headlamps – main beam
H1, 55 watt halogen bulb
59
LightingE72539 E72540 E72541

Downloaded from www.Manualslib.com manuals search engine •Disconnect the wiring connector.
•Release the wire clip and pull outthe bulb.
•Replace the bulb.
Install in the reverse order.
Side repeater indicator
5 watt wedge base bulb
•Slide the lamp assemblydownwards and pull it out.
•Grasp the bulb holder, turn thelamp housing anticlockwise andremove it.
•Pull the bulb out.
Install in the reverse order.
Approach lamps
Please consult an expert.
Fog lamps (vehicles withsport bumpers)
H3, 55 watt halogen bulb
60
LightingE72542 E72543 E72169 E72544

Downloaded from www.Manualslib.com manuals search engine •Loosen the screw in the fog lampbezel. Prise out the fog lampbezel.
•Loosen the screws, and pull outthe lamp assembly.
•Disconnect the wiring connector.
•Pull the bulb out and replace it.
Install in the reverse order.
Fog lamps (ST variants)
H7, 55 watt
•Remove the screws in the foglight bezel.
•Prise out the ring around the lensand the fog light bezel.
•Loosen the screws and pull outthe light assembly.
•Remove the wiring connector.
•Turn the back of the lightassembly anti-clockwise and pullit out.
•Pull the bulb out and replace it.
Install in the reverse order.
Rear lamps (4-door and 5-door)
Open the tailgate.
61
LightingE72545 E72546 E72547

Downloaded from www.Manualslib.com manuals search engine From inside the luggagecompartment, release the rotary clipsof the rear light assembly cover.
Remove the cover.
Press the two red tabs towardseacht other and separate theassembly from the light housing.
Remove the wiring connector.
Direction indicator 21 wattA
Brake/tail lamp 21/4 wattB
Tail lamp 5 wattC
Reversing lamp H1 halogenbulbD
Tail lamp 5 wattE
Rear fog lamp 21 wattF
Turn the bulb anticlockwise underslight pressure, and remove it.
Replace the bulb.
Install in the reverse order. Afterinstallation, check that the lightsoperate correctly.
Rear lamps (Estate)
Open the tailgate.
From inside the luggagecompartment, remove the top rearlight assembly cover. The bottomcover is fastened with clips. Removethe cover.
Unscrew the two wing nuts from thelight assembly. Make sure the wingnuts do not fall into the opening.
Gently pull out the light assembly.
62
LightingE72548 E72549 E72550