Cam GENESIS G90 2023 Owners Manual
[x] Cancel search | Manufacturer: GENESIS, Model Year: 2023, Model line: G90, Model: GENESIS G90 2023Pages: 676, PDF Size: 14.16 MB
Page 31 of 676
2-18
Vehicle Information, Consumer Information and Reporting Safety Defects
If you believe that your vehicle has a defect which could cause a crash or
could cause injury or death, you should immediately inform the National
Highway Traffic Safety Administration (NHTSA) in addition to notifying Genesis
Customer Care.
If NHTSA receives similar complaints, it may open an investigation, and if it
finds that a safety defect exists in a group of vehicles, it may order a recall and
remedy campaign. However, NHTSA cannot become involved in individual
problems between you, your dealer, or Genesis Customer Care.
To contact NHTSA, you may call the Vehicle Safety Hotline toll-free at 1-888-
327-4236 (TTY: 1-800-424-9153);
go to http://www.safercar.gov;
download the SaferCar mobile application;
or write to: Administrator, NHTSA.
1200 New Jersey Ave, SE.,
Washington, DC. 20590.
You can also obtain other information about motor vehicle safety from
http://www.safercar.gov.
REPORTING SAFETY DEFECTS
Page 132 of 676
4-22
Instrument Cluster, Armrest touchscreen, Infotainment system
Press START button with key
(if equipped)
This message is displayed if you press
the Engine Start/Stop button while the
warning message “Key not detected” is
displayed.
At this time, the immobilizer indicator
light blinks.
Check BRAKE SWITCH fuse
This message is displayed if the brake
switch fuse is disconnected.
You need to replace the fuse with a new
one before starting the engine.
If that is not possible, you can start the
engine by pressing the Engine Start/
Stop button for 10 seconds in the ACC
position.
Shift to P or N to start engine
This message is displayed if you try to
start the engine in any other position
except P (Park) or N (Neutral).
Information
You can start the engine with the gear
in N (Neutral). But, for your safety, we
recommend that you start the engine with
the gear shifted to P (Park).
Battery discharging due to external
electrical devices (if equipped)
This message is displayed if the 12V
battery voltage is weak due to any
non-factory electrical accessories (ex.
dashboard camera) while parking. Be
careful that the battery is not discharged.
If the message appears after removing
the non-factory electrical accessories,
have the vehicle inspected by an
authorized retailer of Genesis Branded
products.
Check rear wheel steering system
(if equipped)
This message is displayed if the rear
wheel steering system or related
devices is not working properly. Also,
The warning light will illuminate on the
cluster. If the message appares after
engine is restarted, have the vehicle
inspected by an authorized retailer of
Genesis Branded products.
004_RS4_HMA.indd 4-222022-04-06 3:02:32
Page 256 of 676
5-115
05
ORS051272
High Beam Assist will automatically
switch between high beam and low
beam depending on the detected
brightness from the lamps of oncoming
vehicles or vehicles in front.
Detecting sensor
ORS071001L
M: Front view camera
The front view camera is used as a
detecting sensor to detect ambient light
and brightness while driving.
Refer to the picture above for the
detailed location of the detecting sensor.
NOTICE
Always keep the front view camera in
good condition to maintain optimal
performance of High Beam Assist.
) R U P R U H G H W D L O V R Q W K H S U H F D X W L R Q V
of the front view camera, refer to
U ) R U Z D U G & R O O L V L R Q $ Y R L G D Q F H $ V V L V W
) & $ V V H F W L R Q L Q F K D S W H U
High Beam Assist Setting
ORS051241L
With the Engine Start/Stop button in the
2 1 S R V L W L R Q V H O H F W S / L J K W V
Page 353 of 676
6-43
06
Electronically Controlled Suspension
with Road Preview controls the vehicle
suspension automatically using the front
view camera and vehicle sensors to
maximize driving comfort by taking into
account the driving conditions such as
speed, surface of the road, cornering,
stopping requirements and acceleration.
Front view camera
ORS071001L
M: Front view camera
The front view camera is a sensor that
detects the front road. If the windshield
or the front view camera is covered
with snow, rain or foreign matters, the
data collected by the camera is limited
due to the degradation of the camera’s
performance. Always keep the front view
camera clean.
NOTICE
[ NEVER install any accessories or
stickers on the front windshield, or
tint the front windshield.
[ NEVER place any reflective objects
(for example, white paper, mirror)
over the dashboard. Any light
reflection may prevent the system
from functioning properly.
[ Pay extreme caution to keep the
camera dry.
[ Never disassemble the camera
assembly, or apply any impact on the
camera assembly.
