bulb FORD TAURUS 2000 4.G Owners Manual

FORD TAURUS 2000 4.G Owners Manual TAURUS 2000 4.G FORD FORD https://www.carmanualsonline.info/img/11/5372/w960_5372-0.png FORD TAURUS 2000 4.G Owners Manual

Page 8 of 232

FORD TAURUS 2000 4.G Owners Manual WARNING LIGHTS AND CHIMES
Turn signal
Illuminates when the left or right
turn signal or the hazard lights are
turned on. If one or both of the
indicators stay on continuously or
flash faster, check fo

Page 9 of 232

FORD TAURUS 2000 4.G Owners Manual Safety belt
Momentarily illuminates when the
ignition is turned to the ON position
to remind you to fasten your safety
belts. For more information, refer to
theSeating and safety restraints
chapter.
D

Page 10 of 232

FORD TAURUS 2000 4.G Owners Manual 3. The fuel cap may not have been properly installed and securely
tightened.
These temporary malfunctions can be corrected by filling the fuel tank
with high quality fuel of the recommended octane and

Page 189 of 232

FORD TAURUS 2000 4.G Owners Manual permitted to intentionally remove an emission control device or prevent
it from working. Information about your vehicles emission system is on
the Vehicle Emission Control Information Decal located o

Page 190 of 232

FORD TAURUS 2000 4.G Owners Manual ²License plate lamp
Do not remove lamp bulbs unless they will be replaced immediately. If a
bulb is removed for an extended period of time, contaminants may enter
the lamp housings and affect perform

Page 191 of 232

FORD TAURUS 2000 4.G Owners Manual 5. Disconnect the electrical
connector from the bulb by pulling
rearward.
6. Remove the bulb retaining ring by
rotating it counterclockwise.
7. Remove the old bulb from the
lamp assembly by pulling it

Page 192 of 232

FORD TAURUS 2000 4.G Owners Manual 2. Install the bulb retaining ring over the plastic base and lock the ring
by rotating clockwise until it snaps into place.
3. Connect the electrical connector to the bulb.
4. Install the protective d

Page 193 of 232

FORD TAURUS 2000 4.G Owners Manual 5. Carefully pull bulb straight out of
the socket and push in the new
bulb.
6. Install the bulb socket into the
lamp assembly by rotating it
clockwise.
7. Carefully position the headlamp
assembly onto

Page 194 of 232

FORD TAURUS 2000 4.G Owners Manual 1. Remove screw and the license
plate lamp assembly from liftgate.
2. Remove bulb socket by turning
counterclockwise.
3. Carefully pull the bulb out from
the socket and push in the new
bulb.
4. Instal

Page 195 of 232

FORD TAURUS 2000 4.G Owners Manual 4. Remove the bulb socket by
rotating it counterclockwise, then
pulling it out of the lamp assembly.
5. Pull the bulb from the socket and
push in the new bulb.
6. Install the bulb socket into the
lamp
Page:   1-10 11-20 next >