headrest GENESIS G90 2017 Owner's Manual

2-10
Safety system of your vehicle
Forward and rearward adjust-ment
To move the seat forward or rear-
ward:
1. Push the control switch forward or
rearward.
2. Release the switch once the seat reaches the desired position.
When the seat is adjusted forward or
rearward, the headrest height and
the seatback angle is automatically
adjusted according to the position of
the seat.
Information
The forward/rearward seat adjust-
ment may be restricted, when the seat-
back is leaned back. Adjust your seat,
as follows, before adjusting the seat
position rearward.
- Push and hold the control switch rearward as far as possible, release
the control switch, and re-push the
control switch rearward again.
Then, the seat position is adjusted
rearward, while putting the seat-
back upright.
Seat cushion length adjustment(for driver's seat)
To move the front part of the cushion
forward:
1. Push the front part of the control
switch to move the seat cushion
to the desired length.
2. Release the switch once the seat cushion reaches the desired
length.
To move the front part of the cushion
rearward:
1. Push the rear part of the control switch to move the seat cushion to
the desired length.
2. Release the switch once the seat cushion reaches the desired
length.
Be careful not to damage your
body or clothes when using the
cushion adjustment.
NOTICE
i
OHI036002OHI036003

2-27
02
Pay extreme caution not to dam-
age the connectors, while remov-
ing the head restraint. Damage to
the connectors may cause a tech-
nical problem.
Folding the center head restraint
(if equipped)
To fold the center head restraint :
When the rear-center headrestraint is not used, manually fold
back the rear-center head restraint
while pressing the button (1) on the
side. To use the rear-center head
restraint again, manually pull up
the rear-center head restraint, until
it is securely latched.
You can remove the rear-center head restraint by manually pulling
up the rear-center head restraint,
while pressing the release button.
Information
You can adjust the rear-center head
restraint to the further lower height
by pressing the button (2), which is
located under the rear-center head
restraint, with the armrest folded
back. If the center head restraint is in
the lowest position, raise the head
restraint before folding back the
armrest.
NOTICE
i
NOTICE
OHI036130
When the center head restraint
is not in use, fold the head
restraint back to prevent it from
interfering with your vision
through the rear window.
CAUTION