tire size FORD RANGER 1997 2.G Owners Manual
[x] Cancel search | Manufacturer: FORD, Model Year: 1997, Model line: RANGER, Model: FORD RANGER 1997 2.GPages: 361, PDF Size: 3.39 MB
Page 171 of 361
170
*
[GF10445(R)05/96]
When to use 1 (Low)
*
[GF10450(R)05/96]
With the gearshift in the 1 (First) position, maximum engine
braking is provided. This position provides 1 (First) gear
operation only with no automatic upshifts. To obtain upshifts,
the gearshift must be moved out of this position. Use the 1
(First) position to drive up steep grades or to provide maximum
engine braking on downgrades.
*
[GF10455(R)05/96]
Forced Downshifts
[GF10460(R)05/96]
To gain acceleration in
j(Overdrive) or Drive (O/D OFF)
when passing another vehicle, push the accelerator to the floor.
The transmission will downshift to the appropriate gear: fourth,
third, second or first gear.
%*
[GF10490(R)05/96]
Traction-Lok Rear Axle (If equipped)
*
[GF10492(R)05/96]
This axle provides added drive away traction on slippery
surfaces, particularly when one or more wheels are on a surface
with poor traction.
*
[GF10494(R)03/96]
Extended use of other than matching size tires on a
Traction-Lok rear axle could result in a permanent reduction in
effectiveness. This loss of effectiveness does not affect normal
driving and should not be noticeable to the driver.
[GF11300(R)01/96]
Manual Transmission Operation
%*
[GF11400(R)01/96]
Using the Clutch
*
[GF11500(R)01/96]
Make sure the gearshift lever is in the N (Neutral) position and
your right foot is holding down the brake pedal. Then press the
clutch pedal to the floor with your left foot. Manual
transmission vehicles have a starter interlock switch. The starter
will not crank until the clutch pedal is fully depressed. Start the
engine and allow it to idle for a few seconds. Move the
gearshift into 1 (First) or R (Reverse).
File:09ungfr.ex
Update:Thu Mar 20 08:55:24 1997
Page 282 of 361
282
*
[MC27000(R)03/96]
If your vehicle has aluminum wheels, you may demount the full
size, non-temporary spare tire (if so equipped) and remount on
an aluminum wheel to rotate the spare tire into your vehicle's
rotation pattern. Rebalance the wheel.
%*
[MC27300(R)01/96]
Replacing the Tires
*
[MC27400(R)01/96]
Replace any tires that show wear bands. When your tire shows
a wear band, it has only 1/16 inch (2 mm) of tread left.
*
[MC27500(R)01/96]
7-1/2 pica art:0040200-A
A worn-out tire
*
[MC27600(R)02/96]
Because your vehicle's tires may wear unevenly, you may need
to replace them before a wear band appears across the entire
tread.
*
[MC27700(R)03/96]
Your wheels and tires are match-mounted for improved ride.
Before you begin to repair a tire, mark the wheel and tire so
that they are properly aligned when remounted. This will
ensure that the tires will continue to give you the same ride
level.
File:11unmcr.ex
Update:Thu Mar 20 08:58:43 1997
Page 283 of 361
Maintenancean dCare
283
WARNING
Whe nreplacin gful lsiz etires ,neve rmi xradial,
WARNING
Mak esur etha tal lreplacemen ttire sar e of th esam esize,
WARNING
Do no treplac eyou r4x 2tire swit hªhig hperformanceº