cooling FORD TAURUS 1996 User Guide

278 [SV18300(ALL)11/94]
RWARNING
Never remove the pressure cap while the
engine is running or hot to avoid personal
injury that can be caused by escaping
steam or engine coolant.
[SV18500(ALL)04/95]
1. Before you remove the cap, turn the engine
off and let it cool. Even when the engine is
cool, be careful when you remove the cap.
[SV18600(ALL)02/95]
2. When the engine is cold, wrap a thick cloth
around the cap and turn it slowly
counterclockwise to relieve pressure.
*
[SV18700(ALL)09/95]
3. Step back while the pressure releases.
*
[SV18800(ALL)09/95]
4. When you are sure that all the pressure has
been released, use the cloth to turn and
remove cap.
*
[SV18900(ALL)02/95]
5. Stand away from the reservoir opening. Hot
steam may blow out or hot engine coolant
may even splash out.
*
[SV19000(ALL)09/95]
RWARNING
Failure to follow these instructions could
result in serious personal injury from hot
engine coolant or steam blowout and/or
damage to the engine cooling system or
engine.
*
[SV19050(ALL)09/95]
To find out how much engine coolant mixture
your vehicle's coolant system can hold, seeRefill
capacities for fluidsin the Index.
[SV19100(ALL)04/95]
Add engine coolant only to the coolant
reservoir.If the coolant level is low, add to the
reservoir a 50/50 mixture of water and the type
of engine coolant that Ford specifies. You may
add water by itself only in an emergency, but
you should replace it with a 50/50 mixture as
soon as possible.
File:15fcsvt.ex
Update:Tue Jan 23 13:58:51 1996
ProCarManuals.com

279 [SV19104(ALL)04/95]
Ford Premium Cooling System Fluid is an
optimized formula that will protect all metal and
rubber elastomers used in Ford engines for four
years or 50,000 miles (80,000 km). It is not
necessary and not recommended to use
supplemental coolant additives in your vehicle.
These additives may harm your engine cooling
system. Follow the recommended service interval
for changing your engine coolant.
*
[SV19106(ALL)09/95]
NOTE: When you change or add engine
coolant, it is important to maintain
your engine coolant concentration
between 40%(-11ÊF [-24ÊC]) and 60%
(-62ÊF [-52ÊC]),depending on your local
climate conditions. Below 40% you will
lose freeze protection and above 60%
your engine may overheat on a warm
day.
*
[SV19107(ALL)09/95]
NOTE: Less than 40% of coolant concentration
may cause engine corrosion and
overheating. Plain water may be used
in an emergency only. Replace it with
the specified coolant as quickly as
possible.
*
[SV19108(ALL)09/95]
NOTE: The use of an improper coolant may
void your warranty for the engine
cooling system. Use only a premium,
nationally recognized brand name
engine coolant. Do not use alcohol,
methanol antifreeze or engine coolant
mixed with alcohol or methanol
antifreeze. If you do not use the proper
coolant, the aluminum engine on your
vehicle will corrode.
File:15fcsvt.ex
Update:Tue Jan 23 13:58:51 1996
ProCarManuals.com

280
*
[SV19110(ALL)09/95]
Ford Motor Company expressly authorizes the
Ford Rotunda engine coolant recycling process
and chemicals. Use only Ford Rotunda recycled
engine coolant or an equivalent recycled engine
coolant that is certified by the supplier to meet
Ford specification ESE-M97B44-A.
%*
[SV19112(ALL)09/95]
NOTE: Always dispose of used automotive
fluids in a responsible manner. Follow
your community's standards for
disposing of these types of fluids. Call
your local recycling center to find out
about recycling automotive fluids.
*
[SV19115(ALL)09/95]
Use Ford Premium Cooling System Fluid
E2FZ-19549-AA (in Canada, Motorcraft CXC-8-B)
or an equivalent engine coolant that meets Ford
Specification ESE-M97B44-A.
[SV19150(ALL)11/94]
Have your dealer check the engine cooling
system for leaks if:
[SV19200(ALL)11/94]
q
you have to add engine coolant more than
once a month, or
[SV19250(ALL)11/94]
q
you have to add more than a quart (liter) at a
time
%*
[SV19300(ALL)08/95]
Engine Coolant Drain and Flush
*
[SV19350(ALL)11/94]
Proper procedures for a complete coolant drain
and flush of the cooling system can be found in
theCar Service Manual. Following these
recommended procedures will ensure that the
specified coolant level and a 50/50 or
appropriate mixture of coolant and water is
maintained.
File:15fcsvt.ex
Update:Tue Jan 23 13:58:51 1996
ProCarManuals.com

