instrument panel FORD WINDSTAR 1996 1.G Owner's Guide

238
*
[DR03500(ALL)09/93]
To return the transaxle to the normal Overdrive operation, press
the OVERDRIVE ON/OFF button again. Use this button to
select Overdrive or Overdrive Off whenever you drive your
vehicle.
*
[DR03700(ALL)02/95]
The transaxle will be in the ªoverdrive onº mode when the
vehicle is started even if the O/D OFF mode was selected when
the vehicle was last shut off.
*
[DR03900(ALL)04/95]
NOTE: If the O/D OFF indicator light is flashing on and off
repeatedly when the vehicle is started, there is a
transaxle electronic system malfunction. Contact your
dealer as soon as possible.
*
[DR04000(ALL)01/93]
When to use 2 (Second)
[DR04100(ALL)03/94]
Use 2 (Second) when driving on slippery roads or to provide
additional engine braking on downgrades. This position
provides Second and First gear operation only.
*
[DR04200(ALL)12/93]
When to use 1 (First)
[DR04300(ALL)05/95]
Use 1 (First) to provide maximum engine braking on steep
downgrades. Upshifts from First can be made by manually
shifting to 2 (Second) orj(Overdrive). 1 (First) gear provides
only first gear operation. If you select First while driving at
higher speeds, the transaxle will shift to 2 (Second), and then
downshift to 1 (First) after the vehicle decelerates to the proper
speed.
*
[DR04400(ALL)06/92]
Parking
*
[DR04500(ALL)01/93]
Always come to a complete stop before you shift into P (Park).
This position locks the transaxle and prevents the front wheels
from turning. To securely latch the gearshift in the P (Park)
position, pull it toward you, push it completely
counterclockwise against the stop, and then push it toward the
instrument panel.
File:wndrs.ex
Update:Tue Mar 19 08:18:48 1996

Servicing Your Windstar
303
*
[SV03700(ALL)02/95]
RWARNING
Do not start your engine with the air cleaner removed
and do not remove it while the engine is running.
%*
[SV03800(ALL)03/95]
To open the hood:
[SV03900(ALL)12/93]1.
Pull the hood release lever located below the instrument
panel to the left of the steering wheel.
[SV04000(ALL)11/93]
13-1/2 pica
art:0050053-B
Hood release lever location
[SV04100(ALL)10/93]2.
Go to the front of the vehicle and release the secondary
hood latch under the hood in the front center of the vehicle.
*
[SV04200(ALL)01/93]3.
Lift the hood and release the prop rod from its retaining
clip. Place the end of the prop rod in the prop rod hole
provided on the underside of the hood.
File:wnsvs.ex
Update:Tue Mar 19 08:16:43 1996

Servicing Your Windstar
337
%*
[SV32300(ALL)01/95]
Adding Automatic Transaxle Fluid
*
[SV32400(ALL)04/95]
The fluid type is stamped on the dipstick. Before adding any
fluid, be sure that the correct type will be used.
*
[SV32500(ALL)05/95]
Add fluid in 1/2 pint (0.25 liter) increments through the filler
tube to bring the level to the correct area on the dipstick. If an
overfill occurs, excess fluid should be removed by a qualified
technician.
%*
[SV32600(ALL)01/93]
NOTE: Always dispose of used automotive fluids in a
responsible manner. Follow your community's
standards for disposing of these types of fluids. Call
your local recycling center to find out about recycling
automotive fluids.
*
[SV32700(ALL)06/94]
NOTE: Always use Motorcraft MERCONHor equivalent
MERCONHautomatic transaxle fluid when you refill
your automatic transaxle fluid.
%*
[SV32800(ALL)02/95]
Brake Fluid
*
[SV32900(ALL)05/90]
Your vehicle is equipped with a brake fluid level indicator in
the master cylinder which lights the BRAKE warning light on
the instrument panel when the brake fluid level is low.
*
[SV33000(ALL)01/93]
Under normal circumstances, your vehicle should not use up
brake fluid rapidly. However, expect the level of the brake fluid
to slowly fall as you put more mileage on your vehicle and the
brake pads wear.
*
[SV33100(ALL)10/89]
Check the brake fluid at least once a year. You can do this by
looking at the fluid level in the plastic reservoir on the master
cylinder. The fluid level should be at or near the MAX mark.
*
[SV33200(ALL)05/95]
RWARNING
Brake fluid is toxic.
File:wnsvs.ex
Update:Tue Mar 19 08:16:43 1996

342
%*
[SV35800(ALL)05/95]
Checking and Replacing Fuses
*
[SV35900(ALL)01/93]
If you need to check a fuse, find the fuse panel for the electrical
system, which is located under the instrument panel, and follow
these steps:
*
[SV36000(ALL)09/93]1.
To remove the fuse panel cover, pull down on the fuse panel
cover handle.
[SV36100(ALL)11/93]
17-1/2 pica
art:0050027-A
Fuse puller tool location Ð fuse panel cover
File:wnsvs.ex
Update:Tue Mar 19 08:16:43 1996

