clock FORD PROBE 1996 2.G Owners Manual

63
Instrument Panel Controls
[IP00800(ALL)05/95]
The main controls for the climate control system,
clock, and radio are on the instrument panel.
File:pripp.ex
Update:Fri Jun 23 19:37:35 1995

75 [IP23500(ALL)05/95]
quarter page art:0032079-E
Fog lamp button
*
[IP24200(ALL)05/95]
Radio
*
[IP24300(ALL)04/95]
For information about the radio in your vehicle,
refer to theFord Electronic Sound Systems
Operating Guidein this Owner Guide.
*
[IP24400(ALL)04/95]
Clock Controls on Electronic
Radios
*
[IP24500(ALL)05/94]
The electronic radios have a built-in clock. For
complete operating instructions, refer to theFord
Electronic Sound Systems Operating Guidein this
owner guide.
*
[IP24550(ALL)05/92]
Radio Antenna
[IP24600(ALL)05/92]
The radio antenna is mounted on the rear
passenger side quarter panel of the vehicle. It is
a fixed mast antenna and cannot be retracted.
File:pripp.ex
Update:Fri Jun 23 19:37:35 1995

96
*
[FV02400(ALL)04/95]
Power Door Locks (If equipped)
[FV02500(ALL)01/94]
If your vehicle has power door locks, the
controls to lock the doors are below the inside
door handles on each door. When you close the
doors after you set the door locks, the doors
remain locked. If the power mechanism ever
fails, the manual door locks will override the
power controls.
[FV02550(ALL)02/92]
NOTE: Vehicles equipped with power locks
have a safety feature which allows you
to unlock one or both front doors from
either door key lock cylinder. To
unlock the driver's or passenger door
only, insert the key in the door lock
cylinder and turn to the left
(counterclockwise) to the first position.
To unlock the other door at the same
time, simply continue turning the key
to the left to the second position. Both
doors are locked by turning the key to
the right (clockwise).
File:prfvp.ex
Update:Fri Jun 23 19:36:28 1995

124
*
[AS02600(ALL)04/95]
q
Using the ªSCAN/TUNEº button to scan
radio stations
*
[AS02700(ALL)04/95]
Pressing the ªSCAN/TUNEº button once
enters the scan mode (display will indicate
ªSCNº). Pushing the top
ahalf of the
ªSEEKº button will begin the scan mode up
the frequency band, stopping on each
listenable station for approximately five
seconds. Pushing the bottom
bhalf of the
ªSEEKº button will begin the scan mode
down the frequency band, again stopping on
each listenable station for approximately five
seconds.
*
[AS02800(ALL)04/95]
To stop the scan mode on the presently
sampled station press the ªSCAN/TUNEº
button again.
*
[AS03000(ALL)04/95]
q
Setting the Station Memory Preset buttons
%*
[AS03100(ALL)04/95]
Your radio is equipped with 5 station
memory buttons. These buttons can be used
to select up to 5 preset AM stations and 10
FM stations (5 in FM1 and 5 in FM2). Follow
the easy steps below to set these buttons to
the desired frequencies.
*
[AS03200(ALL)04/95]
1. Select a band, then select a frequency.
*
[AS03400(ALL)04/95]
2. Press one of the memory buttons and hold
the button until the sound returns. That
station is now held in memory on that
button.
*
[AS03500(ALL)04/95]
3. Follow the two steps above for each station
memory preset button you want to set.
*
[AS03601(ALL)04/95]
NOTE: If the vehicle's battery is disconnected,
the clock and station memory preset
buttons (if programmed in auto mode)
will need to be reset.
File:prasp.ex
Update:Fri Jun 23 19:35:26 1995