Information
Have the system inspected by an
authorized retailer of Genesis Branded
products when:
[ The windshield glass is replaced.
[ The front view camera or cover gets
damaged or replaced.
ELECTRONICALLY CONTROLLED SUSPENSION WITH ROAD
3 5 ( 9 , ( :
Page 354 of 676
6-44
Driving Your Vehicle
System Malfunction
OJWEV061048L
Check Electronic Suspension
When Electronically Controlled
Suspension with Road Preview is not
working properly, this warning message
will appear on the cluster LCD display. If
this occurs, have the system inspected
by an authorized retailer of Genesis
Branded products.
NOTICE
If the battery level is high or low,
Electronically Controlled Suspension
with Road Preview may not work
temporarily to protect the system. If this
occurs, ‘Check Electronic Suspension’
warning message will appear.
Limitations of the System
Electronically Controlled Suspension
with Road Preview always operates
while driving according to the vehicle’s
movement, and the preview function
starts to work when the front view
camera detects road conditions such as
speed bumps. Therefore, the preview
function is limited when there is an
extreme condition that the front view
camera may not work normally. In this
case, the electronic control suspension
function operates without the preview
function in accordance with vehicle
movement.
Page 363 of 676
6-53
06
Calibrating the Battery Sensor
If the AGM battery is reconnected or
replaced, ISG system will not operate
immediately. If you want to use the
system, the battery sensor needs to
be calibrated following the below
procedure.
ORS061023LA : Battery sensor
1. Turn off the engine.
2. Disconnect all electronic devices
that were additionally installed after
the vehicle was delivered, such as
navigation, dashcam, etc.
3. After 4 hours with the engine off, turn
the engine on and off 3 to 4 times.
Information
The ISG system may not operate in the
following situations.
-There is a malfunction with the ISG
system.
-The battery is weak.
-The brake vacuum pressure is low.
If this occurs, have the ISG system
checked by an authorized retailer of
Genesis Branded products.
NOTICE
[ Use only a genuine Genesis ISG
battery for replacement. If not,
the ISG system may not properly
operate.
[ Do not recharge the ISG battery with
a general battery charger. It may
damage or explode the ISG battery.
[ Do not remove the battery cap. The
battery electrolyte, which is harmful
to the human body, may leak out.
Page 366 of 676
6-56
Driving Your Vehicle
Predictive shift feature proactively
upshifts or downshifts the gear based on
the data detected from the navigation,
front radar sensor, and camera.
CAUTION
Predictive shift is a convenience
feature. Regardless of its operation,
the driver must pay attention to
the road condition and abide traffic
laws. The vehicle manufacturer
does not take any responsibility for
traffic law violation and accidents.
Predictive shift Operating
Conditions
Predictive shift operates when it is in
the ready state, and a specific situation
is detected while driving. Details
on prerequisites for activation and
operations are as follows.
[ Prerequisites for activation: Predictive
shift operates when all the following
conditions are met.
-Drive mode is set to SMART
-Gear is positioned in D (Drive)
-Smart cruise control is off
-Engine and transmission operate
normally
-Front radar sensor and related
controllers operate normally
-When driving on a highway
[ Operating condition:
Predictive shift function operates
when one of the following situation is
detected.
-Curve or downhill ahead
-Roundabout ahead
-Entering highway
-Low speed vehicle ahead (Vehicle-
to-vehicle distance is closing in)
Predictive shift off Conditions
The predictive shift function will be
released when the following conditions
are met.
-The detected situation is over
-Drive mode is shifted from SMART to
another mode
-Gear is shifted from D (Drive) to
another gear position
-Paddle shifter is used
-Smart cruise control is on
-Engine or transmission malfunctions
-Front radar sensor or related
controllers malfunction
3 5 ( ' , & 7 , 9 ( 6 + , ) 7
Page 393 of 676
7-4
Driver Assistance System
( Y D V L Y H 6 W H H U L Q J $ V V L V W I X Q F W L R Q
ORS072053N
[ Driver steering assist
Evasive Steering Assist function
helps avoid a collision with a vehicle,
pedestrian or cyclist ahead in the
same lane. When a risk of collision
is detected, Evasive Steering Assist
function will warn the driver and if the
driver steers to avoid collision it will
assist the driver’s steering.
[ Evasive steering assist
Evasive Steering Assist function helps
avoid a collision with a pedestrian or
cyclist ahead in the same lane. When
a risk of collision is detected, Evasive
Steering Assist function will warn the
driver and if there is space to avoid
collision in the lane, it will assist the
driver’s steering.
