FORD SIERRA 1988 2.G Braking System User Guide

FORD SIERRA 1988 2.G Braking System User Guide SIERRA 1988 2.G FORD FORD https://www.carmanualsonline.info/img/11/5452/w960_5452-0.png FORD SIERRA 1988 2.G Braking System User Guide
Trending: wheel bolts, ABS, wheel alignment, open bonnet, lock, ECU, brake pads

Page 11 of 22

FORD SIERRA 1988 2.G Braking System User Guide 15A long thin pair of circlip pliers will now be
required to release the key plate retaining
circlip from the caliper bore (see illustration).
With the circlip removed, the pushrod and key
plate can b

Page 12 of 22

FORD SIERRA 1988 2.G Braking System User Guide Specifications. To do this, fix the measuring
equipment, and rotate the disc, noting the
variation in measurement as the disc is
rotated. The difference between the minimum
and maximum measurements re

Page 13 of 22

FORD SIERRA 1988 2.G Braking System User Guide 3Remove the wheel cylinder.
4Remove the driveshaft but do not refit the
securing bolts to the backplate.
5Remove the backplate.
6If required, prise out the handbrake stop
button.
7Refitting is a rever

Page 14 of 22

FORD SIERRA 1988 2.G Braking System User Guide 4Unscrew the two mounting nuts and spring
washers, and withdraw the master cylinder
from the servo. Cover the master cylinder with
rag or a plastic bag to prevent spillage of
hydraulic fluid on the ve

Page 15 of 22

FORD SIERRA 1988 2.G Braking System User Guide Note: New seals must be used between the
reservoir and the hydraulic unit on reassembly.
Removal
1Disconnect the battery negative lead.
2Depressurise the hydraulic system by
pumping the brake pedal at

Page 16 of 22

FORD SIERRA 1988 2.G Braking System User Guide 7Remove the clip from the hydraulic unit
pushrod on the brake pedal. 
8With an assistant supporting the hydraulic
unit, unscrew the four nuts which secure the
unit to the bulkhead (see illustration).

Page 17 of 22

FORD SIERRA 1988 2.G Braking System User Guide Refitting
9Commence refitting by offering the pump to
the mounting spigot, then reconnecting the
low pressure fluid hose.
10Refit and tighten the pump mounting bolt.
11Reconnect the high pressure flui

Page 18 of 22

FORD SIERRA 1988 2.G Braking System User Guide 4Withdraw the module, and disconnect the
multi-plug (see illustration). 
Refitting
5Refitting is a reversal of removal but on
completion check the operation of the ABS
warning lamp as described in the

Page 19 of 22

FORD SIERRA 1988 2.G Braking System User Guide Removal
1Chock the front wheels, jack up the rear of
the vehicle and support on axle stands (see
“Jacking and Vehicle Support”).
2The load apportioning valve is located on
the right-hand side of t

Page 20 of 22

FORD SIERRA 1988 2.G Braking System User Guide 4A flexible hose must never be installed
twisted, but a slight “set” is permissible to
give it clearance from adjacent components.
This can be achieved by turning the hose
slightly before fitting
Page:   < prev 1-10 11-20 21-30 next >
Trending: wheel bolts, brake, lock, wheel alignment, brake pads, boot, wheel bolt torque