127
*
[AS05300(ALL)04/95]
q
Adjusting speaker fader
*
[AS05400(ALL)04/95]
Fade control allows you to adjust the sound
distribution between the front and rear
speakers. Push the ªAUDIOº button
repeatedly until the display reads ªFADE.º
Push the ª+º side of the ªVOLº button to
shift the sound to the front speakers, and
push the ª-º side to shift the sound to the
rear speakers.
*
[AS05500(ALL)04/95]
NOTE: Illuminated bars in the display show
relative levels of bass and treble and
positions of speaker balance and fader
functions after adjustments are made,
then revert to volume level set.
%*
[AS05600(ALL)04/95]
Clock operation
*
[AS05700(ALL)04/95]
When in the radio mode, push the ªCLOCKº
button to switch from radio frequency to clock.
Only the clock numerals will be displayed in the
clock mode Ð there is no A.M./P.M. indication.
When in the clock mode, the time will be
displayed until the button is pushed again.
However, if you retune the radio while it is in
the clock mode, the new radio frequency will be
displayed for approximately ten seconds and
then change back to clock.
*
[AS05800(ALL)04/95]
When in the CD mode, push the ªCLOCKº
button to change the display from elapsed time
mode to track number mode to clock mode. If
the CD track selection is changed when you are
in the clock or elapsed time mode, the new track
number will be displayed for approximately ten
seconds and then revert back to the previous
mode.
*
[AS05900(ALL)04/95]
To set the clock, simultaneously press the
ªCLOCKº button and either the bottom (
b) half
of the ªSEEKº button to set hours, or the top
(
a) half of the ªSEEKº button to set minutes.
File:prasp.ex
Update:Fri Jun 23 19:35:26 1995

128
*
[AS07000(ALL)04/95]
Using the Controls on Your New Compact
Disc Player
*
[AS07100(ALL)04/95]
Your new Ford Compact Disc Player is capable
of playing 12 cmor8 cm discs, without an
adapter! The Player operates when the power is
on and a disc is inserted (label side up). Handle
the disc by its edge only. (Be sure to read and
follow all of the care and cleaning instructions
underHow To Take Care of and Clean Your CD
Player and Discs.
*
[AS07200(ALL)04/95]
NOTE: If after you insert a disc, the disc is
ejected and ªERRORº begins scrolling
in the display, remove the disc and
reinsert it right side up (label side up).
*
[AS07300(ALL)04/95]
The digital display on your CD player will
either show the track (selection) number or the
elapsed time. (The display mode can be selected
by pressing the ªCLOCKº button.) Indicators for
play (
a), stop (
X) and compression on (ªCº)
are also in the display. (These features are
described later.)
*
[AS07400(ALL)04/95]
Once a disc is inserted, operation of the CD
player will override that of the radio.
*
[AS07500(ALL)04/95]
NOTE: The volume, bass, treble, balance and
fader controls on the radio are also
used with the CD player. Refer to
earlier operating instructions on these
controls.
*
[AS07600(ALL)04/95]
How to insert a disc and begin play
[AS07700(ALL)05/94]
Insert one disc,label side upinto the disc
opening. When inserted, the disc automatically
loads into the unit and play starts at the
beginning of the first track (selection).
*
[AS07800(ALL)04/95]
When the disc reaches the end, the disc player
automatically returns to the beginning of the
disc and resumes playing.
File:prasp.ex
Update:Fri Jun 23 19:35:26 1995

139
*
[AS23900(ALL)04/95]
NOTE: If the vehicle's battery is disconnected,
the clock and station memory preset
buttons (if programmed in auto mode)
will need to be reset.
*
[AS24000(ALL)02/95]
Adjusting the tone balance and speaker
output of your radio
*
[AS24100(ALL)04/95]
q
Increasing or decreasing bass response
*
[AS24225(ALL)05/95]
Push the ªAUDIOº button repeatedly until
the display reads ªBASS.º Push the right (+)
side of the ªVOLUMEº button to increase
bass (more ªlowsº), and push the left (-) side
to decrease bass (less ªlowsº).
*
[AS24300(ALL)04/95]
q
Increasing or decreasing treble response
*
[AS24425(ALL)05/95]
Push the ªAUDIOº button repeatedly until
the display reads ªTREB.º Push the right (+)
side of the ªVOLUMEº button to increase the
treble (more ªhighsº), and push the left (-)
side to decrease treble (less ªhighsº).
*
[AS24500(ALL)08/89]
Speaker features and operation
*
[AS24600(ALL)04/95]
q
Adjusting speaker balance
*
[AS24725(ALL)05/95]
Balance control allows you to adjust the
sound distribution between the right and left
speakers. Push the ªAUDIOº button
repeatedly until the display reads ªBAL.º
Push the right (+) side of the ªVOLUMEº
button to shift the sound to the right
speakers, and push the left (-) side to shift
the sound to the left speakers.
File:prasp.ex
Update:Fri Jun 23 19:35:26 1995

