tow FORD PROBE 1997 2.G Owners Manual
[x] Cancel search | Manufacturer: FORD, Model Year: 1997, Model line: PROBE, Model: FORD PROBE 1997 2.GPages: 288, PDF Size: 1.64 MB
Page 19 of 288
15 %
*
[IS03800(ALL)05/96]
High Beam Light
*
[IS03900(ALL)03/96]
This light illuminates when the headlamps are
turned to high beam or when you flash the
lights.
*
[IS04000(ALL)01/96]
one inch art:0030174-A
High beam light
%*
[IS04100(ALL)03/96]
Check Engine Warning Light
*
[IS04200(ALL)03/96]
This light illuminates when the electronic engine
control system is not working properly. This is
the computer that controls the operating
conditions of the engine.
*
[IS04300(ALL)01/96]
one inch art:0030175-B
Check engine warning light
[IS04400(ALL)03/96]
This light illuminates briefly when you turn the
ignition to the ON position, but should turn off
when the engine starts. If the light does not
come on when you turn the ignition to the ON
position or if it comes on and stays on when
you are driving, have your vehicle serviced as
soon as possible. This indicates a possible
problem with one of the engine's emission
control systems.You do not need to have your
vehicle towed in.
File:03prisp.ex
Update:Thu May 16 09:43:45 1996
Page 47 of 288
44
*
[AS35600(ALL)08/95]
2. Terrain
*
[AS35700(ALL)08/95]
The terrain (hilly, mountainous, tall buildings) of
the area over which the signal travels may
prevent the FM signal from being noise-free.
*
[AS35800(ALL)11/92]
Repeated pops and hisses which are heard
during an otherwise clear broadcast can occur
near the station because of the ªline of sightº
characteristic of FM radio waves.
*
[AS35900(ALL)08/95]
If there is a building or large structure between
the antenna and station, some of the signal
ªbendsº around the building, but certain spots
receive almost no signal. Moving out of the
ªshadowº of the structure will allow the station
to return to normal.
*
[AS36000(ALL)08/95]
When the radio waves are reflected off objects or
structures, the reflected signal cancels the normal
signal, causing the antenna to pick up noise and
distortion. Cancellation effects are most
prominent in metropolitan areas, but also can
become quite severe in hilly terrain and
depressed roadways.
*
[AS36100(ALL)08/95]
To minimize these conditions, a stereo/mono
blend circuit has been incorporated into this
system. This feature automatically switches a
weak stereo signal to a clearer monaural signal,
which improves the quality of reception.
*
[AS36200(ALL)08/95]
Several sources of static are normal conditions
on AM frequencies. These can be caused by
power lines, electric fences, traffic lights and
thunderstorms.
*
[AS36300(ALL)08/95]
Another reception phenomenon isStrong Signal
Capture and Overload. This can occur when
listening to a weak station and when passing
another broadcast tower. The close station may
capture the more distant station, although the
File:04prasp.ex
Update:Mon Jun 3 10:03:33 1996
Page 48 of 288
45
displayed frequency does not change. While
passing the tower, the station may switch back
and forth a few times before returning to the
original station.
*
[AS36400(ALL)03/96]
When several broadcast towers are present
(common in metropolitan areas), several stations
may overload the receiver, resulting in
considerable station changing, mixing and
distortion.
*
[AS36500(ALL)08/95]
Automatic gain control circuitry for both AM
and FM bands has been incorporated into this
system to reduce strong signal capture and
overload.
%
*
[AS36600(ALL)08/95]
All About Radio Frequencies
*
[AS36700(ALL)08/95]
The Federal Communications Commission (FCC)
and the Canadian Radio Telecommunications
Commission (CRTC) establish the frequencies
that AM and FM radio stations may use for
their broadcasts. The allowable frequencies are,
AM: 530, 540...1600, 1610 kHz in 10 kHz steps;
FM: 87.9, 88.1...107.7, 107.9 MHz in 0.2 MHz
steps.
*
[AS36800(ALL)08/95]
Not all frequencies will be assigned to a given
area. This radio will tune to each of these
frequencies using manual tune and no fine
tuning is necessary as radio stations may not use
other frequencies.
*
[AS36900(ALL)08/95]
Some FM radio stations advertise a
ªrounded-offº frequency which is not the
frequency they actually broadcast on. For
example, a radio station that is assigned a
frequency of 98.7 MHz may call itself ªRadio 99º
even though 99.0 MHz is not an allowable FM
broadcast frequency.
File:04prasp.ex
Update:Mon Jun 3 10:03:33 1996
Page 55 of 288
52
*
[CF05800(ALL)05/96]
Tips for controlling the temperature in your
vehicle
*
[CF05900(ALL)01/96]
q
To vary the temperature inside your vehicle,
move the temperature selector toward the red
area for warmer air and toward the blue area
for cooler air.
*
[CF06000(ALL)01/96]
q
If you drive with the fan off and the
windows closed, the windows may fog up.
To prevent fogging:
[CF06100(ALL)01/96]
1. Set the function selector control to VENT,
MIX, FLOOR or theVposition.
*
[CF06200(ALL)01/96]
2. Set the desired temperature.
*
[CF06300(ALL)04/96]
3. Set the
H(fan speed) to the desired
position.
*
[CF06400(ALL)01/96]
q
Do not put objects under the front seats that
will interfere with the flow of air to the back
seats.
*
[CF06500(ALL)01/96]
q
Remove any snow, ice, or leaves from the
area below the windshield on the outside of
your vehicle. They could block the air intake.