Servicing Your Windstar
343
[SV36200(ALL)10/93]2.
On the fuse panel, find the number of the fuse you want to
check.
[SV36300(ALL)11/93]
17-1/2 pica
art:0050112-B
Main fuse panel under instrument panel
File:wnsvs.ex
Update:Tue Mar 19 08:16:43 1996

350
*
[SV37500(ALL)05/95]
RWARNING
Always disconnect the battery before servicing high
current fuses.
*
[SV37520(ALL)05/95]
Ford recommends that high current fuses be replaced by a
qualified technician.
*
[SV37600(ALL)03/93]
RWARNING
Always replace the cover to the Power Distribution Box
before reconnecting the battery or refilling fluid
reservoirs.
[SV37700(ALL)12/93]
A blown maxi-fuse may be replaced but will continue to blow
until the cause of the overload condition is corrected.
*
[SV37800(ALL)05/95]
RWARNING
Always replace a fuse with one that has the specified
amperage rating. Using a fuse with a higher amperage
rating can cause severe wire damage and could start a
fire.
%*
[SV38400(ALL)10/94]
Relays
% [SV38500(ALL)03/94]
Relays are devices which receive signals from components or
systems. After receiving signals, relays transfer these signals to
activate or deactivate other components or systems. One relay
box is located with the maxi-fuses near the battery and one is
located with the fuse panel under the instrument panel.
File:wnsvs.ex
Update:Tue Mar 19 08:16:43 1996

Servicing Your Windstar
351
[SV38601(ALL)05/95]
17-1/2 pica
art:0050215-D
The relay box cover located under the instrument panel
[SV38700(ALL)02/95]
Lights
*
[SV38800(ALL)01/95]
It is a good idea to check the operation of the following lights
frequently:
*
[SV38900(ALL)01/95]
n
headlamps
*
[SV39000(ALL)01/95]
n
tail lamps
*
[SV39100(ALL)01/95]
n
brakelamps
*
[SV39200(ALL)01/95]
n
hazard flasher
*
[SV39300(ALL)01/95]
n
turn signals
*
[SV39400(ALL)01/95]
n
license plate lamp
*
[SV39450(ALL)02/95]
n
fog lamps
File:wnsvs.ex
Update:Tue Mar 19 08:16:43 1996

352
%*
[SV39500(ALL)01/95]
The alignment of your headlamps should be checked if:
*
[SV39600(ALL)01/95]
n
oncoming motorists frequently signal you to turn off your
vehicle's high beams when you do not have the high beams
on
*
[SV39700(ALL)01/95]
n
the headlamps do not seem to give you enough light to see
clearly at night
*
[SV39800(ALL)01/93]
n
the headlamp beams are not pointed slightly down and to
the right
%*
[SV39900(ALL)03/95]
Replacing the Headlamp Bulb
*
[SV40000(ALL)01/93]
The headlamps on your vehicle use replaceable bulbs. When the
lamp burns out, simply replace the bulb, rather than the whole
lamp.
*
[SV40100(ALL)05/95]
RWARNING
Handle a halogen headlamp bulb carefully and keep out
of children's reach. Grasp the bulb only by its plastic
base and do not touch the glass. The oil from your hand
could cause the bulb to break the next time the
headlamps are operated.
*
[SV40200(ALL)01/93]
Do not remove the burned out bulb unless you can immediately
replace it with a new one. If a bulb is removed for an extended
period of time, contaminants may enter the headlamp and affect
its performance.
*
[SV40300(ALL)03/95]
To remove the headlamp bulb:
*
[SV40400(ALL)01/93]1.
Make sure that the engine is off and the headlamp switch on
the instrument panel is in the OFF position.
[SV40500(ALL)11/93]2.
Lift the hood and locate the headlamp bulb installed in the
rear of the headlamp. Remove the electrical connector from
the bulb by pulling the connector away from the bulb
assembly.
File:wnsvs.ex
Update:Tue Mar 19 08:16:43 1996

375
[QI02500(ALL)04/95]
full page art:0050005-F
Instrument panel
File:wnqis.ex
Update:Tue Mar 19 14:45:17 1996

384
Child safety seats (continued)
automatic locking mode (retractor)........... 39
built-in child seat................... 27
in front seat..................... 39
in rear outboard seat................. 39
tether anchorage hardware............... 50
Chime
headlamps on................... 122
safety belt.................... 69,83
Cleaning your vehicle
built-in child seat................... 37
CD player and discs................. 204
chrome and aluminum parts.............. 6
exterior....................... 5
exterior lamps................... 125
fabric...................... 5,184
headlamps..................... 125
instrument panel.................. 106
instrument panel lens................ 106
interior lamps................... 128
plastic parts..................... 6
polishing....................... 5
rustproofing..................... 6
safety belts...................... 18
tail lamps..................... 125
upholstery and interior trim............. 184
washing....................... 5
wheels...................... 3,335
Climate control system
air conditioning................... 106
heating....................... 106
Clock.....................200, 216, 231
Cold engine starting................... 58
Combination lap and shoulder belts............ 9
Compact disc radio (see Electronic sound system).... 196
Console, description.................. 186
Controls
instrument panel.................. 105
File:wnixs.ex
Update:Tue Mar 19 08:12:49 1996