143 %
*
[AS28400(ALL)03/95]
Clock Operation
*
[AS28500(ALL)07/90]
How to view the clock mode
*
[AS28650(ALL)07/93]
Press the ªCLOCKº button to alternate the
frequency and time in the display. In the clock
mode, pressing any radio function will
automatically display the radio frequency for
approximatedly ten seconds before changing
back to the clock mode.
*
[AS28800(ALL)07/90]
How to set the clock
*
[AS28900(ALL)04/92]
1. Turn the radio on.
*
[AS29025(ALL)03/95]
2. Press and hold in the ªCLOCKº button,
press the ªSEEKº button left (
b) to advance
the hours and right (
a) to advance the
minutes.
*
[AS29200(ALL)07/90]
NOTE: The clock displays 12-hour time with
no AM/PM indications.
*
[AS35200(ALL)06/95]
Common Radio Reception Conditions
*
[AS35300(ALL)02/95]
Several conditions prevent FM reception from
being completely clear and noise-free, such as
the following:
*
[AS35400(ALL)04/95]
1. Distance/Strength
*
[AS35500(ALL)02/95]
The strength of the FM signal is directly related
to the distance the signal must travel. The
listenable range of an average FM signal is
approximately 25 miles (40 kilometers). Beyond
this distance, the radio is operating in a fringe
area and the signal becomes weaker.
File:prasp.ex
Update:Fri Jun 23 19:35:26 1995

175
*
[RE05100(ALL)03/95]
Spare Tire Location
[RE05200(ALL)08/91]
The temporary spare tire is stored in the luggage
compartment, under the mat and floorboard.
[RE05300(ALL)01/92]
one third page art:0032099-A
Location of the temporary spare tire and jacking equipment
[RE05650(ALL)01/92]
To remove the jack and the temporary spare,
turn the bolt counterclockwise.
*
[RE07600(ALL)03/95]
Preparing to Change the Tire
*
[RE07700(ALL)02/92]
1. Make sure that your vehicle will not move
or roll. If you have an automatic transaxle,
put the gearshift in P (Park). If you have a
manual transaxle, put the gearshift in 1
(First). Set the parking brake and block the
wheel that is diagonally opposite the tire
that you are changing.
File:prrep.ex
Update:Fri Jun 23 19:34:36 1995

177 [RE08500(ALL)01/92]
4. Loosen the wheel lug nuts by pulling up on
the handle of the wrench one half-turn
counterclockwise. Do not remove the wheel
lug nuts until you raise the tire off the
ground. For information about removing
anti-theft lug nuts, seeRemoving and
Replacing the Anti-Theft Wheel Lug Nutsin
this section.
*
[RE08600(ALL)05/95]
Removing and Replacing the Tire
%*
[RE08700(ALL)11/94]
1. Find the jack notch next to the door of the
tire that you are changing. Put the jack in
the jack notch and turn the handle of the
jack clockwise until the wheel is completely
off the ground.
*
[RE08800(ALL)05/95]
RWARNING
To lessen the risk of personal injury, do
not put any part of your body under the
vehicle while changing a tire. Do not start
the engine when your vehicle is on the
jack. The jack is only meant for changing
the tire.
File:prrep.ex
Update:Fri Jun 23 19:34:36 1995