warning FORD WINDSTAR 1998 1.G Manual PDF

242
[ER03300(ALL)01/96]3.
Use the fuse puller tool to remove the fuse.
[ER03400(ALL)01/96]4.
Check the fuse to see if it is blown. Look through the clear
side of the fuse to see if the metal wire inside is separated. If
it is, the fuse is blown and should be replaced with a fuse of
the correct amperage rating.
*
[ER03500(ALL)01/96]
7-1/2 pica art:0040210-B
Fuse puller tool and fuse
*
[ER03600(ALL)01/96]
RWARNING
Always replace a fuse with one that has the specified
amperage rating. Using a fuse with a higher amperage
rating can cause severe wire damage and could start a
fire.
*
[ER03700(ALL)01/96]5.
Put the fuse panel cover back on.
*
[ER03800(ALL)04/96]
Even after you replace a fuse, it may continue to blow if you do
not find what caused the overload. If the fuse continues to
blow, have your electrical system checked.
File:10wners.ex
Update:Mon Oct 7 11:47:52 1996

246
*
[ER04500(ALL)01/96]
RWARNING
Always disconnect the battery before servicing high
current fuses.
*
[ER04600(ALL)01/96]
Ford recommends that high current fuses be replaced by a
qualified technician.
*
[ER04700(ALL)01/96]
RWARNING
Always replace the cover to the Power Distribution Box
before reconnecting the battery or refilling fluid
reservoirs.
[ER04800(ALL)01/96]
A blown maxi-fuse may be replaced but will continue to blow
until the cause of the overload condition is corrected.
*
[ER04900(ALL)01/96]
RWARNING
Always replace a fuse with one that has the specified
amperage rating. Using a fuse with a higher amperage
rating can cause severe wire damage and could start a
fire.
%*
[ER05000(ALL)05/96]
Relays
% [ER05100(ALL)01/96]
Relays are devices which receive signals from components or
systems. After receiving signals, relays transfer these signals to
activate or deactivate other components or systems. One relay
box is located with the maxi-fuses near the battery and one is
located with the fuse panel under the instrument panel.
File:10wners.ex
Update:Mon Oct 7 11:47:52 1996

248
*
[ER05700(ALL)02/96]
RWARNING
If you use the temporary spare tire continuously or do
not follow these precautions, the tire could fail, causing
you to lose control of the vehicle, possibly injuring
yourself or others.
*
[ER05800(ALL)01/96]
When you drive with the temporary spare tire, DO NOT:
*
[ER05900(ALL)01/96]
n
exceed 50 mph (80 km/h) under any circumstances
*
[ER06000(ALL)01/96]
n
load your vehicle so that it is heavier than the maximum
vehicle load rating listed on the tire decal
*
[ER06100(ALL)01/96]
n
tow a trailer
*
[ER06200(ALL)01/96]
n
use tire chains
*
[ER06300(ALL)01/96]
n
try to repair the temporary spare tire or remove it from its
wheel
*
[ER06400(ALL)01/96]
n
use the wheel for any other type of vehicle
*
[ER06500(ALL)01/96]
n
drive through an automatic car wash. Because the temporary
spare tire is smaller than a conventional tire, it reduces the
ground clearance. Your vehicle may get caught in the rails
and it could be damaged.
[ER06600(ALL)01/96]
Finding the spare tire
[ER06700(ALL)01/96]
The spare tire is stored underneath your vehicle, directly below
the cargo area.
File:10wners.ex
Update:Mon Oct 7 11:47:52 1996

