coolant temperature GENESIS G80 2023 Owners Manual

6-59
06
Chain Installation
When installing tire chains, follow the
manufacturer’s instructions and mount
them as tightly possible. Drive slowly
(less than 20 mph (30 km/h)) with
chains installed. If you hear the chains
contacting the body or chassis, stop and
tighten them. If they still make contact,
slow down until the noise stops. Remove
the tire chains as soon as you begin
driving on cleared roads.
When mounting snow chains, park the
vehicle on level ground away from traffic.
Turn on the vehicle Hazard Warning
Flasher and place a triangular emergency
warning device behind the vehicle (if
available). Always place the vehicle in P
(Park), apply the parking brake and turn
off the vehicle before installing snow
chains.
NOTICE
When using AutoSock (fabric snow
chain):

[Wrong size chains or improperly
installed chains can damage your
vehicle’s brake lines, suspension,
body and wheels.

[If you hear noise caused by chains
contacting the body, retighten the
chain to prevent contact with the
vehicle body.

[To prevent body damage, retighten
the chains after driving 0.3~0.6 miles
(0.5~1.0 km).
Winter Precautions
Check battery and cables
Winter temperatures affect battery
performance. Inspect the battery and
cables, as specified in chapter 9. The
battery charging level can be checked by
an authorized retailer of Genesis Branded
products or in a service station.
To prevent locks from freezing
To prevent the locks from being frozen,
spray approved de-icing fluid or glycerin
into key holes. When a lock opening is
already covered with ice, spray approved
de-icing fluid over the ice to remove it.
When an internal part of a lock freezes,
try to thaw it with a heated key. Carefully
use the heated key to avoid an injury.
Use approved window washer anti-
freeze solution in system
To prevent the window washer from
being frozen, add authorized window
washer anti-freeze solution, as specified
on the window washer container.
Window washer anti-freeze solution is
available from an authorized retailer of
Genesis Branded products, and most
vehicle accessory outlets. Do not use
coolant or other types of anti-freeze
solution, to prevent any damage to the
vehicle paint.

9-12
Maintenance
„Standard coolant
ORG3EV091003
„Low conductivity coolant
ORG3EV091002
Check the condition and connections
of all cooling system hoses and
heater hoses. Replace any swollen or
deteriorated hoses.
The coolant level should be filled
between the MAX or F and the MIN
or L marks on the side of the coolant
reservoir when the parts in the motor
compartment is cool.
If the coolant is low, have the vehicle
inspected by an authorized retailer of
Genesis Branded products.
Use only designated coolant for electric
vehicles, adding other types of water or
antifreeze can damage the vehicle.
WARNING
Since specific coolant (Blue color, Low
conductivity) is applied for electric
vehicles, replenishment of other
antifreeze or water may cause problems
to the vehicle.
WARNING
The electric motor for the
cooling fan may continue to
operate or start up when the
vehicle is not running and can
cause serious injury.
Keep hands, clothing and tools
away from the rotating fan
blades of the cooling fan.
The electric motor for the cooling
fan is controlled by vehicle coolant
temperature, refrigerant pressure and
vehicle speed. As the vehicle coolant
temperature decreases, the electric
motor will automatically shut off. This is
a normal condition.
COOLANT

9-13
09
WARNING

[Check the coolant level when
the motor compartment
is cooled. Coolant level is
influenced by temperature,
and if the coolant reservoir
cap is removed when coolant
temperature is high, hot
coolant and steam may blow
out under pressure causing
serious injury.

[Make sure the coolant cap is properly
closed after refilling coolant.
Otherwise the motor could be
overheated while driving.
„Motor compartment front view
ORG3EV091045
1. Check if the coolant cap label is
straight in front.
ORG3EV091043
2. Make sure that the tiny protrusions
inside the coolant cap are securely
interlocked.

9-45
09
Motor compartment fuse panel
Fuse NameFuse Rating Circuit Protected
IG130A IG1 Relay
IG3 130A IG3 Relay
IG230A IG2 Relay
ACC30A ACC Relay
VCU 410A VCU
Module 110A Front Radar, Front Corner Radar LH/RH, Inverter (Front)
Sensor 510A VESS Unit
MDPS 210A MDPS Unit
IEB 410A IEB Unit
Active Hood10A Not Used
IG3 310AElectronic Traction Motor Oil Pump (Rear), Inverter (Rear),
SCU, ICU Junction Block (IPS Control Module), VCU, VCMS
IG3 610AICU Junction Block (ESU), Front A/C Controller, Rear A/C
Controller, Instrument Cluster, A/V & Navigation Head
Unit, Coolant Valve,
A/C Control Module, A/C PTC Heater, Incar Temperature
Sensor, Electronic A/C Compressor, Cooling Fan Motor,
Vehicle Charger Indicator
IG3 710A BMU, Electronic Traction Motor Oil Pump (Front), ICCU
EWP 315A Electronic Water Pump (PEM)
IG3 210A Inverter (Front)
IG3 410ACDM, VESS Unit, Electronic Water Pump (Radiator),
Electronic Water Pump (BSA), Coolant 3Way Valve (BSA)
Washer15A Washer Relay