281
*
[SV19400(ALL)08/95]
Engine Coolant Refill Procedure
*
[SV19450(ALL)01/95]
When the entire cooling system is drained and
refilled, the following procedure should be used
to ensure a complete fill:
[SV19500(ALL)04/95]
q
With the engine OFF and cool, remove the
pressure cap, located on the coolant reservoir.
[SV19550(ALL)04/95]
q
Add a 50/50 mixture of specified coolant and
water to the coolant reservoir. Refer toRefill
Capacitieslater in this chapter for the correct
amount.
[SV19600(ALL)02/95]
q
Continue to fill the reservoir until the coolant
is at the top of the cold fill range.
[SV19650(ALL)04/95]
q
Reinstall the pressure cap until it clicks.
*
[SV19700(ALL)05/95]
q
Start and idle the engine until the radiator
upper hose is warm (this indicates the
thermostat is open and coolant is flowing
through the entire system).
[SV19750(ALL)04/95]
q
Immediately shut off the engine and let cool.
Cautiously remove the pressure cap and add
a 50/50 mixture of specified coolant and
water until the coolant is within the cold fill
range in the coolant reservoir.
[SV19800(ALL)02/95]
q
Reinstall the pressure cap until a click is
heard and felt.
*
[SV19850(ALL)03/95]
q
Check for leaks at the draincock.
*
[SV19900(ALL)03/95]
q
Recheck the engine coolant level, using the
recommended procedure, after one or two
occasions of vehicle use.
File:15fcsvt.ex
Update:Tue Jan 23 13:58:51 1996
ProCarManuals.com

333 %
*
[SV46200(ALL)01/95]
Cooling system
*
[SV46300(ALL)01/95]
q
Protect against freezing temperatures.
%*
[SV46400(ALL)01/95]
Battery
*
[SV46500(ALL)01/95]
q
Check and recharge as necessary.
*
[SV46600(ALL)01/95]
q
Keep connections clean and covered with a
light coat of grease.
%*
[SV46650(ALL)02/95]
q
If storing your vehicle for more than 30 days
without recharging the battery, disconnect the
battery cables to ensure battery charge is
maintained for quick starting. NOTE: If
battery cables are disconnected, it will be
necessary to reset any memory features (eg.
radio presets).
%*
[SV46700(ALL)01/95]
Brakes
*
[SV46800(ALL)01/95]
q
Make sure brakes and parking brake are fully
released.
%*
[SV46900(ALL)01/95]
Tires
*
[SV47000(ALL)05/95]
q
Maintain recommended air pressure.
*
[SV47100(ALL)01/95]
Miscellaneous
*
[SV47200(ALL)01/95]
q
Make sure all linkages, cables, levers and
clevis pins under vehicle are covered with
grease to prevent rust.
*
[SV47300(ALL)05/95]
q
Move vehicles at least 25 feet (10 m) every 15
days to lubricate working parts to prevent
corrosion.
File:15fcsvt.ex
Update:Tue Jan 23 13:58:51 1996
ProCarManuals.com

362 Index
Coolant (see Engine coolant)
checking and adding......... 276
drain and flush............ 280
preparing for storage......... 333
refill capacities............ 328
specifications............. 330
temperature gauge........... 82
Cooling fan............... 256
Cruise control............. 120
Cupholder(s).............. 156
Customer Assistance Center, Ford (U.S.) . . 239
Customer Assistance Centre,
Ford of Canada..........239, 245
D
Dashboard (see Instrument panel)...... 91
Daytime running light system...... 107
Defects, reporting............ 244
Defrost
rear window and side view mirrors. . . 104
windshield............ 95,103
Dipstick
automatic transaxle fluid........ 296
engine oil.............. 273
power steering fluid.......... 300
Disabled vehicle (see Towing)...... 233
Dispute Settlement Board........ 240
Doors................. 125
childproof locks............ 125
door ajar warning light......... 77
lubricant specifications......... 330
Driving under special conditions
bad weather............. 206
heavy load.............. 208
high speed.............. 290
high water.............. 208
slippery roads............ 206
tips for safe driving.......... 206
towing a trailer............ 211
File:fcixt.ex
Update:Tue Jan 23 08:18:16 1996
ProCarManuals.com