Roadside Emergencies
251
% [ER07700(ALL)04/96]
Changing the Tire
*
[ER07800(ALL)01/96]
You should only raise your vehicle with a jack properly placed
at the front or rear jacking points.
*
[ER07900(ALL)05/96]1.
Make sure that your vehicle will not move or roll and that
the tires and jack are on a level, solid surface. Put the
gearshift lever in P (Park). Set the parking brake and block
the wheel Ð in both directions Ð that is diagonally opposite
the tire that you are changing.
*
[ER08000(ALL)01/96]
RWARNING
When one of the front wheels is off the ground, the
transaxle alone will not prevent the vehicle from moving
or slipping off the jack, even if the vehicle is in P (Park).
*
[ER08100(ALL)01/96]
RWARNING
To prevent the vehicle from moving when you change a
tire, be sure the parking brake is set, then block (in both
directions) the wheel that is diagonally opposite (other
side and end of the vehicle) to the tire being changed.
*
[ER08200(ALL)03/96]
RWARNING
If the vehicle slips off the jack, you or someone else
could be seriously injured.
*
[ER08300(ALL)01/96]
RWARNING
On vehicles equipped with Air Suspension, turn OFF the
Air Suspension switch prior to jacking, hoisting or
towing your vehicle.
File:10wners.ex
Update:Mon Oct 7 11:47:52 1996

258
*
[ER09800(ALL)05/96]
RWARNING
To avoid injury, never run the engine with one wheel off
the ground, such as when changing a tire.
*
[ER09900(ALL)01/96]
RWARNING
To lessen the risk of personal injury, do not put any part
of your body under the vehicle while changing a tire. Do
not start the engine when your vehicle is on the jack.
The jack is only meant for changing the tire.
*
[ER10000(ALL)01/96]
RWARNING
Never raise your vehicle by using a bumper jack. The
bumper could be damaged or the jack could slip and you
could be injured.
[ER10100(ALL)01/96]
NOTE: Never raise your vehicle by placing the jack on the
torsion bar (within axle) or front or rear suspension
components. Serious damage to these components may
occur.
[ER10200(ALL)08/96]6.
Your vehicle may be equipped with one of two types of jack
and handle asemblies. Operation of each type is described as
follows:
[ER10210(ALL)08/96]
a. Separate Lug Nut Wrench and Jack Handle Type.
[ER10220(ALL)08/96]
Insert the jack handle into the jack and slide the tapered end
of the jack handle through the slot in the lug nut wrench.
[ER10230(ALL)08/96]
b. Articulated Hex Handle Type
[ER10240(ALL)08/96]
Remove the handle assembly from the jack retaining bracket.
Swing the hex socket end outward to an approximate right
angle position. Place the hex socket end on the hex nut of
the jack assembly. Turn the handle clockwise to raise the
vehicle off the ground.
File:10wners.ex
Update:Mon Oct 7 11:47:52 1996

Roadside Emergencies
261
*
[ER11700(ALL)01/96]
Stowing the spare tire
[ER11800(ALL)01/96]1.
To raise the tire to the stowed position, lay the tire on the
ground with the interior side facing up. Install the retainer
through the wheel center and slide the tire under the vehicle.
Fit the hex-shaped end of the wheel lug wrench over the hex
nut in the floor of the cargo area. Turn the wheel lug
wrench clockwise until the tire is raised to its original
position underneath the vehicle.
[ER11850(ALL)08/96]
If your vehicle has 16" wheels, lift one end of the tire, route the
cable end through the center of the wheel and install the 16"
wheel retainer.
[ER11900(ALL)01/96]
NOTE: The hex nut ratchets when the tire is raised to the
stowed position. It will not allow you to over-tighten.
*
[ER12000(ALL)01/96]2.
Check for proper seating against the underbody supports
and retighten if necessary.
[ER12100(ALL)01/96]
RWARNING
Check the tire seating position for looseness and make
sure the tire is not too far forward to avoid axle contact.
*
[ER12200(ALL)01/96]
RWARNING
Make sure the spare tire and jacking equipment are
stowed and secured in the proper storage location.
File:10wners.ex
Update:Mon Oct 7 11:47:52 1996