File:05prcfp.ex
Update:Tue Jun 11 11:03:33 1996
Page 68 of 288
65 [CF17800(ALL)01/96]
half page art:0032085-B
Manual headlamp retractors located behind the headlamps
*
[CF17900(ALL)08/95]
High Beams and Flashing the Lamps
*
[CF18000(ALL)01/96]
To turn on the high beams, turn the headlamp
control knob to the headlamp ON position and
push the turn signal lever away from you until
it latches. When the high beams are ON, the
high beam indicator light on the instrument
panel comes on.
*
[CF18100(ALL)01/96]
To turn off the high beams, pull the lever
toward you until it latches. The high beam
indicator light turns off.
File:05prcfp.ex
Update:Tue Jun 11 11:03:33 1996
Page 69 of 288
66 %
*
[CF18200(ALL)01/96]
Flashing the Lights
*
[CF18300(ALL)01/96]
To flash the headlamps, pull the lever toward
you for a moment and then release it. The
headlamps will flash whether the headlamp
knob is in the on or off position.
[CF18400(ALL)01/96]
quarter page art:0032034-A
Highbeam and flash-to-pass operation
[CF18500(ALL)01/96]
If the headlamps are retracted when you pull
the lever toward you, they will pop up and
flash.
File:05prcfp.ex
Update:Tue Jun 11 11:03:33 1996
Page 72 of 288
69 [CF19700(ALL)01/96]
Interval Wipers (If equipped)
[CF19800(ALL)01/96]
In addition to two speed wipers, your vehicle
may have wipers that you can set to operate at
varying intervals. For example, you can set the
interval so they wipe less often when it drizzles
and more often in heavier rain.
[CF19900(ALL)01/96]
quarter page art:0032035-B
Variable interval wiper control
[CF19950(ALL)01/96]
To set the interval wipers, pull the lever down
to the first position. Turn the ring on the lever
to the frequency of wiper operation you desire.
*
[CF20000(ALL)01/96]
Windshield Washer
[CF20100(ALL)01/96]
To clean the windshield, pull the wiper lever
toward you. Washer fluid sprays until the lever
is released.
[CF20200(ALL)02/96]
quarter page art:0032057-B
Windshield washer/control
File:05prcfp.ex
Update:Tue Jun 11 11:03:33 1996
Page 90 of 288
87 [CF50800(ALL)03/96]
The remote keyless entry system is equipped
with an illuminated entry system.
[CF50900(ALL)03/96]
When the system is activated, the dome lamp
will illuminate and will stay lit for
approximately 25 seconds. The dome lamp will
shut off when the doors are closed.
%*
[CF51000(ALL)03/96]
Replacing the Batteries
*
[CF51100(ALL)01/96]
The remote entry transmitter is powered by two
coin type three-volt lithium 1616
batteries (included) that should last for several
years of normal use. If you notice a significant
decrease in operating range, the batteries should
be replaced. Replacement batteries can be
purchased at most pharmacies, watch stores or
at your Ford or Lincoln-Mercury dealer.
*
[CF51200(ALL)01/96]
NOTE: The operating range of the remote
entry system can also be affected by
weather conditions (such as very cold
temperatures) or structures around the
vehicle (buildings, other vehicles, radio
and TV towers, etc.). Typical operating
range will allow you to be up to 33
feet (10 meters) away from your
vehicle.
[CF51300(ALL)01/96]
one third page art:0032393-A
Opening the remote transmitter
File:05prcfp.ex
Update:Tue Jun 11 11:03:33 1996
Page 101 of 288
98
*
[SS03300(ALL)05/96]
RWARNING
Cargo should always be secured to
prevent it from shifting and causing
damage to the vehicle or harm to
passengers.
*
[SS03400(ALL)01/96]
RWARNING
Do not remove the floor carpet in your
vehicle. Emission controls cause high
exhaust temperatures under the floor.
[SS03500(ALL)01/96]
NOTE: When returning the folding seats to the
upright position, remember to return
rear shoulder belts to their proper
position.
[SS03600(ALL)03/96]
NOTE: Your vehicle has stowage hooks on the
lower rear side trim panel on which to
hook the safety belts when not in use.
Simply hook the tongue slot over the
stowage hook.
%
*
[SS03700(ALL)02/96]
Important Safety Belt Information
*
[SS03800(ALL)05/96]
The use of safety belts helps to restrain you and
your passengers in case of a collision. In most
states and in Canada, the law requires their use.
*
[SS03900(ALL)02/96]
Safety belts provide best restraint when:
*
[SS04000(ALL)02/96]
q
the seatback is upright
*
[SS04100(ALL)02/96]
q
the occupant is sitting upright (not slouched)
*
[SS04200(ALL)02/96]
q
the lap belt is snug and low on the hips
*
[SS04300(ALL)02/96]
q
the shoulder belt is snug against the chest
*
[SS04400(ALL)02/96]
q
the knees are straight forward
File:06prssp.ex
Update:Mon Jun 3 10:07:19 1996
Page 124 of 288
121 [SS19400(ALL)01/96]
7. Double check that the retractor is in the
automatic locking mode. Try to pull more
belt out of the retractor. If you cannot, the
belt is in the automatic locking mode.
[SS19500(ALL)01/96]
half page art:0032387-B
Checking the retractor
[SS19600(ALL)01/96]
8. Check to make sure that the child seat or
infant carrier is properly secured prior to
each use. If the belt is not locked, repeat
steps 4 through 7.
[SS19700(ALL)01/96]
NOTE: To remove the retractor from automatic
lock mode, allow seat belt retract fully
to its stowed position and the retractor
will automatically switch back to the
vehicle sensitive locking mode for
normal adult usage.
File:06prssp.ex
Update:Mon Jun 3 10:07:19 1996