Detecting sensor
ORS071001
ORS072292
ORS072003N
M: Front view camera,
N: Front radar,
O: Front corner radar,
P: Rear corner radar
Refer to the picture above for the
detailed location of the detecting
sensors.
Page 409 of 676
7-20
Driver Assistance System
Forward Collision-Avoidance Assist
disabled
OJX1079005LOJX1079212L
When the front windshield where the
front view camera is located, front radar
cover, bumper or sensor is covered with
foreign material, such as snow or rain, it
can reduce the detecting performance
and temporarily limit or disable Forward
Collision-Avoidance Assist.
If this occurs the ‘Forward Safety
system(s) disabled. Camera obscured’ or
the ‘Forward Safety system(s) disabled.
Radar blocked’ warning message,
and the
and warning lights will
illuminate on the instrument cluster.
Forward Collision-Avoidance Assist will
operate properly when snow, rain or
foreign material is removed.
If Forward Collision-Avoidance Assist
does not operate properly after
obstruction (snow, rain, or foreign
material) is removed (including trailer,
carrier, etc., from the rear bumper), have
the vehicle inspected by an authorized
retailer of Genesis Branded products.
: $ 5 1 , 1 *
[ ( Y H Q W K R X J K W K H Z D U Q L Q J P H V V D J H R U
warning light does not appear on the
F O X V W H U ) R U Z D U G & R O O L V L R Q $ Y R L G D Q F H
$ V V L V W P D \ Q R W S U R S H U O \ R S H U D W H
[ ) R U Z D U G & R O O L V L R Q $ Y R L G D Q F H $ V V L V W
P D \ Q R W S U R S H U O \ R S H U D W H L Q D Q D U H D
I R U H [ D P S O H R S H Q W H U U D L Q Z K H U H
D Q \ R E M H F W V D U H Q R W G H W H F W H G D I W H U
W X U Q L Q J 2 1 W K H Y H K L F O H
Limitations of Forward Collision-
Avoidance Assist
Forward Collision-Avoidance Assist may
not operate properly, or it may operate
unexpectedly under the following
circumstances:
[ The detecting sensor or the
surroundings are contaminated or
damaged
[ The temperature around the front
view camera is high or low due to
surrounding environment
[ The camera lens is contaminated due
to tinted, filmed or coated windshield,
damaged glass, or sticky foreign
material (sticker, bug, etc.) on the
glass
[ Moisture is not removed or frozen on
the windshield
[ Washer fluid is continuously sprayed,
or the wiper is on
[ Driving in heavy rain or snow, or thick
fog
[ The field of view of the front view
camera is obstructed by sun glare
[ Street light or light from an oncoming
traffic is reflected on the wet road
surface, such as a puddle on the road
[ An object is placed on the dashboard
[ Your vehicle is being towed
Page 411 of 676
7-22
Driver Assistance System
[ You are continuously driving in a circle
[ The vehicle in front has an unusual
shape
[ The vehicle in front is driving uphill or
downhill
[ The pedestrian or cyclist is not
fully detected, for example, if the
pedestrian is leaning over or is not
fully walking upright
[ The pedestrian or cyclist is wearing
clothing or equipment that makes it
difficult to detect
[ Rear wheel steering system (if
equipped) is disabled
ORS071178
The illustration above shows the image
the front view camera and front radar
are capable of detecting as a vehicle,
powered two-wheeler, pedestrian and
cyclist.
[ The pedestrian or cyclist in front is
moving very quickly
[ The pedestrian or cyclist in front is
short or is posing a low posture
[ The pedestrian or cyclist in front has
impaired mobility
[ The pedestrian or cyclist in front is
moving intersected with the driving
direction [ There is a group of pedestrians,
cyclists or a large crowd in front
[ The pedestrian or cyclist is wearing
clothing that easily blends into the
background, making it difficult to
detect
[ The pedestrian or cyclist is difficult to
distinguish from the similarly shaped
structure in the surroundings
[ You are driving by a pedestrian,
cyclist, traffic signs, structures, etc.,
near the intersection
[ Driving in a parking lot
[ Driving through a tollgate,
construction area, unpaved road,
partial paved road, uneven road,
speed bumps, etc.
[ Driving on an incline road, curved
road, etc.
[ Driving through a roadside with trees
or streetlights
[ The adverse road conditions cause
excessive vehicle vibrations while
driving
[ Your vehicle height is low or high
due to heavy loads, abnormal tire
pressure, etc.
[ Driving through a narrow road where
trees or grass are overgrown
[ There is interference by
electromagnetic waves, such as
driving in an area with strong radio
waves or electrical noise