ECU FORD PROBE 1997 2.G Owner's Manual

186 %
*
[MC03400(ALL)02/96]
Opening the Hood
%*
[MC03500(ALL)02/96]
1. Inside the vehicle, pull the hood release
handle located under the bottom left corner
of the instrument panel.
%*
[MC03600(ALL)02/96]
2. Go to the front of the vehicle and release the
auxiliary latch that is located under the hood
at the center of the vehicle.
[MC03750(ALL)01/96]
3. Lift the hood and set the prop rod in the
hole in the hood marked with an arrow.
*
[MC03800(ALL)02/96]
When you close the hood, make sure the prop
rod is in its retainer and that the hood latches
securely.
[MC03900(ALL)01/96]
half page art:0032100-A
The hood release handle
File:11prmcp.ex
Update:Thu May 16 12:08:53 1996

191 %
*
[MC06500(ALL)01/96]
Checking and Adding Engine Oil
*
[MC06600(ALL)01/96]
Since the proper amount of engine oil is
important for safe engine operation, check the oil
using the dipstick each time you put fuel in
your vehicle. Remember the engine must be off,
the oil must be warm and the vehicle must be
parked on level ground.
%*
[MC06700(ALL)01/96]
Checking the engine oil level:
*
[MC06800(ALL)01/96]
1. Turn the engine off after it has warmed up
and allow a few minutes for the engine oil
to drain back into the oil pan.
*
[MC06900(ALL)01/96]
2. Set the parking brake fully and make sure
that the gearshift is securely latched in P
(Park) (automatic transaxle) or 1 (First)
(manual transaxle).
*
[MC07000(ALL)01/96]
3. Open the hood. Protect yourself from engine
heat.
*
[MC07100(ALL)01/96]
4. Locate the engine oil dipstick (highlighted in
yellow) and carefully pull it out of the
engine.
*
[MC07200(ALL)01/96]
5. Wipe the dipstick clean and put it back into
position, making sure it is fully seated.
[MC07300(ALL)01/96]
one inch art:0032075-A
Engine oil dipstick
File:11prmcp.ex
Update:Thu May 16 12:08:53 1996

201
%*
[MC18100(ALL)01/96]
Automatic Transaxle Fluid
*
[MC18200(ALL)02/96]
Under normal circumstances, you do not need to
check the fluid level of the transaxle, since your
vehicle does not use up transaxle fluid. Refer to
theMaintenance Schedulebooklet for replacement
intervals. However, if the transaxle is not
working properly Ð for instance, the transaxle
may slip or shift slowly, or you may notice
some sign of fluid leakage Ð the fluid level
should be checked.
[MC18300(ALL)01/96]
If you must check the transaxle fluid in an
emergency, make sure that your vehicle is on
level ground, start the engine, and move the
gearshift through all of the gears allowing
sufficient time for each position to engage.
Securely latch the gearshift in P (Park). Set the
parking brake and leave the engine running.
[MC18400(ALL)01/96]
Wipe off the dipstick cap, pull the dipstick out
and wipe the indicator end clean. Put the
dipstick back into the filler tube. Make sure the
dipstick is fully seated in the filler tube;
otherwise, you will not get an accurate reading.
Pull the dipstick out and read the fluid level.
[MC18500(ALL)01/96]
The fluid level must be above the lower mark. If
it is not, you should not drive your vehicle until
more fluid is added. Ideally, the fluid level
should be within the specified area of the
dipstick.
[MC18600(ALL)01/96]
NOTE: The fluid level indication on the
dipstick will be different at operating
temperature and room temperature. For
the correct fluid level reading on the
dipstick, follow the appropriate
instructions.
File:11prmcp.ex
Update:Thu May 16 12:08:53 1996

215
*
[MC28860(ALL)01/96]
q
Put the chains on the front tires tightly with
the ends held down securely. Retighten the
chains after driving 1/2 mile (1 km). Follow
the chain manufacturer's instructions.
*
[MC28870(ALL)01/96]
q
Do not drive faster than 30 mph (50 km/h)
or the chain manufacturer's recommended
speed limit, whichever is lower. Avoid
bumps, holes and sharp turns. If you can
hear the chains rub or bang against your
vehicle, remove the chains to prevent damage
to your vehicle.
*
[MC28880(ALL)01/96]
q
Tire chains may affect vehicle handling. Drive
carefully and avoid hard braking.
*
[MC28890(ALL)01/96]
q
Do not use chains on temporary spare tires.
They may damage the vehicle and the tire.
*
[MC29025(ALL)01/96]
q
Remove tire chains at the first opportunity
after using them on snow and ice. Do not use
the chains on dry roads.
%
*
[MC30000(ALL)01/96]
Filling the Fuel Tank
[MC30050(ALL)03/96]
Fuel filler door release lever
[MC30100(ALL)01/96]
Your vehicle is equipped with a fuel filler door
release. To open the fuel filler door, pull up on
the release lever which is located in front of the
driver's seat and near the door.
[MC30200(ALL)01/96]
Remote Fuel Filler-Lid Release Override
[MC30300(ALL)01/96]
If the release does not operate, open the
hatchback, remove the trim on the left rear side,
reach into the opening and pull the latch toward
the rear (see the service manual for trim
removal). You should wear gloves to protect
your hands from any sharp edges when you use
the fuel filler-lid release override.
File:11prmcp.ex
Update:Thu May 16 12:08:53 1996