262
%*
[ER12300(ALL)02/96]
Jump-Starting Your Vehicle
*
[ER12400(ALL)01/96]
Your vehicle's battery may discharge if you leave the lights or
any electrical equipment on after you turn the engine off. If this
happens, you may be able to jump-start from a booster battery
to start your vehicle.
*
[ER12500(ALL)02/96]
RWARNING
The gases around the battery can explode if exposed to
flames, sparks, or lit cigarettes. An explosion could result
in injury or vehicle damage.
*
[ER12600(ALL)05/96]
RWARNING
To protect yourself when charging a battery, always
shield your face and eyes. Make sure that you can
breathe fresh air.
%*
[ER12700(ALL)02/96]
RWARNING
Applying too much pressure on the ends when lifting a
battery could cause acid to spill. Lift the battery with a
carrier or with your hands on the opposite corners.
%*
[ER12800(ALL)05/96]
RWARNING
Batteries contain sulfuric acid which burns skin, eyes,
and clothing.
*
[ER12900(ALL)02/96]
If the acid touches someone's skin, eyes, or clothing,
immediately flush the area with water for at least 15 minutes. If
someone swallows the acid, have him or her drink lots of milk
or water first, then Milk of Magnesia, a beaten egg, or vegetable
oil. Call a doctor immediately.
File:10wners.ex
Update:Mon Oct 7 11:47:52 1996

264
% [ER13700(ALL)01/96]
To connect the jumper cables:
[ER13800(ALL)04/96]1.
Connect one end of the first jumper cable to the positive (+)
terminal of the dead battery. (You can connect either jumper
cable to the positive (+) terminal, as long as you use the
same cable for both positive terminals.) Most jumper cables
have a red cable and a black cable. The red cable is generally
used for the positive terminals and the black for the negative
ones.
*
[ER13900(ALL)02/96]2.
Connect the other end of the first cable to the positive (+)
terminal of the booster battery.
[ER14000(ALL)04/96]3.
Connect one end of the second cable to the negative (s)
terminal of the booster battery Ð NOT to the dead battery.
[ER14100(ALL)01/96]4.
Connect the other end of that cable to a good, unpainted
metallic surface in the engine compartment of the vehicle
that needs a jump-start. The following illustration shows
where you can find a metallic surface.
*
[ER14200(ALL)02/96]
RWARNING
Do not connect the end of the second cable to the
negative (s) terminal of the battery to be jumped. A
spark may cause an explosion of the gases that surround
the battery.
File:10wners.ex
Update:Mon Oct 7 11:47:52 1996

270
*
[MC01600(ALL)01/96]
n
Never get under a vehicle while it is supported by a jack
only. If you must work under a vehicle, use safety stands.
*
[MC01700(ALL)01/96]
n
Keep all lit cigarettes and other smoking materials away
from the battery and all fuel-related parts.
[MC01800(ALL)04/96]
Working Under the Hood
[MC01900(ALL)01/96]
Before you open the hood, read this section carefully.
*
[MC02000(ALL)01/96]
If you plan to work under the hood while the engine is
off:
*
[MC02100(ALL)05/96]
RWARNING
Always set the parking brake fully and make sure the
gearshift is latched in P (Park). Turn off the ignition
whenever you leave your vehicle.
*
[MC02200(ALL)01/96]
RWARNING
Always remove the key from the ignition after you turn
off the engine.
*
[MC02300(ALL)01/96]
If you must work under the hood while the engine is
on:
*
[MC02400(ALL)05/96]
RWARNING
Always set the parking brake fully and make sure the
gearshift is latched in P (Park). Turn off the ignition
whenever you leave your vehicle.
[MC02500(ALL)04/96]
RWARNING
Do not wear loose clothing or jewelry that can get caught
in the moving parts.
File:11wnmcs.ex
Update:Tue Oct 8 10:24:50 1996

Maintenance and Care
271
*
[MC02600(ALL)01/96]
RWARNING
Do not start your engine with the air cleaner removed
and do not remove it while the engine is running.
% [MC02700(ALL)04/96]
To open the hood:
[MC02800(ALL)01/96]1.
Pull the hood release lever located below the instrument
panel to the left of the steering wheel.
[MC02900(ALL)09/96]
13-1/2 pica
art:0051021-A
Hood release lever location
[MC03000(ALL)01/96]2.
Go to the front of the vehicle and release the secondary
hood latch under the hood in the front center of the vehicle.
*
[MC03100(ALL)01/96]3.
Lift the hood and release the prop rod from its retaining
clip. Place the end of the prop rod in the prop rod hole
provided on the underside of the hood.
File:11wnmcs.ex
Update:Tue Oct 8 10:24:50 1996